查询词典 propeller shaft

Small craft with inboard engine - Propeller shaft ends and bosses with 1:16 taper; Technical Corrigendum 1

舱内安装的发动机的小船只。螺旋桨轴端和轴壳。技术勘误表1

In this step, work to drill for the pipe of a propeller shaft or a rudder.

在这个步骤中，演练工作，为管道的传动轴或舵。

Effective modal mass of the propeller shaft bracket system was studied and calculated.

并计算了尾轴架系统的有效模态质量。

The gear mentions and the position of intermediate propeller shaft is decided by the means " computation, mapping and tries to collect many times". Calculates the coordinates of the spindle and drive shaft and checking the center distance, determined department spindle must use dislodges the gear.

本课题设计的组合机床采用&一面两销&定位、液动夹紧，一次装夹加工柴油机齿轮室盖三个面上的孔，保证了加工精度，提高了生产效率，减少了工人的劳动强度。

When taking propeller shaft joint angle measurements, or checking the phasing, of two piece shafts, consider each shaft separately.

当测量两个传动轴的工作角或检查它们是否定相时，对它们要分别考虑。

For connecting the output shaft of the gear box to the rear axle,a ling shaft known as propeller shaft is used.

为把齿轮盒子的输出桥连结到后面的轮轴，鳕即是螺旋桨桥的桥被用。

Among these mechanisms and units are the clutch, transmission,propeller shaft,and final drive comprising differential and axle shaft.

在这些机械装置之中有离合器，变速器，传动轴和由差速器和后轴组成的后驱动器。

The propeller shaft is a drive shaft to carry the power from the transmission to the rear-wheel axles.

螺旋桨轴是传动轴执行的权力，传输到后轮车轴。

In this article, based on room temperature creep analysis on propeller shaft, a dynamic and a fatigue analysis on the propeller shaft are carried out.

本文针对常温下长期受到恒定载荷作用下的某舰螺旋桨尾轴进行了常温蠕变分析，并对变形后的螺旋桨尾轴进行了动力和疲劳分析。

Align previously made marks on yoke and propeller shaft and install propeller shaft.

将定位轭架上的预制标记对准传动轴并安装传动轴。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了