查询词典 quiescent time

Cyclopentane reduced the induction time of hydrate formation, but could not improve the methane consumption during gas hydrate formation in a quiescent cell.

液态烃环戊烷降低了水合物形成的诱导时间，但环戊烷不能提高水合物的填充密度。

Quiescent RASMCs were incubated respectively in 10% FBS DMEM as control group, 10% FBS DMEM supplemented with 0.1% dimethyl sulfide as vehicle group and 10% FBS DMEM supplemented with panaxynol(at concentration of 1,3,9×10-6 mol·L-1) as panaxynol groups. 1. Cell counting and double time. Cell viability was examined with trypan blue exclusion test and the cell number was counted at 0, 24, 48, 72h after the incubation using a hemocytometer.

实验中细胞分成如下几个处理组：①正常对照组：含10％FBS的培养液；②溶剂对照组：0.1％DMSO；③药物处理组：panaxynol 1、3、9×10-6 mol·L-1组。1、细胞计数及倍增时间测定：于接种并同步化后处理0、24、48、72h，用血细胞计数板计算活细胞数量，绘制生长曲线并计算细胞倍增时间。

The effects of the amount of sulfuric acid solution,the amount of potassium iodide solution and quiescent time after extraction were investigated.

考察了硫酸溶液的用量、碘化钾溶液的用量及萃取后静置时间等条件对双氧水含量分析的影响。

Great distance in either time or space has wonderful power to lull and render quiescent the human mind.

时间和空间上的远距离有一种奇妙的力量，可以使人的心灵平静。

The rising/falling settling time is 3.20/4.56 μs and the quiescent current is 3 μA.

它的上升及下降稳定时间是3.20/4.56 μs，静态电流是3 μA。

Similarly, if the strong shear, which could suppress all the scattering in the quiescent two phase region, stopped, the follow-up phase separation also displayed characteristics of anisotropism and relaxation, In this dissertation, the transposed"butterfly'and"streakpattern were observed for the first time within the shear-history-influenced phase separation, which is found closely relevant to the anisotropical relaxation behavior of macromolecules. 5. The phase separation kinetics of PS/PVME under oscillatory shear was further studied on the base of that done under simple shear. It is found that, under specific temperature and strain amplitude, the occurrence of phase separation is strongly contingent on oscillatory frequency and only intermediate frequency could effectively induce phase separation; If all considered oscillatory shear could stimulate phase separation, a fixed frequency can maintain specific most probable phase size and higher frequency yields smaller phase, which makes a higher elasticity but weaker stress relaxation; Furthermore, higher frequency can produces stronger compulsory oscillation on the MPPS but won't change the mean of the MPPS. Under given frequency and strain amplitude, the phase separation kinetics dramatically depends on the phase angle of oscillation and the phase separation corresponding to different phase angle follows different dynamical process.

在简单剪切场下相分离动力学研究的基础上进一步对振动剪切场下PS／PVME的相分离动力力学进行了尝试性的研究，发现：在一定温度和振幅条件下，相分离的发生强烈的依赖于振动频率，只有中等频率的振动剪切才能有效地促进相分离的发生；在都能使相分离发生的前提下，一定频率的剪切能够使体系维持一定的最可几相尺寸，较高频率的剪切导致体系形成的相区尺寸较小，因而体系的弹性效应较强而应力松弛效应较弱；同时，更高频率的剪切对最可几相尺寸的强迫振动效应越强，但不会使最可几相尺寸的平均值发生改变；在一定的振幅和频率条件下，相分离的动力学过程会强烈地依赖于相位角，不同相位角对应的相分离遵循不同的动力学过程但机理一样。

The induction time of methane hydrate formation was reduced, gas hydrate could grow rapidly, and the methane consumption was improved during hydrate formation in a quiescent cell with micella surfactants.

发现微量的表面活性剂降低了甲烷气体水合物在静止反应器中形成的诱导时间，并使水合物快速形成和生长，提高了水合物形成过程中的填充密度。

The results show that the plasticity zone and dynamically quiescent layer become fine equiaxed recrystallisation under the thermo-mechanical effect, the grains in the heat-affected zone grow up because of the effect of friction heat. When the rotation speed is 2 500 r/min and the welding time is 12 s, good joint is achieved, and the tensile shear strength of the joint reaches 9.24 kN. The tensile shear strength of spot increases with increasing tool rotation speed, with increasing welding time, the strength increases first, while then reduces. The microhardness of plasticity zone is high, but is slightly lower than that of the base metal, the minimum value of microhardness is in the heat affected zone. When the energy input of joint is high, the fracture type of spot is mode Ⅰ, and the tensile shear strength is high; on the contrary, when the energy input of joint is less the fracture type of spot is mode Ⅱ, and the strength is low.

结果表明：塑性区和动态静止层的晶粒在热和力作用下发生动态再结晶形成细小的等轴晶，热影响区的晶粒在摩擦热作用下长大变粗；搅拌头旋转速度为2 500 r/min，焊接时间为12 s时，可以获得力学性能较好的焊点，焊点的剪切强度达到9.24 kN；焊点的剪切强度随搅拌头旋转速度的增大而增大，随焊接时间的延长先增大后减小；塑性区的显微硬度较高，但略小于母材，接头显微硬度的最小值分布在热影响区；焊点热输入量较多时，接头为Ⅰ型断裂，焊点的剪切强度较高；焊点热输入量较少时，接头为Ⅱ型断裂，焊点的强度较低。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。