查询词典 rate of flow

Experiments of flow conductivity closure stress of typical propping agent are done, propping agent short-term flow conductivity alteration index is defined, by this, the relation between fissure short-term flow conductivity and closure stress, it is close to exponential relation. 4. Establishing the mathematical simulator of hydraulic fractured well's production in a steady state, finding the relation curve between dimensionless flow conductivity and fracture penetration coefficient by means of calculation and analyses, it is the basis of hydraulic fracture. 5. Expatiating the importance of optimized hydraulic fracturing design in reservoir engineering, advancing the optimizing design method, fracture dimension can be calculated easily when the physical parameters are known. 6. Production rate decline standard curve of vertical fractured wells is achieved by mathematical simulation, when the flow pressure is certain , by asymptotic analyze, this decline curve is close to exponential relation.

完成了国内外典型支撑剂的导流能力闭合应力影响实验，在数据分析中定义了支撑剂短期导流能力变异系数，并由此发现裂缝短期导流能力随闭合应力变化的近似符合指数关系式； 4 建立了一种水力压裂井稳态产能的数学模拟器，计算分析找到了最优无量纲导流能力与裂缝穿透比之间的新型关系曲线，它是水力压裂优化设计的基础； 5 阐述了水力压裂油藏工程优化设计的重要性，提出了优化设计方法，在已知支撑剂物性参数条件下可简洁计算最优裂缝尺寸； 6 数学模拟给出了垂直裂缝井产量递减标准曲线，在井底定压条件下通过渐近分析表明，该递减曲线满足指数关系式。

The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.

结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。

Can be seen, no overload is the essence of the centrifugal pump, pump shaft power curve peak, or shaft power with the increase of flow rate changes are small, relatively flat power curve that axis, so that the pump shaft power in the dead lift off to zero head (that is, from zero flow to maximum flow rate) are less than equal to the original context of the supporting motive power.

可见，无过载离心泵的实质是指，泵的轴功率曲线有峰值或轴功率随流量的增加而有较小的变化，即轴功率曲线比较平坦，使泵的轴功率在关死扬程到零扬程范围内都小于等于原动机的配套功率。

RESULTS A eukaryotic expression system for high expression humanmutantCD59 were successfully set up : The recombinant PALTER-MAX plasmid containing human mutantCD59 cDNA and PCDNA plasmid were co-transfected into CHO cell by cation lipoid mediating method ;and the cells were grown in F12 medium containing 400ug/ml G418 for 14 days, positive clones were grown in RPMI1640 medium to get stable expressing cell lines . Highly expressing clones were selected by flow cytometry ,and were named PALTER-CD59-CHO1PALTER-CD59-CHO2 . Flow cytometry indicated that expression rates of PALTER-CD59-CHO1 and PALTER-CD59-CHO2 were 53.7%and 54.5%. Further more, Stable highly expressing CHO cell lines were more detected by immunocytochemistry and immunofluorescence technology . PALTER-CD59 -CHO1 and PALTER-CD59-CHO2 were grown in RPMI1640 to get a large of cells . CD59 protein were obtained by spalling PALTER- CD59- CHO1 and PALTER - CD59 - CHO2 cells . Stable highly expressing cells were further validated by SDS-PAGE, immunoblot analysis and solid enzyme immunoassay . PALTER - CD59 - CHO1 and PALTER - CD59 - CHO2 were glycated in RPMI1640 of 50mM ribose for 72 hours .BCECF releasing test indicted that the releasing rate of PALTER-CD59-CHO1 or PALTER-CD59-CHO2 was less high than PALTER-CHO ,and the releasing rate of glycated PALTER-CD59 -CHOI or PALTER-CD59-CHO2 was higher than unglycated ones . PALTER -CD59-CHO1 and PALTER -CD59 -CHO2 were glycated in RPMI1640 of 50mM ribose for 72 hours .BCECF releasing test indicted that the releasing rate of PALTER - CD59 - CHOI or PALTER - CD59 - CHO2 was less high than PALTER-CHO ,and the releasing rate of glycated PALTER-CD59-CHO1 or PALTER - CD5 9-CHO2 was higher than unglycated ones .

结果 成功构建突变人CD59的真核细胞表达系统：运用阳离子脂质体介导法将含有突变人CD59的PALTER—MAX重组质粒与PCDNA共转染入CHO细胞：用含有400ug／mlG418的F12培养基培养14天，筛选出稳定阳性表达克隆，RPMI1640培养基扩增获得稳定表达细胞株，并用流式细胞术进一步筛选出高效表达细胞株分别命名为PALTER—CD59—CH01、PALTER—CD59—CH02，表达率分别为53.7％、54.5％；应用免疫组化方法、免疫荧光技术进一步鉴定阳性细胞株；RPMI1640培养基大量扩增PALTER—CD59—CH01、PALTER—CD59—CH02细胞株，裂解细胞得到CD59蛋白质；通过SDS—PAGE凝胶电泳技术、免疫印迹技术、固相酶联免疫吸附试验验证了这两中文摘要个阳性细胞株CO59蛋白的高效表达；50mM核糖培养72小时，获得突变人CD59糖化细胞株，BCECF染料释放试验结果显示，PALTER一CD59一CHOI、pALTER一CD59一CHOZ细胞较PALTER一CHO细胞染料释放率低，未糖化PALTER一CD59一CHOI、PALTER一CD59一CHOZ细胞比较糖化后细胞染料释放率低。

Because the product adapts electronic circuit to control it changes the design of acesodyne infusion pump for single use mechanical pump with silica gel liquid stored vesica as power and with constant limited flow device as control measure of flow rate So it makes that the product does not affect by temperature and viscosity of liquid The flow rate is more accuracy and the usage is more safety .

本产品电子集成电路控制可变注液流量，达到控制最小有效剂量，安全剂量，均匀给药的临床用药目的，该产品设计了多种参数，增加了功能的选择，使流量更加线性和平稳，不仅适合手术后止痛，更适合用于无痛分娩，化疗等临床运用。

Results indicate that the optimum extraction conditions are as follows: ultrasonic power is 600W, temperature is 53℃, the ratio of liquid to solid is 8︰1, ultrasonic treating time is 70min, reflux extraction time is 120min, the extraction rate of oleanolic acid is 3.000 mg/g; XDA-1 resin is favorable in purification of OA in Chaenomeles sinensis Koehne, the optimum purification conditions are found to be 0.794 mg/mL of OA concentration, the flow rate of adsorption is 0.5 mL/min; the desorption solvent is 90% ethanol, and the flow rate of elutant is 1.0 mL/min.

结果表明，超声波辅助提取最佳工艺条件为：超声功率600 W、提取温度53℃、液料比8：1、超声波提取70 min，回流提取120 min，齐墩果酸得率为3.000 mg/g；XDA-1型大孔树脂对齐墩果酸具有较好的吸附和解吸效果，最佳纯化工艺条件为上柱液浓度0.794 mg/mL，吸附流速0.5 mL/min；以90%浓度乙醇洗脱，洗脱流速1.0 mL/min，纯化后得提取物中齐墩果酸纯度可达26.55%。

The results show that the mechanical properties of this PMMA depend strongly on the testing temperature. The Young's modulus and flow stress were found to decrease with increasing temperature at low strain rate. At the strain rate of 10^(-1) 1/s, strain soften was observed under all experiment temperatures. At high strain rate, with the temperature increase, the flow stress deceases remarkably while the failure strain increases, and the strain softening was also observed at the temperature above 333K.

试验结果表明：在准静态载荷下，随着温度的升高，材料的弹性模量和流动应力减小，在应变率为10^(-1) 1/s时表现出明显的应变软化行为；在高应变率(550 1/s)下，随着温度的升高，材料的流动应力逐渐减小而破坏应变增大，当温度超过333K时也有应变软化现象发生；在相同温度下，随着应变率的升高，材料的流动应力增大，但破坏应变减小。

Based on the data from heat water experiments for counter flow and cross flow cooling tower in laboratory with different water flow rate, air flow rate and water falling height, the equivalent diameters of water drop under corresponding conditions are obtained.

在逆流式冷却塔中，水的冷却分三部分：喷头、填料、雨区。但是，在进行填料的模拟试验中，要把上述三部分的热力特性分开，是很困难的。

Based on the data from heat water experiments for counter flow and cross flow cooling tower in laboratory with different water flow rate, air flow rate and water falling height, the equivalent diameters of water drop under corresponding conditions are obtained.

本文首先通过不同淋水高度、淋水密度、过塔风速等的逆流及横流试验塔的热水试验，求出相应条件下的淋水水滴当量直径，再在工业塔的条件下，利用水滴散热公式，计算出雨区散热效果，化为无因次数-冷却数，作出图及计算公式。

Also the multi-scale entropy processing and analysis of conductance fluctuating signals acquired by VMEA sensor for five flow patterns with water as the continuous liquid are conducted. The study result indicates that the increase of f o makes oil in water type slug flow occur at lower U sg; for low flow velocity, the continuous liquid inversion occurs at about f o=0.9 and the increase of U sg makes the inversion point move to low oil volume fraction; the multi-scale entropy detail describes the nonlinear dynamic characteristics of oil-gas-water flow patterns and the rate of MSE at low scales sensitively indicates the variation of flow patterns and can act as the efficient criterion of three-phase flow patterns identification.

对水为连续相的5种流型VMEA传感器波动信号进行了多尺度熵分析，研究结果表明：含油率增加可使水包油段塞流在较低气相表观速度下产生；较低流速下的油水相态逆转可发生在油液比为0.9左右，气相流速增加使得逆转点向含油率低的方向偏移；多尺度熵细节可以刻画油气水三相流非线性动力学特性，而低尺度的多尺度熵变化率敏感地反映流型转变，是划分油气水三相流流型的有效准则。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。