查询词典 reactive circuit

Based on the research results of Chaos theory, in this dissertation, it has made detailed analysis of the chaotic signal generator. Firstly, the characteristic and various detection methods of chaotic signal are recommended. Secondly, with the aid of software, such as MATLAB, PSPICE, EWB, etc, discussion of the process of generating chaotic signal proceeds. Through simulation, the output result of several kinds of chaotic circuit are analyzed and compared. Thirdly, aiming at Chuas chaotic circuit, through debugging, the impacts by components and parts in the circuit, such as operation amplifier, capacity, inductor, etc, has been further investigated. And then provides a new scheme to implement Lorenz chaotic system, the circuit design and analysis are presented in detail and it can be realized by the hardware of programmable arrays FPGA, the experimental results indicate that this scheme has the advantages of easy operation, flexible design and high efficiency. An application example in secure communications is also provided. Finally, through picking up the characteristic parameter-Lyapunov exponent of the Chaos we can analyze the performance of different chaotic signal generators.

本文在混沌理论研究成果的基础上，对混沌信号的产生做了详细的分析，涵盖以下内容：首先介绍了混沌的定义，混沌信号的基本特性和各种判别方法，特别是对简单的一维Logistic映射的硬件实现问题做了初步探索；其次对混沌信号的产生方法进行讨论，借助于MATLAB、PSPICE、EWB等仿真软件，对几种混沌电路输出的混沌信号进行了分析比较，并在此基础上针对典型三阶连续自治系统Chua's电路作进一步实验研究，通过混沌电路调试，深入研究电路中各元器件，特别是运算放大器、电容、电感等对混沌信号时域以及频谱的影响；再次研究连续混沌系统的数字化硬件产生，设计了Lorenz混沌电路在现场可编程门阵列FPGA上实现的新方案，在保密通信中的应用实验结果表明该方案具有操作简单、设计灵活、效率高等优点；最后针对不同混沌系统，采取不同算法，提取混沌特性参数Lyapunov指数，进而对不同的混沌信号发生器的性能进行了分析。

Later, it makes some comparison with four kinds of modulation technique, and finally, it implements the three-level PWM switching power amplifier with the PWM technique. The power of the amplifier is 2kVA, and the frequency bandwidth is 10～3kHz. In the thesis, the author designs and makes the hardwares of the switching power amplifier. The hardwares contain power inverter rank circuit, control system circuit based on DSP, drive and isolation circuit, and protective circuit. The thesis also analyses the potential safety problems and put forward some solutions for the problems. Furthermore, the thesis accomplishes the software design of the control system, and successfully debugs it. The methods of designing higher power ampilfier are also discussed in the thesis. It analyses the feasibility of the methods, outlines the way of how to design higher power switching power amplifier, and does some experiments with the method of switches-parallelling.

根据电动振动试验系统对开关功放的要求，提出了以电感电流瞬时值控制技术为基础的三电平脉宽调制开关功放的设计方案，并通过系统仿真进行了原理性论证；然后设计并制作了开关功放的硬件，包括功率转换电路，基于DSP的控制电路，驱动、隔离电路以及保护电路；针对开关功放数学模型不易得出的特点，细致分析了模糊自适应PID控制方法，在此基础上编写了控制程序；研制出一台功率为2kVA，通频带为10～3kHz的三电平脉宽调制开关功放；论文中还探讨了实现大功率开关功放的方法，分析了各种方法的可行性，给出了实现大功率开关功放的思路，并进行了并联开关管实现大功率开关功放的实验。

The fluorescent lamp ballast circuit used MSC60028 with higher power factor is developed,and the system consists of control circuit,boost circuit and contravariant circuit.

开发了一种采用MS C60028 集成功率因数校正芯片构成的高功率因数日光灯镇流器，整个系统由控制电路、升压电路、逆变电路三部分组成。

And the main circuit chart used microsoft office visio to draw up, has realized the filter circuit, the leveling circuit, the contravariant electric circuit's composition design.

其中主电路图使用了microsoft office visio来绘制，实现了滤波电路、整流电路、逆变电路的组成设计。关键字：单片机 V/F控制 HEF4752

The contravariant welding machine main circuit system by the input filter leveling circuit, the contravariant electric circuit, the high-frequency transformer, the output rectification filter circuit is composed.

主电路系统由输入滤波整流电路、逆变电路、高频变压器、输出整流滤波电路组成。

Then, on the basis of the functional verification, the system architectures of the radio frequency analog front end and the control logic circuit for the passive UHF RFID transponder are studied and designed with low-power design techniques. The RF AFE circuit includes rectifier, matching network, backscatter, regulator, AM demodulator, voltage reference, local oscillator and power on reset circuit, and so on. The control logic circuit contains clock synchronization module, decoding module, coding module, cyclic redundancy checksum module, power management unit, control unit, shift register and memory.

然后，在功能验证的基础上，重点研究了无源超高频射频识别标签芯片射频模拟前端电路和控制逻辑电路的系统架构，并采用低功耗设计技术对其进行了设计，射频模拟前端电路设计包括了整流器、匹配网络、反向散射电路、稳压器、AM解调器、电压参考源、本地振荡器以及上电复位电路等，控制逻辑电路设计包括了时钟同步模块、解码模块、编码模块、CRC校验模块、功率管理单元、控制单元、移位寄存器和存储器等。

All parts of the circuit were analyzed in detail, the parameters of some circuit were calculated, the control-circuit of bird dispeller at airport was simulated by the software of Multisim to verify the feasibility of the circuit.

本设计对机场鸟类驱赶器的各个电路进行了详尽的分析，对部分电路的参数进行了计算，并通过Multisim软件对机场鸟类驱赶器的控制电路进行了仿真，以验证电路的可行性。

The thesis focuses on the circuit design and parameter selection, including the power circuit, control circuit and drive circuit of the front-end converter. Apart from that, for the load-end converter, the design and critical components selection of the traditional full-wave rectification and synchronous rectification are presented.

本文设计和确定电路的各种参数，包括前端变换器的功率电路、控制电路和驱动电路，对于负载变换器则给出了普通全波整流和同步整流的滤波器设计和一些关键器件的选择。

As for the computer engineering design chain, the human-computer dialogue has been with the console layer design, hardware and software interlock circuit design, the implementation of circuit design, other design is what we need to complete the work For example, if the interface circuit, inter-market linkages as well as the code of the circuit, such as the outdoor part of the design of hardware circuits and wiring.

而对于计算机联锁工程设计来说，人机对话层已经含控制台设计、联锁电路软硬件的设计、执行电路的设计，其它的设计才是我们需要完成的工作，例如如接口电路、场间联系、电码化电路以及室外部分等硬件电路和配线设计。

This course will cover: fundamental electrical circuit quantities, and circuit elements; circuits laws (Ohm law and Kirchhoff voltage and current laws); series and parallel connections of circuit elements; operational amplifiers; network theorems; nodal and mesh analysis methods; analysis of natural, step response, and response to sinusoidal input of first and second order circuits; phasor analysis; introduction to computer emulation to electrical circuit.

中文简介：本课程将覆盖以下内容：电子电路的基本原理，电路元件，基本电路定律(欧姆定律，基尔霍夫电压定律和基尔霍夫电流定律)；电子元器件的的串连和并联；运算放大器；网络理论；节点分析法和网孔分析法；一阶电路和二阶电路的普通信号，阶跃信号及单音信号的响应特性的分析；矢量分析法；并介绍计算机电路仿真的相关知识。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。