查询词典 quantity of heat

The principle for calculating mass and heat quantity and hardware and software of the intelligent flow and heat quantity totalizer are introduced.

介绍一种智能流量、热量积算仪的质量、热量计算原理，硬件构成及软件流程。

The deficiency in traditional method for calculating heat transfer quantity in the wall of wood drying kiln was pointed out,and the heat transfer quantity in the wall of wood drying kiln was calculated by the shape factor method.

指出了木材干燥窑壳体传热量的传统计算方法中的不足，并利用形状因子法来分析计算木材干燥窑壳体的传热量。

In order to verify the model mentioed above, the mathematical simulation of geotemperature field has been carried out. The thrust nappe sheat zones are handled with two ways: 1 they are treated as constant heat sources in terms of q=τμ, that is, the quantity of frictionally generated heat is constant; 2 as heat conduit with high thermal conductivities and with fluid flow in fault zones.

为了进一步检验上述逆冲推覆复合叠加构造模型的可信程度，开展了地温场数值模拟工作，按复合叠加型岩石圈热结构给定各种热物性参数，逆冲推覆剪切带以两种方式处理，一是把它作为定热源按q＝τU，即按摩擦生热量级大小取值；第2种是把它作为热通道处理。

The conclusion of three burning methods mentioned above during the heat storage period is that the first method is the best one, which is propitious to keep higher blast temperature because of the heat exchange in the middle and blow of hot blast stove has been aggrandized through convection heat transfer caused by the added exhausted air quantity and increased flow rate.

以上三种燃烧制度，在蓄热期：第1种因废气量增大，流速加快，利于对流传热，强化了热风炉中下部的热交换，利于维持较高风温，第2种因废气量减少，不利于传热和热交换的强化，不利于维持较高风温，第3种由于废气大量减少，流速降低，传热减缓，蓄热量较少，不利于提高风温。

The result shows that the cooling capacity increases with increasing generator heat transfer. The coefficient of performance of the system increases when the quantity of the generator heat transfer is increased from 6 kW to 7 kW, however it decreases in the range of 7 kW-9 kW. When the fan frequency increases, the temperature of liquid ammonia leaving condenser decreases, while the cooling capacity and the COP of the system increases. When the flow rate and inlet temperature of water/glycol increases, the evaporator takes more heat away and the cooling capacity and COP of the system increases.

其结果可发现当发生器加热量增加，系统温度增加系统冷冻能力增加，但其COP於6 kW-7 kW 系统COP会有先增加，於7 kW-9 kW，系统COP会有下掉的趋势；在冷凝器方面，当风扇频率增加，冷凝器温度降低时，冷凝器出口冷媒随之降低，系统冷冻能力会有所提高，COP亦增加；在蒸发器方面，蒸发器卤水出口温度及卤水流量增加，可以使蒸发器带走更多的热量其系统冷冻能力及COP也就会相对增加。

In this paper, based on a pill-box window model with a conical-shaped alumina ceramic and Ansoft HFSS software, the relation of VSWR with various electrical parameters in the window is simulated; the effects of variations of the output window structure on electrical field intensity, microwave power flow and quantity of heat are analyzed; the electrical characteristics of frequency bandwidth, power capability and heat dissipation for the pill-box window with conical-shaped or disk alumina ceramic are discussed, which shows that, with a rational structure of the window with conical-shaped alumina ceramic, the output capability of microwave peak and average power may greatly be increased, the secondary electron emission may effectively be suppressed, and heat dissipation may become more uniform and be easier for cooling.

本文在前人工作的基础上，基于圆锥形陶瓷盒形输出窗模型，采用Ansoft HFSS三维计算软件的优化模拟，对该输出窗模型的驻波频率特性与各种结构参量的关系进行了优化模拟，分析了该输出窗片结构变化对其表面的电场分布，功率流分布、热量分布的影响，得出最优模型参数。并且探讨了陶瓷窗片的形状和几何结构对改善输出窗的频带特性、提高峰值功率和平均功率、抑制二次电子倍增方面的作用。

Adding a small quantity of three functional group of polyvalent can improve the water resistance and decoration of copolymer emulsion after film forming. The structure form of interpenetrating networks has a greater destroy degree to the micro crystal of polyurethane film forming substance than the effect of the prepolymer capping graft copolymer.IV, This article studies on the heat stability of acrylate modified polyurethane dispersion, researches the changes of the structure of acrylate modified polyurethane dispersion afterheating, and analyses by the heat analysis, infrared ray and heat analysis, and mass spectrometery.

利用拉曼光谱和扫描电镜、红外光谱等测试技术，分析了丙烯酸酷及丙烯酸酷一有机硅等改性聚氨酷水分散体的成膜过程—利用预聚体封端技术合成的丙烯酸酷改性聚醚聚氨酷的成膜过程包括乳液颗粒的挤压成膜与分子硬段的微区结晶，有机硅氧烷的引入将同时出现硅氧烷的水解缩合；具有互穿网络结构的丙烯酸酷改性聚氨酷水分散体因丙烯酸酷的互穿而限制了聚氨酷硬段在成膜过程中的结晶，聚合物成膜以挤压成膜为主，有机硅的复合改性同样出现硅氧烷水解缩合现象。8。

According to the change of the enemy\'s quantity and the qualitative theory of the differential equation, we research the spruce aphides and its predator system. At the same time, we discussion the spruce aphid multiplication model when the natural enemy quantity is a certain value and the periodic oscillating model whose the quantity of the natural enemy changes along with the time. Obtains the stability condition of the balance point and the limit-cycle existing condition, the system presents the dissipative structure\'s character. Finally it explains that this theoretical analysis has certain practical significance regarding the preventing and controlling harmful insect.

第五章，松毛虫与其天敌的关系是食饵和捕食者的关系，根据天敌数量的变化，利用微分方程定性理论，研究松毛虫与天敌系统，讨论天敌数量为一定时的松毛虫增殖模型和天敌数量随时间变化的周期振荡模型，得到正平衡点全局稳定性和极限环的存在条件，通过计算机模拟，说明周期振荡的捕食模型能够呈现典型的时间耗散结构特征，对于防治害虫有一定的实际意义。

The change of excavated cavity quantity influence the quantity of Ashy Starling significantly, the change of all cavity influence the quantity of Great Tit and Ashy Starling significantly.

啄洞数量的变化对灰椋鸟的数量变化产生明显影响；样地内总的树洞数量的变化对灰椋鸟和大山雀数量产生明显影响。

0Mg/L 6-benzylaminopurine was the optimal concentration of shoots quantity inducing which frequency of inducing shoots and number of shoots per explant were 100% and 11.1 respectively. 0.5mg/L 6-benzylaminopurine was the optimal concentration of shoots length inducing which average length of shoots was 12.0mm. Explant size had significantly effects on direct shoots quantity and length induction. When complete cotyledon used as explant, frequency of inducing shoots, number of shoots per explant and average length of shoots could approach to 100%, 6.7 and 17.1mm respectively. 2.0mg/L silver nitrate could significantly increase shoot quantity induction, both frequency of inducing shoots and number of shoots per explant could be as high as 97.2% and 4.2 respectively. But silver nitrate also could restrain shoots elongation.

结果表明：不同黄瓜品种直接不定芽数量诱导存在显著差异，但长度诱导无显著差异；6-苄氨基嘌呤对直接不定芽数量和长度的诱导作用显著，其中4.0mg/L为数量诱导适宜浓度，其出芽率和每外植体出芽数达到最高，分别为100.0%和11.1，0.5mg/L为长度诱导适宜浓度，其平均芽长12.0mm；外植体的大小对直接不定芽数量和长度均具显著影响，随着子叶的增大诱导直接不定芽的数量和长度增加，其中单片完整子叶为最适宜大小，其出芽率、每外植体出芽数和平均芽长分别达到100%、6.7和17.1mm；硝酸银也对直接不定芽数量诱导影响显著，其中2.0mg/L为适宜浓度，出芽率和每外植体出芽数分别达到97.2%和4.2，但对芽长有抑制作用。

Hanna: That's over now, isn't it?

都结束了，对吗

You must be ill. You look so pale.

你一定是病了，你的脸色苍白。