查询词典 printer driver

this paper analyzed the error of two methods of printer fuzzy identification by a case of laser printer identification. by error analysis of single method and united method, it evaluated the reliability of two methods about printer identification.

摘 要：通过实际案例的激光打印机打印文字，鉴别打印机型和打印机墨粉类型，分析打印文字图像或墨料ftir图形单一鉴别与联合鉴别结果之间的误差率，评估两种鉴别方式的可靠性差异。

The best ink in the off-time after opening the packaging end use, not to open the ink on the outside when not in use Add to carton packaging, the cartridge so as to avoid talking about the dust falling into the hands of the next use of the dust caused by plugging into the nozzle first, the head following a reset state of ink wash sponge pad, open the front cover, press the Print Paper knife, move out, the hair can not suction clean cloth towel or sponge the ink pad, a large amount of about 10 days, then wash first, because each sponge pad is printer ink wash drawing of fatigue, if the dust and fatigue more ink will be solidified with the protection of Garra and print images will be the first flush, if the plug was found, and if the use of cleaning 3 seconds is not normal use, we must enter the printer maintenance menu kk2 or use kk1 cleaning, large format printers and a small printer operation principle is similar, if the correct maintenance and use, it will increase the service life, which Like is like a car, but also for us to maintain and are familiar with it

墨水最好在拆开包装后断时间内使用完，不要把打开的墨水放在外面，不用时包装好放入纸盒内，以免墨盒嘴上落入灰尘，下次使用时灰尘进入喷头造成堵头情况，喷头复位状态下面有一个洗墨海绵垫，打开前盖，按下打印切纸刀，往外移，用不起毛的纸巾或布吸干净海绵垫的墨水，用量大的话大约在10天清洗一次，因为海绵垫是打印机每次冲洗时吸取疲墨水的，如果灰尘多就会和疲墨水凝固在一起，对墨头的保护和打印头冲洗会有影像，如果发现堵头情况，如果使用清洗3秒还不能正常使用，我们要进入打印机的维护菜单用kk2或kk1清洗，大幅面打印机和小打印机的操作原理是差不多的，如果正确的维护和使用，它的使用寿命就会增长，这也好比一辆轿车一样，还要我们去维护和熟悉它

But note monlchamus, we should first of all, clearly a few details: if I'm using the print head integralization cartridge, note white without note, waydifferent spent cartridge, and throw away, it would be better then reuse, even when printed, generally does not have any prejudice to the printer; if the print head and the wall split-printer ink cartridges, ink in the note, we'd better choose the original manufacturer's selection of ink, because, the printer manufacturers compatible ink normally eligible for canceling the user's warranty, if inadvertently broke the print head and is concentrating.

但在注不朱后，我们答首不后澄辉几个梗概：假如我用的是打印脚一体化不朱盒，那么不注白不注，横竖不朱盒也不有什么用了，与其扔失，不立不如再宝贝诳骗，不离算打印不败果不抱负，凡是也不会差打印机有什么保护；假如用的是打印脚与不朱盒分体的打印机，那么在轻注不朱水时，我们最坏拔取原厂的不朱水，因为采取兼容不朱水，打印机厂家凡是城市裁撤用户的保修资格，给是失慎不弄好了打印脚，不离真是因小失不小了。

For equipment of effective protection good printer, many people want to be restricted to undertake limitative to the access of printer, be used in order to prevent printer at will!

为了有效保护好打印机设备，不少人都想对打印机的使用权限进行限制，以防止打印机被随意使用！

Print ribbon is installed, we need to print frame first uninstall it from the printer, uninstalling the device must be near the print head from the location you pull up hard, in order to easily print aircraft had come from the printer ; the following, we also need to open the print frame, taking into account different models of printers that it installed on the structure of the printing frame is not exactly the same, so the installation of ribbon winding method is not exactly the same, we have to uninstall it before the original band, we a good look around the ribbon before the correct method, or else do not print the right way to install the ribbon will not be able to function properly, but also may lead to the printer not work correctly.

在安装打印色带之前，我们需要先将打印架从打印机中卸载下来，在卸载该设备时，必须先从靠近打印头的位置处用力向上拉一下，才能把打印架轻松地从打印机中拿下来；下面，我们还需要将打印架打开，考虑到型号不同的打印机它的打印架安装结构并不完全相同，因此色带的安装缠绕方法也不完全相同，我们在将原色带卸载下来之前，一定要好好地观察一下色带以前的正确绕法，否则不按正确方法安装的打印色带不但不能正常发挥作用，相反还有可能导致打印机无法正常工作。

The time that it takes the job to get to the printer, the time that it takes for the printer to process the job and the time that it takes for the printer to actually print the job once it has received it.

当时，它以就业去印当时，它以就业为印表机加工和时间缩为打印机打印实际工作一旦收到。

For example, the axes of the topmost driver and the middle driver or of the bottommost driver and the middle driver may intersect at an angle 2.theta.

例如，最上方驱动器和中间驱动器的轴线或最下方驱动器和中间驱动器的轴线在方位平面中相交成2θ角度。

When changing diaphragms in most drivers the new diaphragm may not be 100 % concentric to the old one, and the only way to align it in the magnetic gap is by removing the iron pole from the driver and loosening the screws holding the center pole piece, then and only then the diaphragm can be aligned with the center pole piece and rubbing or touching of the voice coil with the pole pieces in the gap is avoided, this may happen at certain frequencies only, producing a very harsh sound, even passing a static or a dc diaphragm test , therefore the claim that the diaphragms are replaceable in the field is not in many cases true, only when the driver has adjustable screw and dowel locating pin the alignment is possible without getting inside the driver and when alignment of the diaphragm is needed, the plate holding the pole pieces and assembly needs removal, by doing so the pole piece may be well set and aligned but the magnetic field will weaken significantly by such a procedure and solving one problem leads to another one, in this case the driver needs to be re magnetized in order to perform well.

当改变隔膜在大多数司机的新膜片不得100 ％同心旧的，只有这样，才能使其在磁场的差距是通过消除铁柱从司机和松动的螺丝中心柱举行一块，然后才是膈肌可配合中心极片和摩擦或触摸的音圈与极片的差距是可以避免的，可能会遇到这种情况只有在特定的频率，产生了非常严厉的声音，甚至通过一个静态或直流隔膜测试，因此声称隔膜的更换在外地不是在许多情况下，真实的，只有当该名司机已可调螺丝和销子定位销调整是有可能没有得到内部的驱动器和调整时，膈肌是必要的，举行的板极件和大会需要搬迁，这样做极可能是一块很好设置和调整，但磁场将削弱显着这样的程序和解决的一个问题导致另一次，在这种情况下，司机必须重新磁化，以表现良好。

I also thought that the beginning of the phenomenon of the failure was due to display card driver caused the destruction, so I right-click the desktop system, the "My Computer" icon on the shortcut menu from the pop-up the implementation of "property "command, open the System Properties settings window, click the window of the" hardware "tab, and in the corresponding tab page, click" Device Manager "button, open the device list window, use the mouse to start the window "Show card" option, and then double-click the mouse "standard VGA graphics adapter" project, open the corresponding project page the driver tab, click the tab page in the "Uninstall" button to display the current card driver procedure removed, and then restart the computer system, then let the system automatically re-installed the graphics card driver.

开始阶段笔者还以为该故障现象是由于显示卡驱动程序遭到破坏引起的，于是笔者用鼠标右键单击系统桌面中的&我的电脑&图标，从弹出的快捷菜单中执行&属性&命令，打开系统的属性设置窗口，单击该窗口中的&硬件&标签，并在对应的标签页面中单击&设备管理器&按钮，打开系统的设备列表窗口，用鼠标展开该窗口中的&显示卡&选项，再用鼠标双击&标准 VGA 图形适配器&项目，打开对应项目的驱动程序标签页面，单击该标签页面中的&卸载&按钮，来将当前的显示卡驱动程序删除掉，之后将计算机系统重新启动了一下，同时让系统自动重新安装了显示卡驱动程序。

Driver sets mode switch to "OFF", and pulls out master control key; waits for and until the indicator of "train reversal ready" flashes , presses "driverless reversal operation button" on the driver console, or else, leave the train and presses "driverless reversal operation button" on platform; train automatically drives to reversal tracks and backs to departure platform, car doors and platform screening doors are automatically opened, the driver moves into the driver cabin and inserts the key.

司机将模式开关设置为&OFF&位置，拔出主控钥匙；等待&列车折返准备好&指示灯点亮后，按压驾驶台上的&无人自动折返按钮&，或者离开列车，按压站台&无人折返按钮&；。列车自动运行到折返轨并回到发车站台，自动打开车门和站台屏蔽门，驾驶司机进入驾驶室，插入钥匙。

More direct, directer ; most direct, directest

径直的，笔直的

Do you know how to use a chain saw?

你知道如何使用链锯吗？