查询词典 pulse rate

Results: The attenuating rate of the peak value of acceleration at the heel of SYS-2 varied between 24.6 % and 85.8 %. The attenuating rate of average acceleration was from 34.2 % to 87.7 %, and the attenuating rate increased with the decline of pulse input width of the shock.

结果：舰艇防冲击鞋后跟部位加速度峰值的衰减率为24.6%～85.8%，平均加速度衰减率为34.2%～87.7%，衰减率随冲击输入脉宽的减小而逐渐增大。

The complications in the early stage, related parameters, and the incidence rate of infection and mortality in the later stage were evaluated respectively. Results: The incidence rates of renal dysfunction, shock, cardiovascular failure and gastrointestinal hemorrhage, the score of acute physiology and chronic health evaluation Ⅱ and the frequencies of pulse and breath in the severe hypoalbuminemia group were all higher than those in the mild hypoalbuminemia group (P＜0.05 or P＜0.01). The differences of incidence rate of hepatic failure and the scores of Ranson and Balthazar CT between these two groups had no statistical significance (P＞0.05). The incidence rate of infection and the mortality in the severe hypoalbuminemia group were higher than those in the mild hypoalbuminemia group (P＜0.01) in the later stage of SAP.

结果：重度低白蛋白血症组肾功能衰竭、休克、心衰及消化道出血的发生率高于轻度低白蛋白血症组（P＜0.01，肝功能衰竭发生率两组比较无统计学差异；Ranson评分及Balthazar CT评分两组间比较，差异无统计学意义（P＞0.05）；重度低白蛋白血症组的急性生理和慢性健康评价指标Ⅱ（acute physiology and chronic health evaluationⅡ， APACHEⅡ）评分、脉搏和呼吸频率均明显高于轻度低白蛋白血症组（P＜0.05或P＜0.01；重度低白蛋白血症组后期感染发生率及病死率均高于轻度低白蛋白血症组

The design of the device using NC Lathe CA6140 control, part of the main transmission system using AC spindle motor and graded by the pulley driven spindle gearbox, through the inverter and gearbox to achieve sub; Feed System used by stepper motor driven ball screw slowdown after campaign vertical feed system through a gear after the ball screw drive, in the horizontal feed system through two gear-driven ball screw; Tool to automatically transfer tool carrier (4-position), thus achieving automatic tool change; by MCS-51 series 8051 data to be dealt with. from the I / O interface stepper pulse output signal to control the feed rate and itineraries; In order to maintain the function of cutting thread, to the outer end of spindle or other appropriate location loaded pulse generator; Lathe will be transformed into Tailstock manually controlled electric Tailstock.

本设计利用数控装置对CA6140普通车床进行控制，主传动系统部分采用交流调频主轴电动机经带轮及分级齿轮变速箱驱动主轴，通过变频器和齿轮变速箱实现分段无级变速；进给系统采用步进电机通过减速后驱动滚珠丝杠运动，在纵向进给系统中通过一级齿轮减速后驱动滚珠丝杠，在横向进给系统中通过二级齿轮减速驱动滚珠丝杠；刀架改为自动转位刀架从而实现自动换刀；通过MCS-51系列8051单片机对数据进行计算处理，由I/O接口输出步进脉冲信号控制进给速度和行程；为了保持切削螺纹的功能，要在主轴外端或其它适当部位装上脉冲发生器；将车床的手动尾座改造成为可控电动尾座。

Monitoring includes ECG; systolic, diastolic, and mean BP, preferably by intra-arterial catheter; respiratory rate and depth; pulse oximetry; urine flow by indwelling bladder catheter; body temperature; and clinical status, including sensorium (eg, Glasgow Coma Scale—see *), pulse volume, skin temperature, and color.

监测内容包括ECG；收缩、舒张和平均血压，最好用动脉内插管测得；呼吸速率和深度；脉氧测定；内置导尿管尿流测定；体温；及临床状况，包括感觉（如Glasgow昏迷等级表－）、脉量、皮肤温度和肤色等。

Monitoring includes ECG; systolic, diastolic, and mean BP, preferably by intra-arterial catheter; respiratory rate and depth; pulse oximetry; urine flow by indwelling bladder catheter; body temperature; and clinical status, including sensorium (eg, Glasgow Coma Scale—see Table 2: Stupor and Coma: Glasgow Coma Scale *), pulse volume, skin temperature, and color.

监测内容包括 ECG ；收缩、舒张和平均血压，最好用动脉内插管测得；呼吸速率和深度；脉氧测定；内置导尿管尿流测定；体温；及临床状况，包括感觉（如 Glasgow 昏迷等级表－见表2：木僵和昏迷： Glasgow 昏迷表）、脉量、皮肤温度和肤色等。

This paper firstly discusses the principle of UWB pulse array beamforming. Then a beamforming scheme is presented based on multi-rate filter bank, which is suitable for UWB pulse signals. The proposed method avoids the hardness of delays control in time domain, and can obtain the uniform frequency invariant array response in such a wideband for UWB signals.

该文提出一种适合UWB脉冲信号的基于多速率滤波器组的波束形成方法，避开了时域处理中延迟控制的问题，同时实现了大带宽范围内的均匀一致的频率不变阵列响应。

On the basis of these treatments, the patients in the treatment group also had aerobic kinesitherapy through limb and trunk exercises with assistance to improve oxygen consumption of the body and increase the heart rate. In each session of exercise, the patients were supposed to attain the target heart rate of 70％ to 85％ of the personal highest safe heart rate.At the beginning, each session of exercise lasted for 10-15 minutes and the heart rate or pulse was measured every 4-6 minutes, with the patients'heart rate allowed to increase by no more than 20/minute and the patients not feeling tired. The subsequent exercise time gradually increased but not over 30-40 minutes, twice a day for no less than 5 days a week.

干预：两组患者均给予改善循环和营养神经药物等治疗，在此基础上，治疗组采用有氧运动疗法：以靶心率为指标，即以通过运动获得的个人最高安全心率70％～85％作为每次运动的靶心率，开始时每次运动10～15 min，每运动4～6 min测一次心率或脉搏，运动以患者心率增加不超过20次/min、患者感觉不疲乏为度，以后逐渐增加运动时间，直至每次活动持续时间30-40 min，2次/d，每周治疗不少于5 d。

A kind of high speed sulphamate nickel-based electrolyte is chosen as basal electrolyte, the influences of plating process parameters on the micro-hardness of the nickel deposit have been studied by orthogonal experiments. It is concluded that the main influence factors on the micro-hardness of the nickel deposit are sulphamate concentration and electrolyte temperature, the deposition rate and quality in single-pulse mode are higher than that in DC power and double-pulse mode.

选择以氨磺酸型高速镀镍液作为基础镀液，通过正交试验研究了电镀工艺规范对镀层显微硬度的影响关系，试验结果表明：镀液主盐氨基磺酸镍浓度和镀液温度是影响镀层硬度的显著因素，单脉冲供电模式下的电镀沉积速率和镀层质量优于直流和双脉冲模式。

Using experimental method, the effects of different laser energy, different shock times and shock paths on TA2 round sheet forming were analyzed by the aid of a neodymium glass laser with pulse energy 35J, FWHM 23ns, laser wavelength 1.06 μm, effective spot diameter 8mm, pulse repetitious rate 2Hz.

采用实验的方法，研究了不同的激光能量和不同的冲击路径、冲击次数对TA2钛合金圆板变形的影响，取得了不同冲击条件下钛合金圆板的变形数据。

Using a neodymium glass laser with pulse energy 35 J, FWHM 20 ns, laser wavelength 1.06μm, effective spot diameter 8mm, pulse repetitious rate in the range of 1Hz～20Khz and Using a ABAQUS software, an experimental study and numerical simulation on laser - shock forming of titanium sheet metal were carried out respectively.

笔者利用激光冲击波技术对钛合金板料进行了成形实验，所采用的激光波长为1.054μm，脉宽约23ns，能量35J左右，有效光斑直径为8mm，脉冲的重复率为0.5Hz。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。