查询词典 process line

The detail course is to set up the coordinate of the machine and the workpiece, use the intersection of the tool tracing line caused by the adjacent edge in the cutting process as the point on the flank, deduce the function of the flank and program the cutting process of spiral bevel gears using VISUAL BASIC language.

此程序最大的特点就是和实际的加工过程相似——不但齿轮的形成过程和实际相同，而且机床切齿参数的调整过程也和实际一样，因此使用者可以直接在计算机上调整切齿参数，从而根据自己的要求来模拟加工，得到满意的切齿参数，进而在实际机床上获得满意的产品。

First, the S-CDMA-HFC system with integrated traffic is introduced and the method of traffic integration is given. Second, the upstream channel capacity of the S-CDMA-HFC system with integrated traffic that has the same rate is analyzed. The chronoff limit and Gaussian approximate equation of the upstream channel cutoff probability are derived. Third, the impact of the selection of the line transmission rate on the upstream channel capacity of the S-CDMA-HFC system with integrated traffic is discussed in detail. The cutoff probability and throughout equations of the upstream channel with different integrated traffic are derived. Fourth, the impact of the power control error on the capacity is discussed. Results show that the power control error will degrade the upstream channel capacity and have different influence on the different traffic. Finally, the capacity requirement of the initialization process is raised. Analytical results show that the initialization process will impact on the capacity slightly.

首先，简单介绍了综合业务S-CDMA-HFC系统，给出了业务综合的方法；然后，分析了具有相同码率的综合业务条件下的S-CDMA-HFC系统上行信道容量，导出上行信道中断概率的切尔诺夫上限和高斯近似公式；然后，详细讨论了基本传输速率的选择对综合业务S-CDMA-HFC系统上行信道容量的影响，导出了不同业务综合条件下上行信道的中断概率和吞吐量公式；然后，讨论了功率控制误差对综合业务S-CDMA-HFC系统上行信道容量的影响，结果表明功率控制误差会使上行信道容量下降，且对不同业务的影响程度是不同的；最后给出了初始接入的容量要求，分析结果表明初始接入将对综合业务S-CDMA-HFC系统上行容量带来影响，但不明显。

The challenges of these material are screen printing and sintering process. Many long fine patterned lines should be printed on a large piece of glass and sustain a smooth, continuous and uniform line pattern; on the other hand, the sintering process is rapidly increasing sintering temperature to a peak in a short time, then cooling the glass substrate to low temperature under a short time shock.

汽车钢化玻璃除霜加热线，是采用在玻璃基板上印刷银浆，在玻璃的钢化热处理过程中完成银导体膜的烧结附着，由于烧结时间短(总时间250sec)和温度骤变条件相当苛刻，要求导电细线无脱落断线，在功率满足要求的情况下，与外蓄电池连接的电极的焊接及附着强度也有具体要求，另外耐候性及耐擦洗等后步要求也较苛刻。

In addition this paper,"Bio-Rad method," two parasitic wasps of the post-embryonic development the process of protein accumulation in young bees and the host Plutella xylostella in this process in vivo haemolymph protein content were measured and found that over time, was gifuensis parasitic larvae of the diamondback moth haemolymph protein content showed an upward trend in nearly a straight line, Ichneumonidae parasitic For example, in the early parasitic diamondback moth haemolymph protein content also showed the trend of slow growth, but in the mid-and late parasitic young bee about to be completed in the development of the host body when to stop feeding, a significant downward trend却呈, and significantly lower than the third day of its own protein content; on the same day of the different species of the diamondback moth parasitic wasp hemolymph protein content compared Ichneumonidae Parasitism of diamondback moth have hemolymph protein content than in the third and fourth day after the parasitic Braconidae hemolymph content to be high, but very different in the case of the fifth day, as evidenced by her side after the parasitic bee moth haemolymph protein content is cocoon of the parasitic bee hemolymph protein content of 0.7 times.

另外本文采用"Bio-Rad法"对两种寄生蜂胚后发育过程中幼蜂蛋白积累及寄主小菜蛾在此过程中体内血淋巴蛋白含量进行了测定，结果发现随时间的推移，被茧蜂寄生小菜蛾幼虫的血淋巴蛋白含量是呈近直线增加趋势，而对于姬蜂寄生来说，在寄生初期小菜蛾血淋巴蛋白含量也呈缓慢增长趋势，但在寄生中后期，幼蜂即将完成在寄主体内的发育取食停止时，却呈大幅下降趋势，且明显低于其自身第三天的蛋白含量；对同一天的被不同种寄生蜂寄生的小菜蛾血淋巴蛋白含量进行比较，姬蜂寄生过的小菜蛾血淋巴蛋白含量在第三天和第四天均比茧蜂寄生后的血淋巴含量要高，但在第五天的情况大不相同，表现为被姬蜂寄生后的小菜蛾血淋巴蛋白含量是被茧蜂寄生的血淋巴蛋白含量的0.7倍。

The influence and effect of boracic acid,glue and wetting agent during nickel electrolysis cathodic process were studied and the method of on-line control in nickel electrolysis cathodic process was also put forward.

研究了镍电解阴极过程中硼酸、胶、润湿剂的影响与作用，提出镍电解阴极过程中添加剂在线监控的新方法。

The influence and effect of boracic acid, glue and wetting agent during nickel electrolysis cathodic process were studied and the method of on-line control in nickel electrolysis cathodic process was also put forward.

摘 要：研究了镍电解阴极过程中硼酸、胶、润湿剂的影响与作用，提出镍电解阴极过程中添加剂在线监控的新方法。

Labeling process is in line with the COTS and squeege formed the COTS guaranteed cutan, when the charts after gelatinize cots and when you turn the subject box of the front end to scroll in the form of stick out a label; with a label of panels continue to campaign,张合 by 揭标-揭标 e-?·|-clamping of the label side margin was off, when the then standard barrel go to one side of the bearing bottle turntable with Mark intracavernous when the aluminum foil on the bottle labels; at the same time the label of the bottle with the cap bottles go taiqian line also with the pallet for the 90-degree rotation, across the brushlelss label group label is brushlelss; the last high school marching to starred on the head part of applanation.

贴标过程是胶辊和刮板配合使胶辊上形成一定厚度的胶膜，当标板经过胶辊时涂胶并在转过标盒前端时以滚动形式粘取出一张标签；带着标签的标板继续运动，由揭标筒的张合揭标指夹住标签侧缘而被揭下来，当接标筒转到承瓶转台一侧时通过压标海绵将铝箔标贴到瓶口上身标同时贴上）；贴了标签的瓶子随承瓶转台前行的同时还会随托盘作90度旋转，穿过刷标组时标签被刷平；最后行进到压标星轮上将盖顶部分压平。

Factory has a number of TetraPak, composite membrane, roof package, glass production line, the use of Tetra Pak, Sweden, Finland in accordance with, the United States and other advanced Nimico import equipment; the current product line and taste as many as 40 species, the whole production process in strict accordance with the ISO9002 Quality System and HACCP requirements of control, to ensure that the production of each package products to meet the corresponding quality standards.

工厂拥有多条利乐包、复合膜、屋顶包、杯装生产线，采用瑞典利乐、芬兰依莱克斯德、美国Nimico等先进的进口设备；目前产品系列及口味多达 40 余种，整个生产过程严格按照ISO9002质量体系及HACCP要求控制，确保生产的每一包产品都达到相应的质量标准。

Program according to a certain frequency of scan lines with lowlevel circulation lines, while testing out the state line, once the judge has said there is a classified as lowkey is pressed, stop the scan and to maintain the current lineline state, and then read out line state to get the current keys key codes to wait for key popstart the scanning process, waiting for the next key.

程序按一定的频率用低电平循环扫描行线，同时检测列线的状态，一旦判断有一列为低则表示有键被按下，停止扫描并保持当前行线的状态，再读取列线的状态从而得到当前按键的键码；等待按键弹起：检测到各列线都变成高点平后，重新开始扫描过程，等待下一次按键。

The principle of railroad trackbed inspection with GPR mounted on track vehicle is introduced. In line with requirements of exploring depth, accuracy and speed in the process of field survey, the layout of GPR survey line is put forward, the center frequency of antenna, the maximum time window, the temporal sampling interval and the space between traces are calculated according to the theoretical formulas.

介绍了使用路检车装载探地雷达对铁路路基检测的原理，结合野外探测过程中对测量深度、精度和行车速度的要求，给出了GPR现场工作测线布置的原则，理论上给出天线中心频率、时窗、采样率、测量点距的计算公式。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。