查询词典 pumping

This study employs the sensitivity analysis to analyze the influence period of parameters in response to the pumping in both leaky and unconfined aquifers.

本研究使用敏感度分析，寻找渗漏与自由水层的参数，在进行抽水试验时，反应於泄降的影响时程。

Pumping tube pipe with a fixed part of warehouse body sliding in between the two positions embedded parts per 3m welding pipe fixed, positions on the use of rubber face effective 90-degree bend towards the two east-west positions on the sliding-mode platform with human small dump then expected, with each 300mm uniformly continuous pouring of concrete.

泵送管固定部分为钢管随仓体滑升，在两仓之间每3m焊接预埋件以固定钢管，仓上工作面内采用橡胶管用90度弯头转向东西两仓，在滑模平台上用人力小斗车接料，以每层300mm连续均匀浇筑混凝土。

Each Pumping Unit shall be rated for handling unscreened sewage wastewater in accordance with the operating conditions defined in Table 1 of these specifications.

在本规格说明书表1中所规定的工作条件下，每台泵装置应该能够处理未过滤过的下水道污水。

The pump dose not pumping water, the hand of vacuum and pressure gauge swings terribly

水泵不吸水，压力表及真空表的指针剧烈跳动。

The pump dose not pumping water, but the vacuum gauge shows high vacuum.

水泵不吸水，真空表仍表示高度真空。

We will show a vacuum safety check valve that creates a seal between the vacuum pumping device and the part.

我们将显示一个真空阀，安全检查之间创建了一个抽水设备和部分真空密封。

The main products are machine rails, beams, soft-organ, pumping Xiashi plate, reel-type, machine tools and other machinery-guided, screw, light bars, telescopic jacket, round ventilation tube, vacuum tubes, Shaped jacket, machine tools, and fluid, powerful filling tube, protection packages, engineering plastics, steel Tuolian, adjustable cooling pipe, scraping debris panels, plastic hose and fast joints.

主要产品有机床导轨、横梁、柔性风琴式、钢板抽匣式、卷筒式、机床及其它机械导柱、丝杠、光杠、伸缩式护套、圆型通风管、吸尘管、异型护套、机床电、液、强力矩型管、保护套、工程塑料、钢制拖链、可调冷却管、刮屑板、塑料软管及快速接头。

Wine making and ageing Traditional vinification by pumping-over under the pressure of CO2 during the fermentation (3 weeks).

葡萄酒根据传统的酿造过程进行发酵产生二氧化碳（3周），在橡木桶种酿造12个月在进行灌装

These vortical structures can increase the interface between primary and secondary flows, thus resulting in rapid mixing and promoting pumping performance.

这些涡结构能够增加主、次流的接触边界面积，从而提高混合能力和引射能力。

Under the condition of meeting the working requirements of pumping units, aimed at lest material consumption, the walking beam is optimized.

在满足抽油机工作能力条件下，以耗材最少为目标，对游梁进行优化设计是降低抽油机成本的一个重要方面。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。