查询词典 pyrolysed

PES samples were pyrolysed at 358℃ and 590℃, the products of dogradation can be explained on the basis of chain scission. The thermal stability of PES in both inert and oxidising atmospheres has been studied by means of TGA at varies rate of temperature rise.

在正常加工温度（315~335℃）下，使用HAAKE转矩流变仪对PES进行密炼和用挤出机对PES反复挤出，发现并研究了PES的外观，粘度、分子量及力学性能的改变。

The scrape tires were pyrolysed under atmosphere of inertia in a pilot-scale rotary kiln designed by Zhejiang University. Pyrolysis experiment was carried out at 500℃, 550℃, 600℃ and 650℃.

采用浙江大学自行开发的中试回转窑热解系统，在无氧的气氛下，对废轮胎进行了热解试验，热解温度为500℃，550℃，600℃，650℃。

Printed circuit boards were pyrolysed in a tubular furnace with the aim of separating and recovering the organic and metallic materials.

采用温控管式炉在750℃条件下，对废弃印刷线路板进行高温裂解，以分离回收其中的有机和金属材料。

To produce CAW, starch pyrolysed at 500-800C in the presence of a ferric metal as a catalyst in the atmosphere of Ar / H2, in a tube-furnace.

碳原子线是以马铃薯淀粉为固体碳源，以铁系金属为催化剂，在500-800℃的管式炉中、Ar／H_2气流下反应而成。

Effects of different pyrolytic temperatures on the formation of aromatic substances were investigated by pyrolysis chro-matography-mass chromatography when β-carotene was pyrolysed at high temperature under nitrogen protection.

利用裂解色谱-质谱联用仪对β-胡萝卜素在不同温度下进行裂解时所生成的香味物质进行了研究。

For the purpose of studying the effect of different activation and pyrogenation conditions on the porosity of carbon produced from waste tyre rubber pyrolysed in the pilot-scale rotary kiln pyrolyzer, a activation furnace was designed in which the tyre carbons was activated.

为了研究不同热解工况和活化工况对废轮胎活化炭品质的影响，运用自行设计的活化炉对废轮胎热解炭进行了活化实验。

Controlled burning and 'after burning' of the pyrolysed gases from Scrap Chamber in the Heating Chamber burners and also quenching the flue gas in the regenerator provide remarkably reduced contaminants in the gas led to the bag house.

可控的燃烧和加热室烧嘴对废料室热分解气的二次燃烧以及烟气在换热器内的快速冷却显著地减少了通向废气处理单元的污染物。

Parent coal, pyrolysed char, 700℃ and 900℃ partial gasified chars were analysed by SEM-EDX, which proved the mechanism of fixed sulfur by alkaline minerals during pyrolysis and partial gasification.

3对比原煤、原煤热解半焦、热解半焦700℃部分气化焦和900℃部分气化焦的SEM-EDX的分析结果发现灰分在热解、部分气化中的固硫作用。

The compositon and structure of two complexes differed from the complex ZnS (en 〓 synthesized in ethylenediamine. The precursors were pyrolysed in nitrogen stream at 400℃.

实验结果表明这种配合物结构、组成都不同于在纯乙二胺溶液中得到的中间体配合物。

But when Fe/D113 precursor is pyrolysed in the range of 400-700℃, the crystal structure of the iron particle is different. The products are mainly iron oxides andα-Fe as Fe/D113 precursor pyrolysed at 500℃, and as the pyrolytic temperature increases to the range of 600-700℃,α-Fe and Fe_3C are observed. Meanwhile, Al_2O_3、MgO、MgAl_2O_4 were observed in Al/C, Mg/C, Al-Mg/C which were prepared from D113 resin at 1000-1300℃.

而在同样的条件下热解载铁树脂(Fe／D113)，热解产物中铁的晶体结构与热解温度有关，400℃热解产物为铁的氧化物；500℃热解产物为体心立方结构的单质铁；600-700℃的热解产物为bcc单质铁和铁的碳化物(Fe_3C)。1000-1300℃热解含Al、Mg及Al-Mg的D113树脂制得的Al／C、Mg／C、Al-Mg／C材料中Al、Mg主要以Al_2O_3、MgO、MgAl_2O_4形式存在。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。