查询词典 radial field

Ten paired suprafascial and subfascial flaps were harvested, the radial arteries were cannulated, and methylene blue dye was injected into the radial artery followed by a barium sulfate/gelatin mixture.

12具新鲜尸体上取下24个桡侧前臂皮瓣。10对取下的筋膜上和筋膜下皮瓣，桡动脉被插入导管，蓝色亚甲基染料和硫酸钡混合后被注入血管内，对皮瓣行数字化摄影，用软件来测量血管分布区。

4 Results of nondestructive test for weld joints shall be graded according to JB 4730. Following requirements shall be met: a For radial test, quality grade of radial transillumination can't be lower than Grade AB, and that of weld joints shall meet table 10; b For supersonic test, approval standard for weld joints are as follows: 1 For weld joints of 100% supersonic test, grade Ⅰ. 2 For weld joints of local supersonic test, grade Ⅱ. c For magnetic particle test and penetration test, grade Ⅰ.

7.5.4 管道焊接接头的无损检测应按 JB 4730 进行焊缝缺陷等级评定，并符合下列要求： a 射线检测时，射线透照质量等级不得低于 AB 级，焊接接头经射线检测后的合格等级应符合表 10 的规定； b 超声波检测时，管道焊接接头经检测后的合格标准如下： 1 规定进行 100%超声波检测的焊接接头 I 级合格； 2 局部进行超声波检测的焊接接头 II 级合格； c 磁粉检测和渗透检测的焊接接头 I 级合格。

Results indicate that radial distance of the bushing from the rotor center and the radius of the hemispherical bushing significantly affect wear rate,and minimzing both two values will result in lowest wear for micro-rotor systems in MEMS.However,it is noted that the bearing radius sets a lower limit on the hemispherical bushing radius since the bushings are located beyond the rotor inner radius.It is desirable to reduce their effects on friction and wear on micro-rotors by regulating the radius of the bushing and the radial distance of the bushing from the rotor center within permissive range of micro-fabrication.Severe wear exists with increasing applied load and rotating speed of the rotor.Stress distributions in the contact region are different from Hertz solutions due to the convergence stresses apearing on the uncontinuous curvature line and the contact pressures display symmetrical parabola in the contact region.

结果表明：在MEMS微转子系统中，微转子轴衬偏心距离和转子轴衬半径影响线磨损率，以两者减至最小为较理想，但须注意设计中轴承半径的限制，并使轴衬偏心距离大于轴承内半径；在转子加工制造许可的范围内，可以通过调整转子轴衬的半径和偏心距离来减少摩擦磨损对微电机的影响，随着转子所承受载荷和转子旋转速度的增加，其磨损严重；接触区的应力分布不同于经典Hertz解，这是由于应力集中出现在不连续的曲率线上，且接触区的接触压力呈现轴对称抛物线状分布。

Patent, and then the blade-to-blade flow was computed by solving the two-dimensional steady Navier-Stokes equations, finally, overall performance and internal flowfield characterization were obtained and analyzed.2. As to radial matching between blade sections, preliminary investigations were developed from three aspects such as stall margin customizing technique, control technology of tip clearance flow, prediction model and control technology of corner separate.a On basis of reviewing on methods of achieving the goal of stall margin in design process of fan and axial-flow compressor, in conjunction of understandings on "Sweep/Dihedral", stall margin customizing technique was put forward; two-dimensional performance prediction method for stall margin customizing was developed, it can consider influences of radial stacking patterns of blade sections and axial distances between blade rows conveniently and rapidly.b A simple model for tip leakage mixing loss of unshrouded blades for compressible flow was presented.

二、叶片基元展向匹配方面，本研究从影响负荷最大化的叶身展向积迭注：原(来源：ABC论文35网www.abclunwen.com指掠弯是裕度定制的一部分，为方便论述，本文将此统一论述为裕度定制、叶尖间隙、叶片与端壁角区这三个最重要因素出发，探讨了各因素影响负荷最大化的机理，并由此给出了最大负荷设计过程中的技术措施和努力方向。1从掌控风扇/轴流压气机裕度方法回顾入手，探析了美国和俄罗斯裕度控制方法及相应特点，结合对&掠/弯&因素的认识提出了裕度定制技术：并开发了能够体现裕度定制思想的二维特性预估方法，可在二维层面下方便快捷地考虑以掠/弯为代表的叶片基元展向积迭以及叶片排间轴向间距带来的影响；2借鉴Denton关于不可压叶尖泄漏损失的理论分析，推导出适用于可压缩流动的叶尖泄漏掺混损失计算的基本关系式。

It illuminated that the TiN coating enhanced the load bearing capacity, and enlarged the using range of substrate material. MoS2 coating and TiN+ MoS2 composite coating both possessed the good capability for palliating radial fretting damage. The microslip increased in radial fretting when the solid lubrication coating was used on the contact interfaces. More system energy can be absorbed in this process in favor of reducing vibration.

TiN 涂层明显提高了基体材料的承载能力，扩大了其应用范围； MoS2涂层和 TiN+ MoS2复合涂层具有较好的抗径向微动损伤能力；固体润滑涂层增加了径向微动界面的微滑，并可吸收更多的系统能量，有利于系统的减振。

Radial gates are widely used on dams and sluices. It is of practical and theoretical significance to analyze and evaluate the flow-induced vibration of the radial gate with hydraulic experiment and numerical computation.

弧形闸门被广泛地应用于水闸和大坝中，采用试验和数值模型结合的方法，有效的分析和评价表孔弧形闸门流激振动，具有重要的工程意义和学术价值。

To enhance the reliability of bearing seal of cone bit, this paper plans to adopt face-radial combination sealing structures; that is to say, end-face and radial seal are arranged in one bit simultaneously. The nonlinear finite element method is applied to analyze and optimize the design of sealing structures.

为了提高牙轮钻头轴承密封的可靠性，本文设计采用端面-径向组合密封结构，即在一只钻头中同时布置端面和径向密封，采用非线性有限元方法对密封结构进行分析和优化。

The double-layered air-inflated membrane forming a "floating cloud" with a diameter of 107m was built by linking a framework in the shape of a truncated cone in the center and a ring truss with 48 upper radial cables and as many lower radial cables, covering them with PTEE coated glass fiber membrane and introducing air into the double-layered membrane to achieve an internal pressure of 300mmHG.

双层充气膜形成了一个直径107m 的、以锥台状框架为中央支撑的&浮云&。在中央的锥台状框架与外围的环形桁架之间，上、下各有48根辐射状的素相连。

Results All fracture were cicatrized in intramedullary self locking nail group,no radial nerve damnification.1 case appeared fracture cicatrizeless in plate group,fracture cicatrized with intramedullary self locking nail in other hospital.1 case appeared fixture break,2 cases appeared radial nerve damnification after operation,1 case after got out fixture operation.

结果 髓内钉组骨折均获愈合，无内固定折断及再骨折，术后未出现桡神经损伤症状，出现肩部疼痛1例。钢板组1例出现骨折不愈合，于外院行髓内钉固定后愈合，内固定折断及再骨折1例，术后出现桡神经损伤症状2例，取钢板术后出现该症状1例。

Results All fracture were cicatrized in intramedullary selflocking nail group,no radial nerve damnification.1 case appeared fracture cicatrizeless in plate group,fracture cicatrized with intramedullary selflocking nail in other hospital.1 case appeared fixture break,2 cases appeared radial nerve damnification after operation,1 case after got out fixture operation.

结果 髓内钉组骨折均获愈合，无内固定折断及再骨折，术后未出现桡神经损伤症状，出现肩部疼痛1例。钢板组1例出现骨折不愈合，于外院行髓内钉固定后愈合，内固定折断及再骨折1例，术后出现桡神经损伤症状2例，取钢板术后出现该症状1例。

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是，这是不可能的，只要是搞市场经济，是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。