查询词典 requirements

Note Manufacture must comply with the requirements of EURATOM Directives laying down the basic standards for the health protection of the general public and workers against the dangers of ionising radiation, as well as complying with other relevant national requirements.

注：生产必须符合 EURATOM 的要求，EURATOM 规定了公众和生产人员的基本健康保护标准，防止离子放射的危险，同时也要符合其他的相关国家的要求。

2 This cable entry is mating to joint box, meter, and other electrical equipments. The specifications and sizes, basic on the requirements of explosion protection performance, can be designed by the customer. Except of special requirements, they are provided as: NPT, M, G,R threaded connections. The specifications for thread are listed in Table 1

6.2 引入装置是为接线箱、仪表及电气设备等配套使用的，其连接规格及尺寸，在保证电气防爆性能指标外，可以耕具需要由用户设计指定，除有特殊要求外一般提供：NPT、M、G、R等各类螺纹连接形式，螺纹规格见表2。

Translating the requirements of these 'customer' departments into information/action requirements for Kitting action.

将客户部门的要求转化为组件配套行为的信息/行为要求。

Elimination: wind power absorption according to the nature and requirements of the appropriate paper largening; pine paper with according to the position requirements, the paper pile of surface wind around 6 loose paper.

排除方法：可将吸风力依纸张性质及要求适当加大；松纸吹嘴依定位要求，将纸堆表面6张左右纸吹松即可。

Specializing in the production and sale of CNC bending machines die, cutting plate machine blade, a round-cut knife, scissors-roll, mill blades, knives, and other cardboard boxes, addition, the Company may also, according to the different requirements, select the best Design, with the fastest time, the best quality to meet customer requirements.

专业生产和销售数控折弯机模具、剪板机刀片、分切圆刀、滚剪刀片、粉碎机刀片、纸箱刀等，另外，本公司还可以根据客户的不同要求，选择最佳的设计方案，以最快的时间，最好的品质满足客户的要求。

The maximum lifting limit and minimum requirements for the dimension of manholes were the requirements most often mentioned by the designers.

最大起重限额和最低要求的尺寸沙井要求最常提及的设计师。

Because of requirements in mechanical tree planting, such as slope below 25°and being away from lakes or marshlands, there are only a limited number of places which meet the requirements.

由于机械化种树有一些限制，如坡度在25o以下，要不能是湖泊沼泽，所以，真正符合这样条件的生产基地十分有限。

WHO2003 Products to meet norms, ISO4074, EN600, ASTM/D3492, GB7544, SABS and other standard requirements, but also according to customer demand for the production of the special requirements of latex products. 1989 certification through the United States FDA. Det Norske Veritas in 1999 through the ISO19001 + EN46001 quality system certification. The United States in 1999 through FDAS review. In 1999 through the European Community CE certification. South Africa in 1999 through the SABS certification. Det Norske Veritas in 2002 through ISO9001__2000 + ISO13485-1996 quality system certification.

产品可满足WHO2003规范、ISO4074、EN600、ASTM/D3492、GB7544、SABS等标准要求，还可按客户需求生产特殊要求乳胶制品。1989年通过美国FDA认证。1999年通过挪威船级社ISO19001+EN46001质量体系认证。1999年通过美国FDAS复审。1999年通过欧共体CE认证。1999年通过南非SABS认证。2002年通过挪威船级社ISO9001__2000+ISO13485-1996质量体系认证。

Valves open and close speeds generally no strict requirements, but some conditions the speed of the hoist he special requirements, if any, the prompt to open or PRESSURE-REDUCING VALVE EN200X closed, to prevent an accident, and some require slow and shut down to prevent the resulting water hammer, etc.

一般对阀门的启闭速度无严格要求，但有些工况对启闭速度有特殊要求，如有的要求迅速开启或关闭，以防发生事故，有的要求缓慢关闭，以防产生水击等，这在选用阀门类型时应加以考虑。

After analysis, each part of the platform can well satisfy the requirements offast offloading and the requirements of structural strength and stability.

结果证实，在指定的环境条件下，整套系统可满足安装快速性要求，而且也能满足结构强度要求和稳定性要求。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。