查询词典 rear end

Products factory operators; Steyr, Steyr Wang, Hao Wo main bridge shell rear axle, bearing blocks, cross the bridge cover, Steyr wheel shell, shift cylinder, rear axle sudden yuan, ZF Clutch fork shaft, swing rod, before and after the brake hub, Steyr various separation fork, gear room covered ,67-68 pulley, bridge sudden yuan, steel plate, parallel to shell axis, double-H shift shaft , 0503 Steyr-axis between the shell bad, bad Steyr 0198 Inter-axis shell, oil seal and seat, steel plate before and after the hanging ears, rear wheel, shift box assembly, double H shift rocker, one, two block I. block F99588, shift box casing, drive shaft telescopic forks, steel slide, shift cylinder, a variety of connecting plates, gearbox sudden yuan, three, blockIntroduction F99589, Steyr cylinder cover, double-H shift dial head, adjust the lever fork, wheel cover, FL clutch fork, FL Clutch fork shaft, Steyr after the output shaft bearing support, flywheel shell, fork and seat connection, Steyr Cylinder Head,ácover ,67-68 water pipe joints, rear brake camshaft bracket, rear axle minus the main shell, minus the shell of the main bridge, bearing seat, adjust the lever forks, brackets, brake lane joystick arm, gearbox sudden yuan, clutch pedal arm, oil block at the end of care, single head, double-headed rocker, gear room covered, decelerationround, adjust the lever forks, shift box casing, double H shift dial head, Double H shell, gear room covered, separation lever plate before and after the hanging ears, double-H shift shaft, decelerationround,áBushing, Steyr 10 file clutch shell, the bridge box, minus the shell after the main bridge , Bearing Block, the bridge cover, Steyr wheel shell, shift cylinder, after the sudden the bridge element, ZF Clutch fork shaft, swing rod, steel slide, shift box casing series products .

本厂经营产品；斯太尔，斯太尔王，豪沃后桥主桥壳，轴承座，过桥箱盖，斯太尔轮边壳，换挡汽缸，后桥突元，ZF离合器拨叉轴，摆杆，前后制动毂，斯太尔各种分离拨叉，齿轮室盖，67-68皮带轮，中桥突元，钢板垫板，平行轴壳，双H换挡轴，斯太尔0503轴间差壳，斯太尔0198轴间差壳，油封及座，钢板前后吊耳，后轮毂，换挡盒总成，双H换挡摇臂，一，二挡导块F99588，换挡盒套管，传动轴伸缩叉，钢板滑座，换档汽缸，各种连接盘，变速箱突元，三，四挡导块F99589，斯太尔汽缸盖，双H换挡拨头，杠杆调整叉，轮边盖板，FL离合器拨叉，FL离合器拨叉轴，斯太尔输出轴后轴承座，飞轮壳，连接叉及座，斯太尔汽缸盖（欧II，平衡轴盖板，67-68水管接头，后制动凸轮轴支架，后桥主减壳，中桥主减壳，轴承座，杠杆调整叉，托架，行车制动操纵杆臂，变速箱突元，离合器踏板臂，油底托块，单头，双头摇臂，齿轮室盖，减速轮垫片，杠杆调整叉，换挡盒套管，双H换挡拨头，双H壳体，齿轮室盖，分离杠杆，钢板前后吊耳，双H换挡轴，减速轮垫片，平衡轴衬套，斯太尔10档离合器壳，过桥箱，后桥主减壳，轴承座，过桥箱盖，斯太尔轮边壳，换挡汽缸，后桥突元，ZF离合器拨叉轴，摆杆，钢板滑座，换挡盒套管等系列产品。

The sleeve, which is a sliding fit in the cavity insert and on the core pin, is fitted at its rear end to the ejector assembly.

这个顶管装在顶料组合的后端，和型腔镶块以及型芯滑配。

The sleeve, which is a sliding fit in the cavity insert and on the core pin, is fitted at its rear end to the ejector assembly.

顶管装配在镶拼组合式型腔或小型芯上滑动，末端固定在顶出固定板上。

The interplay of concave and convex lines contours the side-on view of the rear end.

在凹凸轮廓线的相互作用的副作用对尾部看法。

The core motifs were the circle and the curves of the roof line, front and rear end.

核心主题是循环的车顶线，前后结束曲线。

In a high speed corner, you can usually make the rear end start to slide by turning one way under power, lifting off, and then quickly turn the other way, so you are making a 'feint' the opposite way before you go round the corner.

在一个高速转角时，你一般可以使一边失去动力，使这边升高，然后迅速转向另一边，来使后轮率先滑移，其实在你过弯前做了一个'假'的相对路线。

It has a rather bulbous, rounded head and short "rear-end" and neck, often looking "plump" and "squat".

大黑脊鸥具有灯泡状、圆形的头部，尾部及颈部较短，外形呈圆胖或矮胖。

The Audi R8 sits wide and low on the road, with its strongly accentuated rear end appearing to flex its muscles like a sprinter ready to leave the starting block.

奥迪R8坐在宽而低的道路上，其强烈的突出尾部出现展示其如短跑准备离开开始块肌肉。

This paper introduces the fundamental principle of semiconductor laser and its high-reflective coating which is deposited on the rear end face of resonant cavity.

中文摘要：本文简单介绍激光的基本原理，着重说明了激光器光学谐振腔上的高反射膜的作用。

Two circular vents highlight the side of the car with a ducktail spoiler topping the C8 Aileron's aggressive rear-end.

两个圆形通风口强调一方的汽车与ducktail扰流突破将其命名为C8副翼的侵略尾部。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。