英语人>网络例句>profiles 相关的网络例句
profiles相关的网络例句

查询词典 profiles

与 profiles 相关的网络例句 [注:此内容来源于网络,仅供参考]

The result showed that the volatile profiles from Vibrio parahaemolyticus were distinctly different from that of tryptic soy broth.

电子鼻所得的数据用主成分分析、判别因子分析、单类成分判别分析等多元统计方法进行数据分析。

Exhibiting angle unconformities or erosion unconformities in different part of the basin, these surfaces are obvious to be recognized on seismic profiles.T1 conformity, separating Eogene from Neogene, was formed during the whole basin uplifting and erosion by the end of Eogene.T1 unconformity denuded unbearing strata differently, and the deeper and thickest erosion lies on the southern margin of the basin, which reflects the activity of southern Jiangnan paleo-terrene. In conclusion, the major erosion belts extending along NW direction reflects NE-SW compression and slipping caused the Eogene basin uplift and strengthen the earlier NW direction extending low convex, and formed the NW direction extending depress and erosion belts.

古近系和新近系之间的T1不整合面形成于古近纪末期的盆地整体抬升,对下伏地层造成不同程度的剥蚀,沿盆地南缘的剥蚀层位深,剥蚀量大,反映盆地南缘整体相对隆起,与江南古陆的隆起作用有关。T1界面剥蚀带走向以北西向为主,反映了盆地在古近纪末受到了北东-南西向的挤压或压扭作用,该作用造成盆地整体抬升,强化了北西向展布的低凸起,产生了近北西向的洼陷和剥蚀带。

If the glass during processing should avoid collapsing edges, cracks and other damage during transportation to avoid being hit sharp metal; installation should avoid the use of distorted profiles, glass Perpendicularity poor guide pulley in place, punch Department Unbuffered rubber pad, such as non-standard operation.

如果在加工玻璃应避免运输过程中倒塌的边缘,裂纹和其他损失,以避免被击中切削;安装应该避免的,如不使用扭曲型材,玻璃垂直度差的地方导轮,冲压部无缓冲橡胶垫,,规范运作。

C. Create two new hardware profiles, one for the docked state and one for the undocked state.

C。 建立两个新的硬体设定档,一个用於插接状态,另一个用於未插接状态。

ANP and CX43 began to express at 2nd week after induction and increased gradually,about 60% of the resulting myogenic cells were positive at 4th week after induction ,they were negative for uninduced cells.hMSCs'surface antigen profiles obtained by Flow Cytometry were negative for CD31\CD34\CD45 before and after induction,but CD90 expressed higher after induction while was weak positive before induction(P.05). Apotosis index was correlated with the cultural time after induction,The apoptosis rate of induced hMSCs was remarkably higher than control group(P.01),and the variation between groups was notable(P.05),the cell cycle analysis showed that the percentages of G_0/G_1phases were reduced significantly after induction. The expresstion levels ofβ-MHC and CTNT mRNA were undetectable before induction,began to increase at 1st、4th week after induction,reached the peak at 6th week and decreased after that,the expression of Bcl-2 and Bax mRNA varied regularly after treated with 5-azacytidine. hMSCs'resting membrane potential、range and rate of depolarization were heightened gradually after being induced.

结果:hMSCs诱导前为纺锤形,诱导后第2天部分细胞即开始发生形变,呈球形或短棒状,1周后胞浆中颗粒增多,约20~30%细胞边缘呈毛刷样变化;hMSCs表面抗原CD31、CD34、CD45在诱导前后差异无统计学意义,CD90未诱导时表达呈弱阳性,诱导后明显增高(P.05);ANP和CX43在诱导前无表达,诱导后第2周开始表达且表达随时间逐渐增强,但CX43在诱导后第5周表达量开始降低。hMSCs诱导后凋亡指数随诱导后培养时间增加,低浓度诱导组低于标准浓度诱导组,组间差异有统计学意义(P.05),G_0/G_1期细胞比例诱导后较对照组显著减少(P.05);β-MHC和CTNT基因分别在诱导后第1周和第4周时表达开始增强,在第6周时均达到高峰,第8周时表达开始衰减,Bcl-2、Bax基因表达呈时间依赖性变化,hMSCs经诱导后随心肌样细胞特征的表达膜静息电位、去极化幅值和去极化速率逐渐增高。

One of the important tasks in Resin Transfer Molding is the selection of appropriate processing parameters, so that the mold cavity will be filled completely and the composite quality can be guaranteed. Successful completion of these tasks requires knowledge of the resin flow, especially the resin flow front profiles, the pressure distribution, temperature distribution and the resin conversion distribution et al. In this paper, the governing equations of resin flow are presented on the base of the seepage mechanics, the thermodynamics and the chemical kinetics. The unlumped temperature system i.

中文题名树脂传递模塑工艺过程数值模拟与固化过程监测研究副题名外文题名 Investigation on numerical simulation and curing process monitoring of resin transfer molding 论文作者李海晨导师王彪教授学科专业工程力学研究领域\研究方向学位级别博士学位授予单位哈尔滨工业大学学位授予日期2002 论文页码总数10,121页关键词树脂固化光栅树脂传递模塑复合材料馆藏号BSLW /2003 /TQ320 /7 树脂传递模塑(Resin Transfer Molding,RTM)工艺过程研究的主要任务之一是选择合适的工艺参数,以使树脂充分润湿增强纤维,保证固化后产品质量。

Profiles of β-actin expression in different recovery time after heat shock were expressed similarly and not significantly different from that of the unstimulated control, suggesting an ubiguitous expression pattern.

表明β-actin是研究受外界环境胁迫作用下昆虫体内不同基因表达水平的可靠内参基因。

This study has achieved the following purposes,observed effects of different levels of noise exposure on the auditory function and the hearing organ of guinea pigs,explored optimal noise exposure profiles for research of NIHL susceptibility,established NIHL susceptibility model,148 differentially expressed genes of cochlea between NIHL susceptible and unsusceptible guinea pigs were screened by using suppression subtractive hybridization.The results of bioinformatics analysis showed that there are 34 sequences whose homology were larger than 80% and match sequence larger than 100 bp.

本研究观察了不同噪声暴露量对豚鼠听觉功能和听觉器官结构的影响,探讨了NIHL易感性研究的最佳噪声暴露方案,建立了NIHL易感豚鼠模型,利用抑制性消减杂交技术筛选NIHL易感与不易感豚鼠耳蜗的差异表达基因片段148条,生物信息学结果显示同源性大于80%且匹配碱基大于100 bp的片段共34条。

In addition, deterministic calculations were carried out using (1) arithmetic mean values of untransformed hydraulic parameters,(2) arithmetic mean values obtained after backtransformation of Gaussian distributed parameters, and (3)alternatively using a set of mean bimodal retention and conductivity curves. Predictions obtained with the two stochastic methods and the deterministic cases are compared with measured cumulative outflow and moisture content profiles from fifteen 1 m long undisturbed soil columns collected along the same transect.

此外,决定论计算被实行使用改变与水有关的参数的(1)算术平均价值观,在 backtransformation 以后为得到高斯的(2)算术平均价值观的散布参数和(3)另一种选择使用一套卑鄙双峰的保留和传导性弯曲。,用二有可能的方法和决定论情况为得到的预言被把和仔细斟酌累积的流出比较和从十五1 m 长不受干扰土壤柱,沿着把同样的 transect。

The uprights are new, so is the cooling system, the diffuser and the wing profiles.

变速箱依然是横向的部件,但它也是全新设计的,当然它也是在去年我们使用的变速箱基础上研制的。

第51/78页 首页 < ... 47 48 49 50 51 52 53 54 55 ... > 尾页
相关中文对照歌词
Don't Get Lost In The Crowd
The Laughing Song
The Corner
Respect Your OG's
Tailz
Feel Like An Enemy
Code Of The Streets
We Belong
West Ryder Silver Bullet
Sponsor
推荐网络例句

Listen,point and check your answers.

听,指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例,经过临床的诊断后,其中施以温针治疗的48例,疗效显著,报道如下。1临床资料本组病例48

Some known methods of remnant pump detection and automatic laser shut-down use communications, such as an OSC.

一些已知的残余泵浦检测和自动激光关断的方法利用诸如OSC的通信。