查询词典 pump handle

He stopped the spread of the disease in 1854 by removing the pump handle from the polluted well.

他在1854年通过移去污染水井的汲水手柄阻止了疾病的传播。

Step on flush water valve and pump at least 15 strokes with pump handle.

脚踩在进水阀门踏板上，同时将手摇泵摇压最少15下。

Provided with a pressure limit valve, too fast pump handle shaking does not work.

是没有用处的。

Rotate, and shake the pump handle once in one or two pipe revolutions.

泵手柄一次。

When you replace the pump handle, a readout on the machine will ask you if you want a receipt. Press "Y" for yes or "N" for no.

你把把手放回原处後，机器上的读出器会显示，询问你是否需要收据，按下「Y」代表要，按下「N」代表不要。

Close the relief valve, shake the pump handle to make the cutter wheel touch the

3.2.1 关上卸压阀，摇动油泵手柄，使切管刀与

To 10mm feeding, after the cutting wheeltouches the pipe, one pump handle shaking is

切管刀进给10 mm，切管刀接触钢管后，每摇动一次

Step on the flush water valve while moving the pump handle for one, two strokes or so, till flush water starts filling the toilet bowl.

脚踩在地板上进水阀门踏板上，同时将手摇泵前后摇压1至2下使马桶内装入一些水。

The main products include: multi-functional injection pump handle, base, child seat child seat, the new injection molding children toy car, plastic bicycle pedal cars shaped baskets and other plastic products.

主要产品有：多功能打气筒注塑手柄、底座、童座儿椅、新型儿童注塑玩具车、注塑自行车脚蹬、车筐及其它异型塑料制品等。

For the upper and lower physical decomposition of the fuel pump, pump body can be placed, open side cover, remove the pump head fastening nut, remove the pump head, hand clamp plunger living roots, slowly out the plunger and spring cylinder fault, with clean petrol or diesel repeated washing, wash, after-loading complex (note the plunger into the regulation of regulation must fork arm), and alternately tighten pump head nut, rotating camshaft, oil pump pulled the handle to manipulate the review.

2对于上、下体能分解的喷油泵，可将水泵体平放，打开侧面盖板，卸下泵头紧固螺母，取下泵头，用手钳夹住柱塞根部，慢慢抽出故障缸柱塞和弹簧，用清洁的汽油或柴油反复清洗，洗净后装复(注意柱塞调节臂必须装入调节叉内)，并交替拧紧泵头螺母，转动凸轮轴，扳动油泵操纵手柄复查。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。