查询词典 pressure

Conditions of the seepage and stress is a dynamic process, and also shows its interaction and interdependence. Owing to the closure of the fracture, the hydraulic gradient and the permeability pressure of the fracture turn large, and also promote the expansion of water cracks, and fissures connectivity increasing. The increase of the crack opening width will result in the increase of the infiltration capacity and seepage flow, and the reduction of seepage pressure. Because of the dynamic dependence of the fracture aperture, pressure and seepage, under certain conditions, changes in fracture aperture can lead to the formation of local water-passage, and the local emission of high pressure water, and thus promotes the formation of the sudden outgush disasters.

结果表明：洞室开挖完成后，在围岩渗流与应力耦合作用下，围岩中裂隙隙宽、裂隙中水压及其渗透流量的变化是一个动态过程，且相互作用与相互依赖；裂隙的闭合使得结构面水力梯度变大，作用在裂缝上的渗透压力增大，促进导水裂缝扩展，裂隙连通性增加；裂缝张开度增大，渗透能力增强，渗流量增大，其渗流压力相应降低；由于围岩中裂隙隙宽、压力和渗流量的动态依赖性，在一定条件下，裂隙隙宽的改变可导致局部水力通道的形成，高压水头从局部涌出，从而促进突水灾害的形成。

Experiment 1: After air injection, pressure inside pressure plethysmograph increasedsharply to peak pressure, then decreased to horizontal pressure and kept no change.

实验1：在空气注入压力型体积描记箱后，描记箱内压力迅速上升至一个高峰，然后下降至一个高于0cmH_2O的基线压，峰压显著高于基线压(P＜0.001)。

Rna - Rns, see "Partitioning of net radiation", for multiple plants the fraction of radiation to each plant is calculated in the radiation section, see "Partitioning of radiation between plants", es is the vapour pressure at saturation, ea is the actual vapour pressure,ρa is air density, cp is the specific heat of air at constant pressure, Lν is the latent heat of vaporisation,Δ is the slope of saturated vapour pressure versus temperature curve,γ is the psychrometer "constant", rs is an "effective" surface resistance and ra is the aerodynamic resistance.

潜在蒸腾量 Etp 根据Monteith(1965)给出的彭曼联合方程形式计算：式中： Rn 为对于蒸腾的有效净辐射量(也就是 Rna - Rns ，见"净辐射划分"-Partitioning of net radiation，对于多重植被，每一株植物的辐射比率的计算见辐射一节的"植物间的辐射划分"Partitioning of radiation between plants)； es 为饱和水气压；ea 为实际水气压；ρa 为空气密度； cp 为常压下的空气比热；Lν为汽化潜热；Δ为与温度曲线饱和水气压关系曲线斜率；γ为干湿球湿度计"常数"；rs 为"有效"表面阻力；ra 为气动阻力。

When the piston in the cylinder-side movement from left to right, the left cylinder cavity as a result of increasing the volume of the left cavity space constant pressure to reduce, when the space left inside the pressure chamber below the pump pressure containers, according to the principle of balance of gas pressure and was pumping the gas container valve 5 after smoke was continuously pumped into the left cavity, at this time is in the process of breathing.

当活塞在气缸内从左端向右端运动时，由于气缸的左腔体积不断增大，左腔空间的压强不断的降低，当左腔空间内的压强低于被抽容器内的压强，根据气体压强平衡的原理，被抽容器内的气体经过吸气阀5不断地被抽进左腔，此时正处于吸气过程。

Recent years, more and more testing data show that for developing oilfield by water injection to keep pressure, when flowing pressure at bottom less than that of saturation pressure, inflow performance curve deflects to pressure axial and appears the maximal point.

近年来，越来越多试井资料证实，注水保持压力开发的油田，当井底流压低于饱和压力后，流入动态曲线向压力轴偏转并出现最大产量点。

Plastic should lower 3 steps, because plastic is a step to add meltresin material to cyclinder , Higher stick of resin material ,higher screwback pressure. Screw speed differs depending on decomposing temperatureof resin material ,Higher screw speed ,Higher trim force of resin,higher cyclinder temperature. Some resin material may decomposes so it setscrew speed in mid-speed such as 45-75%, In plastic step setting screwback pressure is very important, Higher screw back pressure ,higherquality of product screw back pressure make resin structure order, Moldingproduct is beautiful and volume stable. But ,it maybe flow if screw

再复杂的熔胶旋转过程最多不会超过三段，因为熔胶本身就是存在于把胶熔进料筒的过程，如果原料粘度大，熔胶压力则大，但速度则应取决于原料的分解温度，熔胶速度越快，原料中的剪切力则会越大，料管温度则越高，局部原料产生分解的可能性则会越大，故一般熔胶会采用中速为宜，如45%-75%，熔胶同时会碰到一个比较重要的环节，那就是背压的使用，产品精度要求越大，背压的使用则更大，背压可使原料分子间结构更紧密，成型出的产品则尺寸更稳定，外观越好。

The basic parameters of shoe tree production was acquired through testing pressure, impulse pressure, and time in continued pressure in platform and insole pressure system.

其次，通过压力平台和鞋垫压力系统对双脚脚底压力的分布、运动过程中脚底压力、冲量、脚底受力时间的变化进行验证，获得鞋楦生产的基本参数。

The permanent magnets are now mouthed at the exterior of the high-pressure vessel and are no longer in contact with the fluid sample. So this construction of equipment decreases the contamination of each other. Concerning the temperature-control system, the present instrument employs one non-vibrating new technology. In the high pressure systems, a simple and fast high-pressure pump was used to generate hydraulic pressure. This equipment is more easy to control than the literature\'s methods. A digital lock-in amplifier has been used as sinusoidal current function generator and the induced signal detector.

本文对振动丝粘度密度仪在设计方案上进行了大量改进，把磁体从高压容器的内部移植到容器的外部，提高了容器的化学适应性，采用了无振动的恒温新技术，利用了方便快捷的加压方式，极大的方便了实验的进行，减少了实验的工作量，用数字Lock-in锁相放大器作为驱动信号发生器和诱导信号检测器，设备既简单又极大地提高了信号的检测灵敏度。

Methods 2.1 The experiment about changing electricic pressure values into the pulse-taking pressure values of making pressure standars of sphygmograph. Putting 1g、2g、5g、10g、20g、50g、100g、140g weights on the black1 probe and the black2 probe of NX-3 multifunctional sphygmograph ,putting 1g、2g、5g、10g、20g、50g weights on the purple probe of NX-3 multifunctional sphygmograph. Then we noted the the different pressure numerical value when putting none and different weights on the probes to prove the liner relationship between them. 2.2 Setting up wiry pulse model in achy rabbits We operated on the non-drugged state rabbits, exposure the carotid.

2.1 关于电学压力值与实际压力值换算的脉图仪压力定标实验：NX—3 多功能脉图仪黑色探头 1 和黑色探头 2 上放置 1g、2g、5g、10g、20g、50g、100g、140g砝码，NX—3 多功能脉图仪紫色探头放置 1g、2g、5g、10g、20g、50g 砝码分别记录两种脉图仪共三个探头其空载、探头上放置砝码时脉象采集仪上所显示的取脉压力值，验证砝码重与取脉压力值的线性关系。

Cooking, the pot is only one atmospheric pressure of the steam pressure, water boiling point of 100 degrees, while the pressure cooker is different from working pressure is 1.3 kg / square centimeter, the working temperature can reach 124 degrees.

烹煮锅只有一个大气压力的蒸汽压力，水的沸点100度一点，而压力锅是从不同的工作压力为1.3公斤/平方厘米，工作温度可达124度。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。