查询词典 reaction

The reaction mechanism between nickel ion and butynediols in the electroless plating process was analyzed. The results show that the change of BOZ concentration is a quasi first-order reaction, the change of the nickel ion concentration is related to the BOZ density, and this change belongs to a higher order reaction. The reaction rate equation was determined as dC/dt=-8.585×10^(-4)+1.188×10^(-4)t-4.64×10^(-6)t^2+5.8×10^(-8)t^3-2.3×10^(-11)t^4. The activation energy of this process decreases as temperature increases, and it decreases with the BOZ concentration as 64-423 mg/L, it increases with the BOZ concentration as 123~240 mg/L. The S value is positively correlated to temperature, when the temperature is 80℃, the reaction rate and S value are the largest; while when the temperature is above 80℃ and BOZ concentration is over 160 mg/L, S value and the reaction rate decrease gradually.

结果表明，镀液中BOZ浓度的变化是准一级反应，镍离子的浓度变化与BOZ的浓度有关，属多级反应，其反应速率方程为dC/dt=-8.585×10^(-4)+1.188×10^(-4)t-4.64×10^(-6)t^2+5.8×10^(-8)t^3-2.3×10^(-11)t^4，反应体系的活化能E随温度的升高而减少，随BOZ浓度的变化而变化：当BOZ浓度在64~123mg/L时，E线性减少；在123~240mg/L时E线性增加。S随温度的升高而增加，当温度达到80℃时S值最大，反应速度最大；当温度超过80℃，BOZ浓度大于160mg/L时，蝎的值逐渐减少，反应速度降低。

The whole sintering process of SHS converter fettling materials can be divided into three steps. The first step is the decomposition reaction of carbonates and sodium nitrate, which is an endothermic reaction. The second step is the SHS reaction, i. e. thermite reaction, the metal of Al reacts with CO〓, O〓, NO〓, Fe〓O〓 to form Al〓O〓. The speed of thermite reaction is very quick, and accompanied with large amount of heat emission and temperature rise. The third step is the reaction of spinels formation. The Al〓O〓 produced by SHS reacts with MgO to form spinels.

整个SHS补炉料的烧结过程分三步进行：第一步为碳酸盐、硝酸钠的分解反应，属于吸热反应；第二步为SHS反应即铝热反应，金属铝粉与CO〓、O〓、NO〓、Fe〓O〓等反应生成Al〓O〓，反应速度很快，并伴随有巨大的放热和温度升高；第三步为合成尖晶石的反应，SHS反应产物Al〓O〓与MgO反应生成尖晶石。

The optimum reaction conditions are obtained by orthogonal exptl. design; ring-opening reaction:n:n = 1:1.3, Hexamethylenetetramine catalyst 0.7%,reaction temp. is 80℃, reaction time is 7 h, and concentration of inhibitor is 0.3%. ring-closing reaction : n:n=1:0.9, reaction temp. is 40℃, reaction time is 5 h.

通过正交设计确定了最佳工艺条件为：开环反应：六次甲基四胺用量0.7%(占反应物总量的质量百分比)，阻聚剂用量0.3%(占反应物总量的质量百分比)，ECH：MAA的摩尔比为1.3：1，温度80℃，反应时间7h ；闭环反应：氯醇酯： NaOH的摩尔比为1：0.9，反应温度40℃，反应时间5h。

The main content of this paper as follows: The acidic strength, reaction temperature, reaction time of Chlorine-aluminate Ionic Liquids with different structure of cation on the activity of transalkylation of MN with TeMB and the selectivity of 2,6-DMN were studied. The optimum reaction condition was obtained: the molar fraction of AlCl_3 is 0.71, molar ratio of 2-MN and TeMB is 1, the amount of ionic liquid is 32wt%, reaction temperature is 20℃and reaction time is 8h using X-xAlCl_3 and X-xAlCl_3 as catalysts; the optimum reaction time is shortened 6h using Et_3NHCl-xAlCl_3 as catalyst.

本文主要研究了以下内容：分别考察了不同阳离子结构的氯铝酸盐类离子液体的酸强度、反应温度、反应时间等因素对MN和TeMB转移烷基化的催化反应活性和2，6-DMN选择性的影响，优化得到适宜的反应条件为：以X-xAlCl_3和X-xAlCl_3为催化剂时，AlCl_3的摩尔分数x=0.71，2-MN和TeMB摩尔比为1∶1，离子液体用量为32wt％，反应温度为20℃，反应时间为8h；以Et_3NHCl-xAlCl_3为催化剂时，反应时间缩短到6h。

The four reaction channels including hydroxyl-type benzaldoxime are endothermic reaction, thermodynamically non-spontaneous process, but the other four reaction channels including ion-type benzaldoxime participation are exothermic reaction and thermodynamically spontaneous process. The latter four reaction channels, which have lower reaction barriers, faster reaction velocities and bigger equilibrium constants than those of the former fours, are the chief reaction channels.

苯甲醛肟以羟基型参与反应的4个反应通道均为吸热反应和热力学非自发过程，它们均具有较高的反应势垒、较慢的反应速率和较小的平衡常数；而以离子型参与反应的四个反应通道均为放热反应和热力学自发过程，它们的反应势垒较低，反应速度较快，平衡常数也较大，故苯甲醛肟应主要以离子型参与反应。

The results demonstrated that the fractional conversion and reaction rate were rapidly increased in the initial curing reaction. The higher the curing temperature, the higher the fractional conversion and reaction rate was. With increasing of the curing temperature and time, the fractional conversion and reaction rate decreased and became constantly. The initial curing reaction was a first order reaction. The apparent activation energy and frequency factor of curing reaction used G- capryl ester was bigger than that of used G-oligomer.

结果表明：固化体系在研究的固化温度下，转化率和反应速率在固化反应初期增加快速，温度越高增加越快，随着固化时间的延长，这种变化逐渐变慢，并最终趋于恒定；初期固化反应为一级反应，反应初期的表观活化能和指前因子大小顺序为G-预聚体＞G-辛酯。

The paper reviews the progress of ionic liquids as microwave medium or catalyst in the fields of organic synthesis, mainly including cyclization reation, nucleophilic subsitution reaction, metathesis reaction, acylation reation, rearragement reaction, polymerization reaction, coupling reaction, oxidation and reduction reaction as well as selective debromination reaction etc.

本文综述了以离子液体为反应介质或催化剂的微波辅助技术在多种类型有机反应中的研究成果，主要包括了环合反应、亲核取代反应、金属复分解反应、酰化反应、重排反应、聚合反应、偶联反应、氧化还原反应和选择性脱溴反应等。

With assistance from development partners, Bio·Reaction Industries is working to commercialize this technology for the wood products panel board market and pulp mills.

在发展伙伴的协助下，Bio·Reaction Industries正在致力于在木材产品小组板市场及纸浆造纸厂进行商业化。

Shanghai DITECH Mould Co.,Ltd is focus on RIM process.The Reaction Injection Molding process allows us to meet your low volume, injection molded plastic part needs. our clients including Siemens,ABB,MDS,AMETEK,MARCO,LUWA,Hanon Technologies,Amorsino Electronics,Techcomp,Freesport Corp,Zhongyu Automobile etc .

公司介绍 Company Profile 上海锐纥模具有限公司是专注于RIM（Reaction Injection Molding，反应注射成型）工艺生产的专业化公司，长期为Siemens，ABB，MDS，AMETEK，Planmeca，LUWA，MARCO，海能仪器，艾诺电子，天美仪器，复盛运动用品，中誉汽车等提供中小批量的产品和服务。

In this study, multiple primer polymerase chain reaction , consensus primer PCR and in situ hybridisation with biotin-labelled DNA probe (using domestically-produced agents) were applied and the sensitivity, specificity as well as practical value of each method were compared.

本实验采用了国内外领先的多重聚合酶链反应（polymerase chain reaction，PCR）和共用引物PCR法及国产生物素标记探针原位核酸杂交法，比较和估价了三种方法的灵敏度，特异性和在实际工作中的应用价值。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。