查询词典 removing

The process of rust removing by abrasive cleaning,selection and formulation of abradant s,methods of lowering cost are described.

分析了钢管表面处理的方式及其效果；阐述了喷射除锈的工艺、磨料的选用和配比、降低成本的手段。

Abrin is one of the potent toxins isolated from the beans of plant abrus precatorius.the toxic protein consists of two disulfide-bonded subunits,the a and b chains.the b chain is a galactose-specific lectin that facilitates the binding of abrin to the cell membrane that precedes endocytosis.after entering the cells,the a chain catalytically inactivates 60s ribosomal subunits by removing adenine position 4324 of 28s r–rna,and thereby inhibits protein biosynthesis.

相思子毒素是从豆科植物(abrus precatorius l。)种子中分离的一种细胞毒性蛋白。它由a，b两条链组成，由一个二硫键相联，b链具有半乳糖凝集活性，可与细胞膜上受体结合，帮助a链进入细胞内，a链进入细胞催化失活60s核糖体亚基，从而使细胞蛋白合成被抑制。

The results of the experiments show that it can kill the colon bacillus and golden staphylococcus that attach to the seats of the automobile, the mouth of the air-conditioner,the handle of the door,steering wheel,instrument panel,the inside and the floor of the automobile as well as the shoe closet,washroom,cupboard,air-conditioner,sement,etc,in one minute.The rate of removing and killing the bacteria can be as high as 98.5%.It can also remove the sweat smell of the seats,cigarette smell and the smell of leftover effectively,so it has the functions of sterilizing,removing smell and purifying the air in the automobile.The fragrant cvan last a long period of time and you will refresh yourself and feel energetic with it.It is an environmental protecting product and has no side effects.

实验证明：本品可在1分钟内清除附着在汽车座椅、空调口、门把手、方向盘、仪表台、车内壁、底板及家庭鞋柜、洗手间、橱具、家用空调、下水道、地下室等各部位的大肠杆菌、金黄葡萄球菌等，清除率98.5%，还能有效清除汽车座椅上吸附的汗味、烟味、食物碎沫发出的异味，达到杀菌除臭抗菌作用，可净化车内空气，并长期保持防香，提神醒脑，令人精神百倍。

Old naphthalene removing filler is easier jam. But new porous light porcelain structured filler has beyond comparison excellence to wood grille filler. It can enlarge fourfold adsorption surface, greatly promote naphthalene removing effect, increase purification efficiency and insure the quality of civil coke oven gas.

老式脱萘填料比较容易堵塞，新型多孔轻瓷填料有着木格栅填料所无法比拟的优点，能够在相同的重量下扩大四倍的吸附面积，极大的促进了脱萘液的脱萘效果，提高了洗萘塔的净化效率，确保了民用焦炉煤气的质量。

Although forest canopy layer could prevent splash erosion effectively, clay was taken away by overland flow and run off easily, the erosion amount became less after removing the forest canopy and surface soil, while the splash erosion still produced in the surface layer; the splash function weakened after having water current, the starting particles were less than bareland, so removing the surface disturbed soil made the erosion amount and clay less, silty sand more than bareland, but unsteady, the wear and tear energy used by raindrop splash and current function for overcoming sediments separating and starting were comparatively large, sediments were very difficult to be started and transported, it explained that forest root systems could increase anti-erosion capability of forest vegetation, make rainfall-current system splash and export finer particles than bareland.

虽然林冠层能有效防止溅蚀的发生，但坡面流还是能带走粘粒部分，粘粒还是容易流失。去除林冠和表层土后，侵蚀量变得更少，但表层还是会被溅蚀，有水流后，溅蚀作用减弱，颗粒起动的比裸地的少，所以，去除表层扰动土后，侵蚀量更少，粉沙多，粘粒比裸地更少一些，但不稳定，雨滴击溅和水流作用用于克服泥沙分离起动损耗的能量较大，很难被起动输移，这说明森林植被根系的作用增加了林地植被的抗蚀力，使降雨一水流系统仅能溅起输出比裸地坡面更细小的泥沙颗粒。

This routine is a series of moves which must be done smoothly to create illusions of knotting the ring on the rope without letting go of the ends of the rope, removing the ring by apparently visibly penetrating through the knot, then finally removing the knot itself from the rope.

这个流程中的所有动作需要快速且平稳的完成，从而产生圆环被粗棉绳牢系的视觉幻象。接着环将从绳结中逃脱，最后绳结也会从棉绳上脱逃。

This routine is a series of moves which must be done smoothly to create illusions of knotting the ring on the rope without letting go of the ends of the rope, removing the ring by apparently visibly penetrating through the knot, then finally removing the knot itself from the rope.

这个流程中的所有动作需要快速且平稳的完成，从而产生圆环被粗棉绳牢系的视觉幻象。接着环将从绳结中逃脱，最后绳结也会从棉绳上脱逃。周围吹拂着微风，轻抚着我的头发与手指，穿越夜晚边缘的暗影，直到所有星星沉寂。。。

Using the relative reflection as weighting factor, the weighted mean of the surface albedo over Dunhuang Gobi in typical arid region is calculated and its values are 0.255 ± 0.021. After canceling the interference of the buildings, the mean values of the roughness length averaged with logarithm is 0.0019 ± 0.00071 m. After removing the influence of the oasis, the soil wetness factor computed with data under condition of no precipitation is 0.0045. After removing the influence of the precipitation .the mean values of the soil heat capacity over Dunhuang Gobi in typical ac-id region is 112 × 10 ~6 m~(-3)K~(-1), a bit smaller than the values observed i n HEIFE. But the soil heat diffusivity and conductivity are about one of those observed in HEIFE. The soil water content over Dunhuang Gobi in typical synoptic condition is very little and does not exceed 1% basically.

并且利用相对反射为权重加权平均，计算得到典型干旱区敦煌荒漠戈壁的平均反射率为0.255±0.021；剔除建筑物干扰后，利用对数平均法计算的粗糙度长度平均值为0，0019±0.00071 m；剔除绿洲影响后，用无降水影响的资料确定出土壤湿度影响因子为0.0045；剔除降水影响后，用观测资料计算的敦煌典型干旱区荒漠戈壁的热容量平均值为1.12×10~6m~（－3）K~（－1），比&黑河试验&在戈壁和在其它沙漠观测的有关值略小一些，但热扩散率和热传导率都比&黑河试验&在戈壁观测的值小一倍左右；观测的敦煌戈壁典型天气条件下的土壤含水量非常小，基本上不超过1％。

A method for making Bisphenol A with a purity of more than 99.7% by reacting phenol and acetone using an acid catalyst, separating a BPA-phenol adduct by crystallisation and removing phenol from the adduct, in which involves continuous suspension crystallisation with a total dwell time of more than 4 hours in at least 3 crystallisers, by cooling first to 50-70 C in two parallel crystallisers and then to 40-50 C in a third crystalliser connected in series with the first two.; A method for the production of Bisphenol A with a purity of more than 99.7%, by reacting phenol with acetone in presence of an acid catalyst, separating a BPA-phenol adduct from the product mixture by crystallisation, filtration and washing, and removing the phenol from the adduct, in which stage involves continuous suspension crystallisation in at least three crystallisers connected in such a way that the mixture is first cooled to 50-70 C in two crystallisers in parallel and then cooled to 40-50 C in a third crystalliser in series with the first two, the total residence time of the mixture over all crystallisers being more than 4 hours.

描述用于生产纯度大于99.7％的双酚例如，双酚A(BPA的方法，这种方法包含苯酚和丙酮在有酸性催化剂参与的情况下反应形成一个包含双酚的产物混合物；通过结晶、过滤和洗涤从该产物混合物中以双酚/苯酚复合物的形式除去至少一部分双酚以提供双酚A/苯酚复合物晶体；并且从双酚/苯酚复合物晶体中除去至少一部分的苯酚以提供纯度大于99.7％的双酚；其中结晶过程包括连续的混悬液结晶，并且是在至少三个结晶装置中进行的，装置的排列使得产物混合物首先在结晶过程的第一阶段在第一个结晶装置和并联的第二个结晶装置中被冷却到50至70℃的温度，随后在结晶过程的第二阶段在与第一和第二个结晶装置下游串联的第三个结晶装置中被冷却到40至50℃的温度，并且其中产物混合物在结晶过程中的总驻留时间在4小时以上。

A process for making an electronic device which comprises applying a nonaqueous plate-resistant ink by ink jet printing to selected areas of a dielectric substrate, optionally laminated with an electrically conductive metal, exposing the plate resistant ink to actinic and/or particle beam radiation to effect polymerisation, adding one or more metal layers by electrolytic or electroless deposition, the upper layer of which is an etchresistant metal, removing the polymerised plate-resistant ink with alkali and finally removing the electrically conductive metal which are optionally directly laminated to the dielectric substrate and not protected by an upper layer of etch-resistant metal by chemical etching wherein the plate-resistant ink is substantially solvent-free and comprises: A 30 to 90 parts acrylate functional monomers free from acid groups comprising mono- or higher functionality wherein 5 to 95% by weight are mono-functional monomers; B 1 to 30 parts acrylate functional monomer containing one or more acid groups; C 0 to 20 parts polymer or prepolymer; D 0 to 20 parts radical initiator; E 0 to 5 parts colorant; F 0 to 5 parts surfactant; and where the ink has a viscosity of not greater than 30 cPs at 40 DEG C and all parts are by weight.

一种制备电子装置的方法，所述方法包括以下步骤：通过喷墨印刷在任选层压了一种或多种导电金属的介电底材的选定区域涂覆非水的阻沉积油墨，将所述阻沉积油墨暴露在光化辐射和/或微粒束辐射中以完成聚合，通过电解沉积或无电沉积增加一层或多层金属层，其中最上层的金属层为一种或多种阻蚀刻金属，用碱除去聚合的阻沉积油墨，最后通过化学蚀刻将任选直接层压在所述介电底材上并且不被一种或多种阻蚀刻金属的上层保护的导电金属除去，其中所述阻沉积油墨基本不含溶剂，并且包含以下组分：A30-90份不含酸基团的丙烯酸酯功能性单体，所述单体包括单官能或多官能单体，其中5-95％重量为单官能单体；B1-30份包含一个或多个酸基团的丙烯酸酯功能性单体；C0-20份聚合物或预聚物；D0-20份自由基引发剂；E0-5份着色剂；和F0-5份表面活性剂；其中所述油墨的粘度在40℃下不高于30cPs，并且所有的份数以重量计。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷