查询词典 pump house

As a minimum, each finished pump shall be performance tested for total dynamic head, capacity, efficiencyand power requirements at six (6) operating points plus shut-off head for the selected impeller diameter, ofwhich, the design capacity operating point shall be included.

每一台装配完好的泵至少要在六（6）个工作点上进行性能测试，测试项目至少包括全动力扬程、流量、效率和功率消耗，此外，还要对用于所选择的叶轮直径断流水头的设计流量工作点上进行性能测试。

In doing so, I learned that by opening a small panel door just above the pump panel, you could gain access to the control valve and that removing a small pin from the point where the valve handle connected to the motor, you would then be able to operate the valve by hand.

这样做，我知道了打开水泵正上方面板的小面板门，你可以进入控制阀，并剔除了点小针在阀门手柄连接到汽车，你便可以为手工操作阀门。

In doing so, I learned that by opening a small panel door just above the pump panel, you could gain access to the control valve and that removing a small pin from the Rate-of-Flow Control Valves point where the valve handle connected to the motor, you would then be able to operate the valve by hand.

这样做，我知道了打开水泵正上方面板的小面板门，你可以进入控制阀，并剔除了点小针在阀门手柄连接到汽车，你便可以为手工操作阀门。

You're just gonna go pump your pompoms

就这样？你就这样去玩你的彩球

Taking precise plungers of oil pump mouth and bearings produced in a large scale as the objects, practical application and verification of above theoretically research results were made.

以大批量生产的油泵油咀柱塞精密偶件和轴承件为对象，对上述理论研究结果进行了实际应用与验证。

NET and three dimensional CAD software SolidWorks2004, the special-purpose three plungers reciprocating pump CAD system collecting the design, the lectotype, the analysis and the plot as a body is developed in this paper.

NET和三维CAD软件SolidWorks2004开发出一套集设计、选型、分析及绘图为一体的专用三柱塞往复泵的CAD系统。

The addition of less than 1% phosphorus improves the hardness and strength of bronze; that formulation is used for pump plungers, valves, and bushing s.

磷青铜铸锭的含磷量少于1%，铸件只含微量，特别适用于作泵的柱塞、阀和套。

The addition of less than 1% phosphorus improves the hardness and strength of bronze; that formulation is used for pump plungers, valves, and bushings.

磷青铜铸锭的含磷量少于1%，铸件只含微量，特别适用于作泵的柱塞、阀和套。

With the help of performance test of reciprocating pump, the design for the spring was validated. An experiment-bed was also built to test the poppet valve's lift displacement. The testing results prove that the simulation was in a correct way.

设计了往复泵泵阀试验台；通过对往复泵进行性能测试，对不同弹簧预紧力下阀门升程进行了测定，验证了仿真结果的合理性。

In order to optimize the spring of the reciprocating pump valve and establish the best spring factor matching, the unsteady opening-closing process of the poppet valve was simulated. The simulation based on computational fluid dynamics approach, and the dynamic-grid technology and User Defined Function was conducted to depict the law of motion of the poppet valve.

采用RNG k-ε湍流模型、动网格技术以及用户自定义程序，对往复泵泵阀的启闭过程进行了非定常数值仿真，得出了不同弹簧因素下、阀门从开启到关闭的过程中，阀芯的升程随时间的变化规律、阀的迟滞关闭时间以及阀芯落座的瞬时速度。

A small, rubber-headed hammer used in examination or diagnosis by percussion.

叩诊槌用在通过''。'振荡'。''所作的检查或诊断中的橡皮头的''。'小'。''槌

Affixes are limited in number in a language, and are generally classified into three subtypes, namely, prefix, suffix, and infix, depending on their position with reference to the root or stem of the word.

语言中词缀的数量总是有限的，根据它们跟词根或词干的相对位置，一般可以把词缀分外三小类：前缀，后缀和中缀。