查询词典 recovery phase

This makes more and more people pay more attention to studies and applications of numerical simulation in thermal recovery. In this research, we have developed a reliable mathematical model for thermal recovery, which takes a full consideration of the effect of viscos, gravitical and capillary forces on the three-phase flow of gas, water and oil, the effect of the temperature on the medium characteristics of liquid and solid, the phase equilibrium of gas-liquid in each component, heat transportation including connection, conduction and radiation as well as heat losses in both the overburn and underlying strata. In the space discreation of the mathematical model, we have proposed a new method based on the improvement of the conventional nine-points difference approximation, which has a higher difference accurancy.

本项研究以热力采油的主要机理为基础，充分考虑在粘性力、重力和毛管力作用下油水气三相流动，考虑温度对各种流体和固体介质物性的影响，考虑每一组分中汽液两相的相平衡，考虑热在地层中的传导、对流和辐射以及上下盖层的热损失，利用热力学第一定律、质量守恒定律和流体迁移定律，建立了正确可靠的注蒸汽数学模型；在对数学模型进行空间离散时，利用控制有限体积积分法，对以往的九点差分近似作了合理的改进，使其具有较高的差分近似精度：结果表明，该公式的近似精度要比以往文献中所给的九点差分近似精度高，可以认为，在油藏数值模拟中，如果遇到非均质情况，使用这种九点差分近似更合理。

The conclusions were as follows: theνO-H andνC=O IR absorption maxima shifted towards higher wave numbers after imprinting 17β-estradiol on TFMAA-co-TRIM copolymer with the red shift of theνO-H groups being apparent after precipitation polymerization for 16h while that forνC=O groups being observed after polymerization for 24h. A strong interaction between TFMAA and 17β-estradiol was confirmed by the high selectivity for 17β-estradiol, as indicted by the values of the separation factor of isomers of 17β-estradiol/17α-estradiol (2.28) and the imprinted factor (3.01). Particle diameter of TFMAA-co-TRIM polymer was between 300 nm and 1.5μm, which suited well for solid phase sorbent throughout at low column pressure. The recognition of imprinting TFMAA-co-TRIM polymer for sterol molecules was driven by enthalpy eluted with acetronitile, and low temperature was in favor of the separation of sterol structure analogues on imprinting column. TFMAA-co-TRIM polymer possessed of determinate anti-heat stability, with melting point beginning at 255.84℃, Tp=257.40℃, control TFMAA-co-TRIM polymer and imprinting TFMAA-co-TRIM polymer were respectively decompounded at 267.79℃and 343.11℃, and solid micro-extraction noddle prepared by the special polymerization also showed definite recognition for 17β-estradiol by GC/MS detecting at 270℃. By selection of various washing and elution solvents, elution reagents of close polymerization system were of more advantage in template molecules retention and recognition on molecularly imprinted solid phase extraction column. At a certain extent, progesterone, 17α-estradiol, 17β-estradiol and 4-androstene-3, 17-dione could be intercepted on the MISPE column. Especially, MISPE had high selectivity for progesterone, and imprinting TFMAA-co-TRIM polymer could achieve adsorption balance within 50 min by absorption kinetics test for 17β-estradiol. However, MISPE column showed better selectivity and enrichment property for 17β-estradiol than C18 and CSPE columns according to the data from HPLC and GC/MS analyses. Recovery of 17β-estradiol on MISPE column was up to 85.5% while when prime extracting solution of milk powder was sampled, the recovery of CSPE and C18 columns were 43.7% and 30.7%, respectively.

通过研究阐明：紫外聚合产物TFMAA-co-TRIM中的νO-H振动吸收峰在聚合16h后红移，νC=O振动吸收峰在聚合24h后红移；TFMAA-co-TRIM对雌二醇异构体的印迹因子达到了3.01，α为2.28，优于其它功能单体参与得到的聚合物识别特性；TFMAA-co-TRIM聚合物粒径介于300 nm至1.5μm之间，作为色谱固定相具有良好的通量和低的柱压；在乙腈流动相中，TFMAA-co-TRIM分子印迹固定相的分离过程主要被焓驱动，低温有利于分子印迹固定相分离甾醇结构类似物；TFMAA-co-TRIM分子印迹聚合物在255.84℃时开始熔融，Tp=257.40℃，聚合物CP的降解温度在267.79℃，MIP降解温度在343.11℃，制备的固相微萃取头初步经GC/MS 270℃的耐热性测定；不同的洗提溶剂筛选证明了选择接近聚合溶剂的洗脱体系更有利于MISPE发挥识别效应；分子印迹固相萃取柱对孕酮、17α-雌二醇、17β-雌二醇和雄烯二酮都具有不同程度的保留特性，可作为此类化合物的吸附材料，特别对孕酮强保留的富集特性，可作为孕酮的选择性识别吸附剂，其分子印迹聚合物对17β-雌二醇的吸附动力学测定显示在50 min内基本达到吸附平衡，具有作为传感器核心敏感材料的潜力；对比萃取奶粉中17β-雌二醇性能，MISPE柱比非分子印迹固相萃取柱和C18柱具有更高的保留，回收率依次为85.5%，43.7%和30.7%。

The recoveries for 2,3-BD and acetoin were 91%and 92%,respectively.Aqueous two-phase extraction of 2,3-BD from real fermentation broth,the removal ratio of cells was above 99%,and the soluble proteins were about 85%in the top phase,which resulted in easy recovery of 2,3-BD from the top phase by vaporization because a viscous slurry was not formed by glucose,cells and soluble proteins at high temperature as in traditional separation methods.In addition,the cells recovered from the fermentation broth could be used as inoculum for further fermentation.

结果表明，目标产物2，3-丁二醇和乙偶姻主要富集在上相中，而葡萄糖主要富集在下相中；当异丙醇和硫酸铵的质量浓度分别是34%和20%时，2，3-丁二醇和乙偶姻的分配系数分别为8.29和8.98，回收率分别达到91%和92%；采用该条件对发酵液直接进行萃取，细胞的去除率在99%以上，可溶性蛋白去除率可达85%。

Frequency offset, convergence time, phase noise and hardware cost are the most important factors for algorithm selecting. First, the carrier recovery loop is divided into two parts, frequency recovery loop and phase recovery loop.

由于载波恢复需要捕获较大的频偏范围、较短的收敛时间、较小的相位噪声和较低的硬件实现成本，所以本文从这四个方面考虑算法的选择。

A 2D two phase horizontal fracture model was established when studying hydraulic fractures for the requirement of shallow reservoir stimulation in this block; and a 3D two phase model has been built for numerical simulation of a reservoir with five-spot pattern without considering vertical fracture flow. The impacts of horizontal fracture half length and flow conductivity on recovery factor and ultimate recovery factor are studied for some certain injection and production conditions. The parameters of hydraulic fracturing are optimized.

根据该区块浅层油层改造的实际需要，研究水力裂缝时建立两维两相的水平裂缝模型，不考虑裂缝垂直方向上流动，建立了五点井网条件下三维两相油藏数值模拟模型，研究了水平裂缝半长和导流能力对油井产量、注采条件下的采收率和最终采收率等指标的影响，优化了水平裂缝参数。

Preliminary market with favorable market conditions or expected to be the catalyst, these factors include: the market and boost confidence in the positive effect of the proliferation of four-quarter economic growth and corporate earnings recovery phase, further loosening of macro-policy expectations, and so on.

初步市场有利的市场条件或有望成为催化剂，这些因素包括：市场和促进在四个扩散的积极作用的信心季度的经济增长和企业盈利的复苏阶段，进一步放松宏观调控政策的预期，等等。

The main products of our company is ZP Standard Recovery Diode、ZK Fast Recovery Diode、KP Phase Control Thyristor、KS Triac Thyristor、KK Fast Thyristor、KG High Frequency Thyristor、 Bridge Rectifier、 Power Modules、Schottky Module、SF Super Fast Recovery Diode Module 、Welding Machine Module、 Solid State Relay、 Solid State Voltage Regulator、Heat Sink Material and so on .

企业主要生产：ZP型普通整流管、ZK型快速整流管、KP型普通晶闸管、KS型双向晶闸管、KK型快速晶闸管、KG型高频晶闸管、桥式整流器、电力模块、肖特基模块、SF超快恢复二极管、电焊机专用模块、固态继电器、固态调压器、型材散热器等电力半导体器件。

Power factor correction; reverse recovery; phase splitting

中文叙词：功率因数校正；反向恢复；分相

Keyword: power factor correction; reverse recovery; phase splitting

叙词：功率因数校正；反向恢复；分相

Power factor correction reverse recovery phase splitting

功率因数校正；反向恢复；分相

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。