查询词典 pulse glass

The degradation characteristics of ZnO-glass varistors have it's own features. For the first time, degradation phenomena of varistors under direct biasing, alternative field and pulse current are examined respectively in this thesis.

ZnO-玻璃系压敏电阻的老化有其自身的特点，论文首先分析了压敏电阻在直流、交流和脉冲电流作用下的老化实验现象，在此基础上，分析了各种条件下的老化机制。

Cloud base height measurements with a single pulse erbium glass laser ceilometer.

一种便携式激光测云仪的云底高度反演方法。

Micro-concave-surfaces were fabricated on the surface of a photosensitive glass by focused irradiation of femtosecond laser (with 775 nm-wavelength and 150 fs-pulse duration),heat treatment and wet chemical etching in 8% ultrasonic solution of hydrofluoric acid for 50 minutes at room temperature.

利用聚焦的飞秒激光（中心波长775 nm、脉宽150 fs）照射FOTURAN光敏玻璃，经热处理及浓度为8％的氢氟酸溶液室温腐蚀50 min后，在FOTURAN玻璃表面制作了微凹面。

Focusing the laser (10 ns,1 064 nm) through K9 glass is used to study the relation between the damage appearance of the glass and the focusing position of the high intensity ns laser pulse.

利用脉宽为10 ns、波长为1064 nm的激光脉冲聚焦通过K9玻璃的方法，研究了玻璃的损伤形貌与高强度纳秒激光脉冲聚焦位置的关系。

The temporal and spectral behavior of the pulse transmitting in the glass material under different input pulse conditions is studied.

圆偏振光入射时，可以获得更短脉冲宽度的压缩脉冲和更窄的光谱宽度。

To improve the fatigue strength of TC4, Nd: Glass pulse laser was used to shock the surface of TC4. X-ray stress analyzer was used to test the residual stress of the shocked area, and calculation was done by finite element software ABAQUS.

为提高钛合金的疲劳强度，采用Nd： Glass强脉冲激光对TC4钛合金表面进行冲击强化处理，采用X射线应力仪对冲击区的残余应力场进行测试，并采用ABAQUS有限元仿真软件对其残余应力场进行分析计算。

Supposing the spectral distribution of the chirped pulse after amplification is be Gauss or super-Gauss distribution,the inverse calculation on 100 J Nd∶glass chirped pulse amplication system is carried out.

理论上假定放大后啁啾脉冲的光谱分布为高斯分布或超高斯分布，对&百焦耳级钕玻璃啁啾脉冲放大系统&进行逆运算。

Multilayer dielectric thin film reflector for spectrum reshaping of chirped pulse la ser in Nd :glass chirped pulse amplification system.

用于钕玻璃啁啾脉冲放大系统光谱整形的多层介质膜反射镜。

Using experimental method, the effects of different laser energy, different shock times and shock paths on TA2 round sheet forming were analyzed by the aid of a neodymium glass laser with pulse energy 35J, FWHM 23ns, laser wavelength 1.06 μm, effective spot diameter 8mm, pulse repetitious rate 2Hz.

采用实验的方法，研究了不同的激光能量和不同的冲击路径、冲击次数对TA2钛合金圆板变形的影响，取得了不同冲击条件下钛合金圆板的变形数据。

Using a neodymium glass laser with pulse energy 35 J, FWHM 20 ns, laser wavelength 1.06μm, effective spot diameter 8mm, pulse repetitious rate in the range of 1Hz～20Khz and Using a ABAQUS software, an experimental study and numerical simulation on laser - shock forming of titanium sheet metal were carried out respectively.

笔者利用激光冲击波技术对钛合金板料进行了成形实验，所采用的激光波长为1.054μm，脉宽约23ns，能量35J左右，有效光斑直径为8mm，脉冲的重复率为0.5Hz。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。