查询词典 rate of flow

If flow rate is in excess of that specified, turn indicator towards closed position, noting pressure drop and valve setting and determining new flow rates from flow rate chart .

如果流量超过规定，将指示器旋转到关闭位置，注意压降和阀门设置，并从流量表中确定新的流量。

If flow rate is in excess of that specified, turn indicator knob towards closed position, noting pressure drop and valve setting and determining new flow rates from flow rate chart .

如果流量超过规定，将指示器旋钮旋转到关闭位置，注意压降和阀门设置，并从流量表中确定新的流量。

Because the product adapts electronic circuit to control it changes the design of acesodyne infusion pump for single use mechanical pump with silica gel liquid stored vesica as power and with constant limited flow device as control measure of flow rate So it makes that the product does not affect by temperature and viscosity of liquid The flow rate is more accuracy and the usage is more safety .

本产品电子集成电路控制可变注液流量，达到控制最小有效剂量，安全剂量，均匀给药的临床用药目的，该产品设计了多种参数，增加了功能的选择，使流量更加线性和平稳，不仅适合手术后止痛，更适合用于无痛分娩，化疗等临床运用。

The results obtained from range analysis and variance analysis show that the channel turning angle is the most important factor affecting the flow index, and the flow rate is seriously influenced by the number of channel units, which facilitates settling the problem of increscent flow rate due to the structural optimization.

流量和流态指数的极差和方差分析结果均显示出流道转角对流态指数的影响最显著，而流道单元数对灌水器流量的影响最大，这一结果有助于解决流道经优化后带来的流量增大问题。

For the stability of the flow metering pumps, metering pump flow rate, as some big changes with pressure, you can set the exit of metering pump back-pressure valve, so that the output of metering pump flow rate stability, and then usually selected back-pressure valve The Reducing Valves pressure of the actual use of a metering pump metering pump pressure or slightly less than the use of pressure.

用于稳定计量泵的流量，如某些计量泵的流量随压力变化较大，可在计量泵的出口处设置背压阀，使计量泵的输出流量稳定，这时一般选择背压阀的压力为计量泵的实际使用压力或略小于计量泵的使用压力。

The results indicate that the interface curve in width varies along the flow direction. The flow rate ratio controls the coextrusion interface location. The interface deviate value increases with the increasing of the flow rate ratio. The difference viscosity of two layers polymer leads to the interface deflecting towards the lower viscosity side.

结果表明：宽度方向共挤出界面的形状和位置沿聚合物流动的方向不断变化；界面偏移量的大小随着流量差异的增加而增大；聚合物入口流量的变化是导致共挤出界面位置变化的决定性因素，流量比的变化对出口处界面形状的影响不大；两种聚合物粘度的不同会导致界面偏向粘度较低的熔体一侧。

In this paper experimental and theory research was conducted on flow rate measurement for steam-water two-phase flow using venturi tube method and the flow rate measurement was fulfilled.

本文对采用文丘利管测量汽液两相流体流量的方法进行了实验和理论研究，实现了对汽液两相流体流量的测量。

The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.

结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。

Results indicate that the optimum extraction conditions are as follows: ultrasonic power is 600W, temperature is 53℃, the ratio of liquid to solid is 8︰1, ultrasonic treating time is 70min, reflux extraction time is 120min, the extraction rate of oleanolic acid is 3.000 mg/g; XDA-1 resin is favorable in purification of OA in Chaenomeles sinensis Koehne, the optimum purification conditions are found to be 0.794 mg/mL of OA concentration, the flow rate of adsorption is 0.5 mL/min; the desorption solvent is 90% ethanol, and the flow rate of elutant is 1.0 mL/min.

结果表明，超声波辅助提取最佳工艺条件为：超声功率600 W、提取温度53℃、液料比8：1、超声波提取70 min，回流提取120 min，齐墩果酸得率为3.000 mg/g；XDA-1型大孔树脂对齐墩果酸具有较好的吸附和解吸效果，最佳纯化工艺条件为上柱液浓度0.794 mg/mL，吸附流速0.5 mL/min；以90%浓度乙醇洗脱，洗脱流速1.0 mL/min，纯化后得提取物中齐墩果酸纯度可达26.55%。

Under 100% of natural light, Pinus massoniana had highest values of maximum photosynthetic rate, light saturation point, light compensation point, dark respiration rate, the apparent quantum yield, leaf total electron flow rate and photochemical fluorescence quenching, whereas Cryptocarya concinna exhibited maximum fractions of total electron flow partitioned to photorespiration.

结果表明，在100％光下，马尾松有最高的最大光合速率、光饱和点、光补偿点、暗呼吸、表观量子效率和总电子传递速率，光化学猝灭也最大。

The witness also told the jury at the Royal Courts of Justice in London that he saw a paparazzo fighting with a member of the public who was trying to stop him taking pictures in the minutes before the emergency services arrived.

他还告诉在伦敦皇家法庭的陪审团，在急救服务到来之前，他当时看见一个狗仔队正和一群阻止他拍照的人打架。

The entire N／C program on a tape is made up of an accumulation of these successive data blocks.

纸带上的整个数控程序由这些连续数据单元连接而成。