查询词典 radial field

In chapter 4, the plane-radial and plane-parallel flows for Newtonian fluid in fractal porous media are analyzed. Based on the same assumption as that in chapter 3, the expressions for porosity, flow rate, velocity and permeability for both radial and parallel flows are developed. The proposed expressions are expressed as a function of tortuosity, fractal dimension, maximum and minimum pore diameters, and there are no empirical constant and every parameter has clear physical meaning in the proposed expressions.

第四部分研究了分形多孔介质中牛顿流体的平面径向和平行流动，考虑到实际毛细管的弯曲性和毛细管管径的分形分布，给出了径向和平行流动时的孔隙数目、孔隙率、流量、流速和渗透率的分形表达式；得到了分形多孔介质中微可压缩流体的压力分布方程；得到了无量纲的渗透率、压力和流速的解析表达式。

"So all components are based on latest supersport technologies: upside-down front fork, fully adjustable suspensions, Brembo radial brake pump, radial brake calipers, R1-type swingarm, everything."

&因此，所有的组件都基于最新的超级技术：倒置前叉，完全可调悬架，伦博径向制动泵，径向制动卡钳，受体1型swingarm ，一切。&

It is worth to be noted that the needed driving current to the MR valve with both annular and radial damping gaps is less than that to the MR valve with annular damping gaps under the cut-off state of the MR valves, which show that the MR valve with both annular and radial damping gaps consumes less energy.

测试结果显示：（1）在相同的工作条件下，同时具有圆环和圆盘阻尼间隙的磁流变阀产生的压降更明显；（2）处于截止状态时，同时具有圆环和圆盘阻尼间隙的磁流变阀的激励电流明显小于具有圆环阻尼间隙的磁流变阀的激励电流，因此采用同时具有圆环和圆盘阻尼间隙的磁流变阀可以节约能量的消耗。

The results are:(1) Samples without straight radial grain have more hits and increasing faster than samples with straight radial grain, but before fracture hits count is not much different.

最后得出以下结论：(1)径向纹理不通直的试件比通直的声发射撞击数要多，而且增加的趋势较快，但是在试件断裂前，声发射撞击数相差不大。

To adopt band type rail rolled by stainless steel and chain type drive method run circumferential movement along with the pipe to be cut by flame cutting carriage,cutting torch will run radial movement driven by ball bearing screw by step motor along with the pipe to be cut,the above two dimension movement compose to inclined cutting movement of cutting torch,the inspection of circumference position of cutting torch,the determination of radial position and return point of cutting torch all controlled by SCM.

为了满足钢管斜截切割的要求，建立了钢管斜截切割的数学表达式，采用不锈钢轧制的带形轨道和链式传动的方式使火焰切割小车沿被切钢管做周向运动，割炬沿被切钢管的轴向运动由步进电动机带动滚珠丝杠完成，上述两维运动合成为割炬的斜切运动，割炬周向位置的检测、割炬轴向位置及折返点的确定均由单片机控制完成。

The turbine comprises at least one radial or diagonal turbine stage (120) with radial or diagonal feed stream and axial exhaust flow and at least one axial turbine stage (121 - 125) with a axial feed steam and axial exhaust flow.

该涡轮机包括至少一个带有径向的或者对角线的入口和轴向的出口的径向的或者对角线的涡轮机级(120)和至少一个带有轴向的入口和轴向的出口的轴向涡轮机级(121-125)。

The opening of the valve body in a leading role in the orientation of any reciprocating parts, in the active pieces into fixed at the minimum radial clearance of not less than 0.7mm, valves should be in a spy state, the activities of parts and fixed parts Minimum radial clearance of A42C Type Pound-Grade Low Lift Spring Loaded Safety Valve not less than 0.125mm.

阀体中对阀的开启起主导作用的任何往复运动的导向零件，在活动件进人固定处的最小径向间隙不应小于0.7mm，阀处于伺应状态时，活动件与固定件的最小径向间隙不应小于0.125mm。

The opening of the valve body in a leading role in the orientation of any reciprocating parts in the active pieces into fixed at the minimum radial clearance of not less than 0.7mm valves should be in a spy state the activities of parts and fixed parts Minimum radial clearance ofA42C Type Pound-Grade Low Lift Spring Loaded Safety Valve not less than 0.125mm.

阀体中对阀的开启起主导作用的任何往复运动的导向零件，在活动件进人固定处的最小径向间隙不应小于0.7mm阀处于伺应状态时，活动件与固定件的最小径向间隙不应小于0.125mm。

Loading mechanical model in four directions(radial direction,reverse radial direction and opposite lateral direction)of slipper block are designed for equal rated bearing capability and may satisfy using demands in several different installation postures.

滑块上4个方向（径向、反径向和相对横向）的载荷力学模型是拍案相同额定载荷能力设计，可满足在不同的安装姿态中使用。

Firstly, the related parameters are distributed periodically in the falling film and their periods all equal to that of vacillation of fishing vessel. Secondly, the film tangent and radial velocity components are not zero because of vacillating additional inertia forces and furthermore, in one vacillation period, most parameters are distributed quite regularly in the tangent and radial directions. Thirdly, when other parameters are kept constant, the falling film absorption is enhanced if the amplitude or the period of vacillation is moderately decreased and this result conforms to the theoretical qualitative analysis. Finally, falling film absorption changes with the solution parameters at inlet and system pressure and the change trend is very similar to what happened in the static tube.

首先，降膜内相关参数分布具有周期性且周期等于摇摆振动周期；其次，摇摆附加惯性力使液膜沿吸收管周向和径向流速不为零，而且单位摇摆周期内各参数沿周向和管长方向分布比较规律；再次，当其他参数一定时，适当减小摇摆幅度和摇摆周期，液膜吸收能力将增强，这与理论定性分析相当吻合；最后，改变溶液入口参数及吸收压力，相应的吸收情况有所改变，其趋势与静止状态下的降膜吸收非常一致。

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是，这是不可能的，只要是搞市场经济，是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。