查询词典 rate of flow

The waste combustion in the waste bed and the impacts of the waste burning efficiency are complex. In order to solve this problem, the method of numerical simulation has been adopted to simulate waste combustion, and calculate the mass loss rate, moisture evaporation, volatile release, char burning rate. Used the total flow rate of primary air between 50～1 000 Nm3/min to calculate the mass loss, excess air coefficient of waste bed, components of the gas. Calculated results show that the burning efficiency is higher when the total flow rate of primary air is at 517.47～632.09 Nm3/min .

针对垃圾焚烧炉床层内垃圾燃烧过程复杂性及影响垃圾燃烧效率因素多的问题，运用数值仿真方法对某垃圾焚烧炉床层垃圾燃烧进行了模拟，获得了垃圾质量流失速率、水分蒸发速率、挥发分释放速率、焦炭燃烧速率和烟气的温度；并在50～1 000 Nm3/min范围内改变一次风流量，获得了床层质量流失比值、过剩空气系数和烟气中各组分的质量百分比含量。

In order to overcome the difficulties in measuring the flow rate of oil-water two-phase flow, the measurements of total mass flow rate, respective mass flow rate and real density of oil-water mixture with a double-U Coriolis flow meter were investigated.

针对油水两相流流量的测量难题，采用双U型Coriolis流量计对油水混合物的总质量流量、分相质量流量和真实密度进行了测量研究。

The stratified flow, slug flow and asymmetry annular flow upstream become symmetry annular flow with uniform film thickness after the spin generating element. The liquid extraction ratio is only determined by the diameter and number of the sampling holes and independent of gas and liquid flow rate of the main pipe, and the gas extraction ratio is mainly controlled by the liquid flow rate of the main flow loop.

分析表明，取样流体中的液相质量流量与主流体液相质量流量的比值主要取决于取样孔的数目和大小，而取样流体中的气相质量流量与主流体气相质量流量的比值则与主管路液相流量有关。

The invention discloses a measuring method for firing conclusion and gas flow rate in the process of liquid, gas fuel firing, which comprises the following steps: positing three points on fuel transmission pipe, air pipe and gas pipe, setting regular measuring device or sampling device, measuring the flue's element and flow rate of point 1, air element of point 2, and gas element of point 3, inputting the data of three points into computing unit, computing air flow rate Mair, gas flow rate Mgas and firing conclusionηB by the element of air, flue, and gas and flue flow rate Mburn.

本发明公开了一种液体、气体燃料燃烧过程中燃烧完全度和燃气流量的确定方法，步骤为：在燃料输送管道、空气管道和烟气管道上分别设置三测点，并安装常规的测量装置或取样装置；分别测量测点1的燃料成分和流量；测点2的空气成分；测点3的燃气成分；将三测点的测量数据输入计算单元；根据空气、燃料和燃气的成分以及燃料流量M burn ，计算空气流量M air 、燃气流量M gas 和燃烧完全度η B 。

The results indicate that, in either single or double blowing, larger erosion rate is mainly found in the slag line and near purging plug area of ladle lining; erosion is accelerated when gas flow rate increases; the erosion rate of ladle lining with double blowing is larger than that of single blowing; erosion rate distribution is obviously different as gas flow rate increases; in heavy blowing, serious erosion centers around slag line area and expands gradually outwards; as purging plug gets close to lining wall, malconformation of erosion rate in ladle lining becomes more prominent and the erosion rate of lining near purging plug increases.

结果表明，无论单吹还是复吹，较大的蚀损速率主要分布在钢包渣线及近透气砖区域，吹气量的增大会加速钢包内衬的蚀损。采用复吹时，钢包内衬的蚀损较单吹时更快。随着吹气参数的改变，钢包内衬蚀损速率的分布状况差异明显。大吹气量下，较大的蚀损集中在渣线区域且呈环向扩展；透气砖安装距包壁越近，钢包内衬蚀损不均衡性也越突出，近透气砖内衬蚀损加重。

METHODS: Pulmonary function tests were performed in 20 children with asthmatoid bronchitis (2 months-2.5 years of age) before and 30, 60, and 120 minutes after salbutamo and ipratropium bromide inhalation. The indexes of pulmonary function measured included tidal breathing flow volume loop, percent of tidal volume to peak tidal expiratory flow, terminal flows per peak expiratory flow (25/PF), peak tidal expiratory flow, rate of mid-expiratory to mid-inspiratory flow, respiratory rate and tidal volume per kilogram. RESULTS: Before drug inhalation, the descending branch of the TBFV loop was depressed.

20例2个月至2岁6个月的喘息性支气管炎患儿，在吸入药物沙丁胺醇+溴化异丙托品前、吸入后30，60，120min各行一次潮气流速容量环检查，并进行肺功能各项指标比较，包括潮气呼吸流速容量环的形态，反映小气道功能的敏感指标到达潮气呼气峰流速时的呼气量/潮气量，呼出75%潮气量时的呼气流速/潮气呼气峰流速(25/PF)，潮气呼气峰流速，反映大气道功能的指标潮气呼气中期流速/潮气吸气中期流速，潮气呼吸状态下的通气功能，包括呼吸频率，每公斤体重潮气量。

The test results showed that when the cycle water flow was 65m^3/h and the oxygen flow was 1, 2,……, 10L/min, the relationship between the dissolved oxygen and oxygen flow in the water was y=0.1009χ^2+0.0594χ+5.9588 (r=0.9927). According to the mass balance principle, the maximum oxygen utilization rate of oxygen cone was calculated at 84.56%. Under the condition of the maximum oxygen utilization rate of oxygen cone, according to the rate of Nile tilapia oxygen consumption, the number of oxygen cone was projected in industrialized fish farming system. It provided the basis for oxygen supply system design in industrialized fish farming system.

结果表明，在循环水流量为65 立方公尺/h，水温24.5℃，氧气流量为0， 1， 2，……，10 L/min的条件下，溶氧与氧气流量回归方程为y=0.1009χ^2+0.059 4χ+5.958 8(r=0.9927)；根据物料平衡原理，推算出氧气锥的最大氧气利用率为84.56%；在最大氧气利用率的条件下，依照尼罗罗非鱼的耗氧率计算模式，推算出工厂化养鱼系统需配置氧气锥的台数。

First, we adopt MEMS technology to fabricate micro venturis with different widths of 150 and 200 um respectively and utilize FLUENT software to analyze the flow fields. Air was set as the working fluid and the air mass flow rate of inlet is changed to obtain the pressure drop between inlet and outlet. When a flow passes through the throat, the backflow results in the symmetric separations occur and grow with the increase of mass flow rate.

在微文氏管的研究部分，首先利用微机电制程技术制造出两种不同尺寸的微文氏管，宽度分别为150及200微米，开口角度各为45°，总长则为10 mm，再以空气作为工作流体，利用不同质量流率来量测微文氏管进出口的压力差并配合FLUENT软体分析观察其流场分布的情况。

In doing so, I learned that by opening a small panel door just above the pump panel, you could gain access to the control valve and that removing a small pin from the Rate-of-Flow Control Valves point where the valve handle connected to the motor, you would then be able to operate the valve by hand.

这样做，我知道了打开水泵正上方面板的小面板门，你可以进入控制阀，并剔除了点小针在阀门手柄连接到汽车，你便可以为手工操作阀门。

XRD and EDS analysis indicate that at static condition, the composition of the scale is CO3, while the scale changes to CO3 at dynamic conditions. The increment in flow rate increased the thickness of the scale remarkably, but had little influence on the hardness and Young's modulus of the scale. The fracture toughness of the scale exhibited the lowest value at the flow rate of 0.5 m/s whereas the adhesion strength increased with increasing the flow rate.

结果表明，静态条件下形成的腐蚀产物膜的主要成分为CO3，动态条件下的主要成分为CO3；介质的流动能够促进腐蚀产物膜的形成，但对膜的硬度以及杨氏模量影响不大；腐蚀产物膜的断裂韧性随着流速的增大先下降后上升，流动状态下内层腐蚀产物膜的致密性较好，膜与基体的结合强度较高。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。