查询词典 probe-pointed

The effect of tribology factors on bearing vibration is studied experimentally. AR model and WPT are used to processing the normal arid abnormal signals. The results are as follows:1. The vibration of ball bearings is caused by the tribology action of contact pairs of ball and ring races and has the essential of tribo-dynamics. Any factors affecting the tribology characteristics of contact pairs will affect vibration and noise of bearings consequently.2. Vibration characteristics of bearing keep almostly unchanged with the increasing of axial load expecting the increasing of nature frequencies. When radial load increasing with axial load unchanged, nature frequencies keep unchanged but some new vibration peaks appears in the spectrum.3. Vibration amplitudes are damped and nature frequency are enhanced with sufficient lubrication. Vibration and noise of bearings increase obviously and roar can happen and the contact surfaces scratch slightly under insufficient and unclean lubrication state. Bearing will be disabled in a few minutes without any lubrication.4. Bearing vibration is unstable under low speed. With the speed increasing, the vibration become stable and natural frequencies increase slightly but the amplitudes increase apparently.5. Bearing vibration can be excited only by some harmonics ofwaviness without lubrication and by all harmonics with lubrication based on the theoretical analysis.6. The nature frequencies of ball bearings decrease with the increasing sizes. When international clearance increasing, nature frequencies decrease in radial and increase in axial and angular and the amplitudes increase in radial and decrease in axial and angular. When the number of balls increasing, nature frequencies increase and amplitudes decrease. When the pitch diameter increasing, axial nature frequency increase and others nearly keep no change. When outer race groove curvature radius increasing, nature frequencies increase in radial and decrease in axial and angular and amplitudes keep no change in radial and increase in axial and angular. When inner race groove curvature radius increasing, nature frequencies decrease and amplitudes increase.7. The distortion in amplitude and frequency components of bearing vibration signals picked up by the present probe measurement method is founded and right conclusions cannot be achieved by the signals. When accelerometer is rigidly screwed with steel stud onto a flat outer surface of a ball bearing, vibration signal can be got without distortion and the reliability of research on bearing vibration is assured.8. AR model is suitable for large samples of bearing vibration signals, square root of length of samples can be used as the upper limitation of order determination and the FPE order selection criterion is effective. Many advantages of AR spectrum are founded over the classical based on FFT.9. Time-Frequency analysis is necessary for abnormal noise of ball bearings. WPT overcomes the principle shortcomings of STFT and proved to be a best tool to process the abnormal signals.

理论分析和试验研究表明： 1球轴承振动是钢球—滚道接触副中的各种摩擦学作用引起的，具有摩擦动力学的本质，任何对接触副的摩擦学特性有影响的因素都将对球轴承的振动和噪声特性产生影响； 2中心轴向载荷作用下，载荷增大使球轴承的固有振动频率升高，载荷越大同样的载荷增幅引起的频率升幅减小，足够大的中心轴向载荷作用下载荷的变化对球轴承振动的频率特性不会产生明显的影响； 3轴向和径向联合载荷作用下，径向载荷不大时球轴承振动的固有频率基本不变，但是可能引起变刚度激励的非线性振动，出现新的频峰，过大的径向载荷将使部分钢球脱离接触，使球轴承的振动和噪声呈现不稳定状态； 4润滑对球轴承的振动和噪声特性有重要的影响，良好的润滑对振动有明显的抑制作用，润滑不充分时，振动和噪声的水平会有明显增高，一定条件下还会激发接触副中的谐振，发出啸声，造成接触表面的伤害，无润滑干接触时，短时的运转就会损伤接触副表面，使振动和噪声迅速增大，并随时可能引发严重的磨损和卡滞失效；接触副润滑良好时，油膜的"刚化效应"使球轴承振动的固有频率有所提高，润滑剂中含有弥散性污浊时，振动的幅度总体升高，但弥散性污浊不会改变球轴承振动的频率特性；浙江大学博士学位论文：球轴承振动的研究 5低速时，球轴承振动的基本特征呈现不稳定状态，随着转速的提高，球轴承振动的频率特性趋于稳定，固有频率频峰升高； 6理论分析表明，干接触时钢球和滚道表面波纹度的某些谐波分量能激励球轴承的振动，振动的幅值与谐波幅值成正比，实际球轴承中钢球的分布不可能完全均匀，波纹度的激励作用会随时发生；润滑接触的分析表明，波纹度的任意谐波分量均能激励球轴承的振动； 7球轴承的几何和结构参数分析表明，球轴承尺寸越大，径向、轴向和角振动的固有频率越低；钢球中心圆直径增大，球轴承的径向和轴向振动的固有频率基本不变，角振动的固有频率有所上升，振动的幅频特性基本不变；径向游隙加大使球轴承的径向振动固有频率降低，轴向和角振动的固有频率有所升高，径向振动幅频特性的幅值升高，而轴向和角向降低；钢球的数量增多使球轴承振动的固有频率上升，幅频特性的幅值下降，径向振动的幅值下降最为明显；外圈沟曲率半径系数增大使球轴承径向振动的固有频率升高，轴向和角振动的固有频率降低，径向幅频特性基本不变，轴向和角向幅频特性幅值升高；内圈沟曲率半径系数增大使径向、轴向和角振动固有频率均下降，振动幅频特性的幅值均有升高； 8试验对比表明，传感器采用探针式安装时，由于探针接触副接触特性的影响，钡(量得到的球轴承振动信号有失真，采用专门设计和制作的试验球轴承，以固定式安装加速度计，首次测量得到了球轴承振动的真实信号，通过对振动信号的分析，验证了球轴承振动的理论模型； 9)基于时间序列分析的AR模型适用于大样本球轴承振动信号的分析，以样本长度的均方根值作定阶上界，FPE做判阶准则，给出的AR谱光滑，频率分辨率高，是球轴承振动分析的简便而可靠的手段； 10以时频域分析的小波包变换分析球轴承异音信号能够比较好地定位和聚焦异音发生的时间，时间间隔，频率范围，同样是球轴承振动分析的可靠的手段，可用作球轴承故障诊断技术。

If you can get 6 microns with a 3 long probe, you're doing pretty darn good.

如果你能用一个3 探针仅偏差6个微米，你做的已经非常好了

Decay constant k of Surface Dynamics of the modified surface can be calculated using the measurement results of the contact angle and the angle - dependent XPS, being a probe, k values can be used to characterize the surfa...

通过PET表面的接触角及F/C比的测定，计算出表面动力学衰减常数k，三种测试方法得到的k值都可以用来表征碳氟等离子体处理PET的表面动力学行为，其中混合气体的k值最小。

Through measuring density inside and in the position with defect, it was discovered that density of defect in timber has corresponding relation to the pressure signal extracted by probe. Mechanism of the mechanical pressure deterred to measure defect in timber was set up.

压阻式木材内部缺陷类无损检测技术要解决的技术难点是木材密度特征的提取方式，以及对信号的分析消噪和判断等技术手段，分为如下几个方面进行研究。

123I-IaraU was deficiently evidenced as a probe to monitor gene expression in the Tramp-C1/HSV1-sr39tk system.

本研究结果无法提供充分的证据显示碘－123-IaraU在Tramp-C1/IL3-tk系统可作为基因探针。

Firstly, the relationship of Atomic force and distance is studied. The scan type of samples and the working mode of probe is confirmed, then PZT is chosen as actuator for micro scan displacement, and optical deflexion method is used to detect the deflexion value of cantilever. After all these work, the system light path design is finished, and its mathematical model is completed.

首先，分析了原子力探针系统的中原子力–距离的关系，并确定探针系统的探针的工作模式和样品的扫描模式，从而选择压电陶瓷作为扫描微位移驱动器；采用光学偏转法检测微悬臂偏转量，并选用了PSD作为传感元件，并在此基础上进行了系统光路设计及其数学模型的建立。

Objective To reinforce the recognization of deltoid contracture inchildren and probe its causes, pathomechanism,diagnosis and treatments.

目的 增强对儿童三角肌挛缩症的认识，探讨其病因、发病机制、诊断和治疗方法。

One group was cultured in DEME free of serum; the other in DEME with 10 μg/ml lipopolysaccharides for 6 hours. NF-κB was studied by flow cytometry technique using immunofluorescent staining, and by gel shift assay using γ-32P labeled NF-κB oligonucleotide probe.

取体外培养的第2或3代人角膜基质细胞，同步化后分为2组：无血清的DMEM液培养的不加药组；含质量浓度为10 μg/ml脂多糖的DMEM液培养6小时的加药组。

We should probe it in depth...

我们应当在深入调查。。。

Probe into the methods and forms of the exerting of deputation during the course of adjourn a meeting.

积极探索党的代表大会闭会期间发挥代表作用的途径和形式。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新