查询词典 quiescent
- 与 quiescent 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
In adjacent sections, ALP staining was used to classify BMUs as quiescent or actively forming bone.The areal densities of scl- and scl+ osteocytes in the BMU were inversely correlated and were strong determinants of ALP status in the BMU.
在邻近切片,用ALP染色把BMUs分为休眠或活跃骨形成,这个BMU内区域的scl-和scl+骨细胞的密度呈负相关并且是这个BMU内ALP染色状况的有力的决定因素。
-
The results show that the plasticity zone and dynamically quiescent layer become fine equiaxed recrystallisation under the thermo-mechanical effect, the grains in the heat-affected zone grow up because of the effect of friction heat. When the rotation speed is 2 500 r/min and the welding time is 12 s, good joint is achieved, and the tensile shear strength of the joint reaches 9.24 kN. The tensile shear strength of spot increases with increasing tool rotation speed, with increasing welding time, the strength increases first, while then reduces. The microhardness of plasticity zone is high, but is slightly lower than that of the base metal, the minimum value of microhardness is in the heat affected zone. When the energy input of joint is high, the fracture type of spot is mode Ⅰ, and the tensile shear strength is high; on the contrary, when the energy input of joint is less the fracture type of spot is mode Ⅱ, and the strength is low.
结果表明:塑性区和动态静止层的晶粒在热和力作用下发生动态再结晶形成细小的等轴晶,热影响区的晶粒在摩擦热作用下长大变粗;搅拌头旋转速度为2 500 r/min,焊接时间为12 s时,可以获得力学性能较好的焊点,焊点的剪切强度达到9.24 kN;焊点的剪切强度随搅拌头旋转速度的增大而增大,随焊接时间的延长先增大后减小;塑性区的显微硬度较高,但略小于母材,接头显微硬度的最小值分布在热影响区;焊点热输入量较多时,接头为Ⅰ型断裂,焊点的剪切强度较高;焊点热输入量较少时,接头为Ⅱ型断裂,焊点的强度较低。
-
The life history of Rhododendrons includes 4 stage: germination stage, pre-over-winter stage and winter quiescent stage.
杜鹃花属植物生活史周期可划分为:萌动期、生长期、越冬前期和越冬休眠期四个阶段。
- 推荐网络例句
-
I didn't watch TV last night, because it .
昨晚我没有看电视,因为电视机坏了。
-
Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.
今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。
-
I'm running my simile to an extreme.
我比喻得过头了。