查询词典 reaction rate

Based on both western scholars' study such as Taylor on a monetary policy reaction function and Chinese condition, this article makes a new forwardlooking monetary policy reaction function, in terms of market interest rate, regulated interest rate and interest rate spread.

本文在泰勒等西方学者对货币政策反应函数研究的基础上，构造一个适合我国国情的前瞻性货币政策反应函数，从市场利率、管制利率以及两者利差三个层次，通过该反应函数对我国货币政策的实证检验结果发现，一方面，该反应函数能够很好地描述同业拆借利率、存贷款利率和两者利差的具体走势，能够为我国货币政策的制定提供一个参考尺度，以衡量货币政策的松紧。

At equilibrium,the rate of the metal dissolution is equal to the rate of the cathodic reaction,and the rate of the reaction is directly proportional to the current density by Faradar's law ;therefore:（6）and the Nernst equation can be rewritten(7)where B is a constant and i0 is the exchange current density,which is defined as the anodiccurrent density at the standard electrode potential.

在平衡，金属溶解的率与负极反应的率是相等的，并且反应的率与电流密度直接地是比例由Faradar的法律；因此：(6)和能斯脱等式可以被重写(7) B是常数的地方，并且i0是交换电流密度，被定义作为正极电流密度在标准电极电位。

The optimum reaction conditions are as follows: diphenylmethanethiol : methyl chloroacetate is 1:1.5, and the reaction carried out at 100℃ for 4 h, 2- acetamide can be carried out in the room temperature for 20 h, the yield of 2- acetamide was 76%, hydrogen dioxide: 2- acetamide is 1:1, and the reaction carried out at 60℃ for 3 h, the yield of modafinil was 79%, the total yield of reaction can be reached 48%.

研究表明，采用氯乙酸甲酯作为醚化试剂，反应时间4h，反应温度100℃，二苯甲硫醇：氯乙酸甲酯=1：1.5，室温下氨解反应20h，二苯甲硫乙酰胺收率76%；采用过氧化氢作为氧化试剂，反应时间3h，反应温度60℃，过氧化氢：二苯甲硫乙酰胺=1：l，莫达非尼收率79%，反应总收率可达48%。

This paper mainly introduces experimental methods and basic principle about gelled acid reaction kinetics. Through the reaction kinetics experiment of straight acid and gelled acid, the reaction parameters of acid - rock reaction and kinetic equation in different conditions were achieved.

介绍了胶凝酸反应动力学的试验方法及基本原理，进行了普通酸和胶凝酸与灰岩的反应动力学试验，得到不同条件下的酸岩反应动力学参数及反应动力学方程，对优化碳酸盐岩油藏酸压设计有一定的指导作用。

Acieration Mu hydrogenation the main body of a book has been inspected mainly takes off the nitrogen function, the acieration Mu deoxidation acieration temperature and , deoxidation acieration reaction airspeed, the reaction pressure escaping from nitrogen reaction affects hydrogenation as well as the reaction airspeed azine hydrogenation to acieration Mu catalysator takes off the nitrogen function's.

本文主要考察了碳化钼的加氢脱氮性能，以及碳化钼还原碳化温度，还原碳化反应空速，加氢脱氮反应的反应压力以及反应空速对碳化钼催化剂的吡啶加氢脱氮性能的影响。

In the part of producing TONALIDE, through single-factor-experiments , the highest yield of reaction condition was confirmed as: reaction time about 4 hours; reaction temperature about 20 ; the quantity of chlori-acytyl about 10g; the quantity of aluminum chloride 13-15g and the yield of reaction was as high as 90%.

在TONALIDE的合成部分，通过单因素试验，找到了反应收率最高的反应条件为：反应时间4小时左右；反应温度20℃左右；乙酰氯的用量10g左右；反应中的三氯化铝的用量13～15g，此时反应收率可达90％。

Under the conditions of stir speeds 400 r·min~(-1) and distance between anode and cathode 1 mm, by using the orthogonal design, the optimum technological conditions were found that the current density was 0.3 A·cm~(-2), initial NaOH concentration in catholyte was 50 g·L~(-1), reaction times of two steps were all theoretical electrochemical reaction times. In the first electrosynthesis, initial Na_2CrO_4 concentration in anolyte was 650 g·L~(-1), and reaction temperature was 80℃. In the second electrosynthesis, initial Na_2Cr_2O_7 concentration in anolyte was 700 g·L~(-1), and reaction temperature was 85℃.

324全氟磺酸增强复合阳离子交换膜、阴阳极液中搅拌速度均为400r·min~(-1)条件下，通过正交实验得到优化工艺条件为：电流密度0.3A·cm~(-2)，阴极液氢氧化钠初始浓度50g·L~(-1)，两步反应时间均为理论电催化反应时间，第一步阳极液铬酸钠初始浓度650g·L~(-1)，反应温度80℃，第二步阳极液重铬酸钠初始浓度700g·L~(-1)，反应温度85℃。

1 At a reaction temperature of 100 ℃ and a reaction time of 30 min to give 2,which was then subjected to condensation reaction with p-propoxy mandelic acid in the presence of phosphoric acid at a molar ratio of m(2)∶m( p-propoxy mandelic acid )∶m=1∶1∶1 at a reaction temperature of 60 ℃ for 3 h to yield 3,which was further oxidized by chloranil to give t.

对现有分散红356合成工艺进行了优化，以n∶n=1.2∶1投料，100℃反应30 min得缩合物2，再在等质量磷酸催化下与分批加入的等质量对丙氧基扁桃酸60℃缩合3 h得缩合物3，经温和氧化剂四氯苯醌氧化得标题化合物，总收率55%。

First, a chlorinator was self-designed in this paper, and dichloride of 2-methyl-1-propene was synthesized by 2-methyl-1-propene reacted with chlorine fast in this reactor. By means of the Orthogonal Experiments design and single factor experiments, the influence of several reaction variables on the yield were examined and the optimum reaction conditions under the intervallic operation were obtained, the yield and selectivity of dichloride of 2-methyl-1-prop-ene were more than 65% and 80% respectively. Second, the preparation of 2-methylene-1, 3-propanediol, which dichloride of 2-methyl-1-propene reacted with alkali was investigated. By means of the Orthogonal Experiments design and single factor experiments, the influence of several reaction variables on the yield were examined and the optimum reaction conditions under the intervallic operation were obtained, the conversion of dichloride of 2-methyl-1-propene was 100%. Moreover the preparation of MPO, which 2-methylene-1, 3-propanediol reacted with hydrogen, in presence of Al_2O_3-Pd catalyst, was gotten, and the product was appraised.

本文在氯化反应过程中，自行设计制作出了氯化管式反应器，在该反应器中异丁烯和氯气迅速混合反应生成二氯异丁烯，根据该氯化反应特征利用正交试验和单因素试验考察了有关因素的影响并优化得到了最佳工艺条件，二氯异丁烯的总收率达65％以上，选择性达80％；接着，对二氯异丁烯进行水解反应制得了2-甲烯-1，3-丙二醇，讨论了相关因素对水解反应的影响，并通过正交试验和单因素试验得到了较佳工艺条件，二氯异丁烯的转化率达100％；同时还对制备的2-甲烯-1，3-丙二醇在常压下采用三氧化二铝负载钯催化剂催化加氢得目的产物MPO，并对产品进行了鉴定，从而打通了整个工艺路线。

The effects of various factors on the reaction were studied.It has been found that the optimum reaction conditions are that the amount of catalyst is 13.3% of the amount of cyclohexanol, the reaction time is 80 minutes and the reaction temperature is 200~210℃.

考察了催化剂用量、反应温度、反应时间等因素对脱水反应的影响，得出了其最佳的反应条件：催化剂用量为环己醇质量的13.3%，反应时间80 m in，油浴温度200~210℃。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。