查询词典 process furnace

This process can preheat blast furnace gas and air up to 200℃ and 400℃ respectively, and blast temperature above 1 200℃ can be obtained from pebble stove.

该工艺技术把高炉煤气和助燃空气分别预热到200℃和400℃，配套采用球式热风炉，热风温度可以达到1200℃以上，同时计算了工艺中涉及到的各种参数，对工艺和设备进行了设计或选型。

This paper introduces the principal,technical process and product properties of which yield superfine powder whith plasma technical in the classical antimony white furnace.

介绍在传统的锑白炉上采用等离子体技术，生产Sb2O3超细粉末的原理、工艺过程以及产品性能，是一项老工艺赋与新内容的技术创新。

In the steel-making process of electric arc furnace, the endpoint parameters, i.

在电弧炉冶炼生产过程中，出钢温度、碳含量和磷含量等终点参数直接关系到后续生产工艺，甚至影响产品质量。

During computer calculate, According to condition of charging of bell-less top blast furnace, and burden motion characteristics and contact situation in charging process, the reboxing is used to distinguish the point of contact between burden granules and between burden granular and wall.

本文将其引入冶金工程科学研究，从高炉炉料颗粒的运动机理研究高炉无钟炉顶布料过程及布料规律，确立了高炉无钟炉顶布料的炉料分布和料面形状的理论数学模型，推动了高炉无钟炉顶布料的理论研究。

The results of combustion process numerical simulation of blends in blast pipe and tuyere raceway indicated that the total combustion efficiency of blends could come up to more than 90%, the combustion behavior of injecting blends in tuyere zone is between that of injecting coal and waste plastics. Hence, injecting blends of coal and waste plastics in blast furnace is feasible in theory.

高炉喷吹煤与废塑料混合燃料过程数值模拟结果表明：燃料总的燃烧效率能达到90%以上，高炉喷吹煤与废塑料混合燃料物在高炉风口区的燃烧行为介于高炉单独喷吹煤粉和废塑料两者之间，高炉喷吹混合燃料煤与废塑料在理论上是切实可行的。

As sulfuric acid , prepared from blowing furnace flue gas in the copper sulfide ore smelting, is easy to get reddish, blackish and greenish, reasons are found through analysis and detection, flame color reaction and hanging experiment in combination with the production process.

针对利用硫化铜矿冶炼吹炼炉烟气制得的硫酸易发红、发黑和发绿的情况，结合生产工艺，利用分析检测、焰色反应和挂片实验等手段，明确了原因。

First the paper applied the commercial program PHOENICS to establish the mathematical simulation by the modificatory Navier-Stokes equation andκ-εtwo-equation, then selected the spots by golden section, and investigated the fluid flow behaviors in argon blowing process in ladle furnace.

本文首先在商业软件PHOENICS操作平台上，采用修正后的Navier-Stokes方程和κ-ε双方程建立数学模型，采用黄金分割法选点进行模拟，用三维模拟研究了LF吹氩过程中钢液的流动行为。

Possesses a number of high-quality professional management and technical personnel, production equipment advanced, the use of the whole process of production silicasol casting, casting line has a full set of equipment 2, 100KG MF Induction Furnace 4 sets monthly production capacity of 150 tons or more.

拥有一批高素质的专业管理和技术人才，生产设备先进，采用全硅溶胶工艺生产铸造，有精铸流水线全套设备两条，100KG中频感应电炉4台套，月产能力达150吨以上。

Ceramic Process Engineer – furnaces 陶瓷工艺工程师—炉子 Responsibilities职责:-Take part in the design review with overseas equipment suppliers during the furnace fabrication phase and assist on-site validation and installation.

在设备制作阶段和外国的设备供应商参与设计评估，以及协助设备的现场验证和安装。

The quartz tube inserted into the furnace that becomes the process chamber for diffusion and oxidation.

插入到炉子中的石英管，作为扩散和氧化的处理腔。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。