查询词典 pressure point

Find a relation between the maximum pressure and the pressure at any point · Apply the condition of statical equilibrium to find the actuating force, the torque, and the support reactions.

寻找关系最大压力和压力，在任何一点·申请条件的静力平衡，以寻找驱动力，转矩，及支持的反应。

Starting from the view point of practical application, based on large amount of pressure well logging data home and abroad, the author demonstrated how to distinguish over-pressure formations using wellsite data, through selected methods such as drilling parameters, rock fragment analysis, drilling fluid parameters, and electric well-logging .

本文从现场实用性的角度出发，综合国内外大量压力录井资料，其中，选取了部分常用的压力评价方法，如钻井参数、岩屑分析、钻井液参数、电测井等，对如何利用现场资料来判断超压层进行阐述。

The four properties, vapour pressure lowering, freezing point depression, boiling elevation, and osmotic pressure, are known as the colligative properties of solutions

溶液的这四个特性：蒸汽压下降、凝固点降低，沸点升高和渗透压，称为溶液的依数性。

It was found that increasing pressure for blank can improve the compactedness of blanks so as to make foam aluminium materials with homogeneous pores. Foaming temperature, as one of the main influencing factors on foaming process, should be controlled higher than the melting point of Al or Alalloy to a certain extant in order to keep a reasonable viscosity. Thus, the foam aluminum with homogeneous pores and high porosity is available. As shown by experiments, such materials should be made on conditions that they shall be protected with molten salt under 300?MPa pressure at 675～680?℃.

研究了粉末冶金法制备泡沫铝材料的方法讨论了发泡过程中的保护方式、制坯压力、发泡温度等参数对泡沫铝体积质量、孔隙率、孔结构的影响，并对发泡机理进行了探讨增大制坯压力使得金属坯致密，可以得到孔结构均匀的泡沫铝材料；发泡温度是影响发泡的主要因素之一，发泡温度控制在高于铝或铝合金熔点，同时保持熔体具有一定粘度的范围内，能够得到孔结构均匀、高孔隙率的泡沫铝材料实验结果表明：采用熔盐保护方式，在300MPa的压力下，温度在675～680℃时，可得到孔径均匀、孔隙率高的泡沫铝材料。

In the business card printing and membership card-making, if the pressure can be caused by the students'overloaded, dot gain and text version dilative of dvysocket, 30%~ 40% dot have hollow point business card printing and membership card making serious may occur when the hard mouth phenomenon; plates and roller pressure is too large, the paper--the characters have been (especially small text handwriting) fuzzy edge printing graphics and text, is not clear.

在制卡和会员卡制作洋，若不弛力功重，不离会引起网不背不收不小和笔不朱扩弛糊版，30%~40%网不背有空腹不背，制卡和会员卡制作时会不入现惨重的软口本体等；印版与网纹辊的不弛力太不小，纸背笔迹(尤其是洪不小笔不朱笔迹)暧昧，印品图文边际不澄辉。

In order to clear heterogeneous reservoirs waterflooding performance, and decreased interlayer and within-layer contradictions, and improved the water flooding recovery, experimental study should be conducted first, This paper based on Pucheng Sasan reservoir sandstone cores to study object. Multi-point pressure measurement of water flooding oil experimental apparatus was established. Through the three-layer water flooding experiment to study injection strategy, interlayer interference and recovery factors. True sandstone micro-model water flooding used newly developed color visual image analysis system researched water-drive types, forms of residual oil and waterflood efficiency. Percolation mathematical model was established, black oil simulation program was developed, long-core displacement experimental results were matched, pressure and saturation change were researched by the simulation matching results.

为了明确非均质储层注水开发动态过程，减轻由于层间和层内非均质造成的开发矛盾，提高水驱采收率，本文从实验研究出发，以濮城沙三储层岩心为研究对象，建立了一套带多测压点的多层长岩心水驱油实验装置，通过开展三层水驱油实验，研究注水方式、层间干扰以及采收率影响因素；真实砂岩微观模型水驱油实验采用最新研制的彩色可视化图像分析系统研究水驱类型、残余油形成类型以及水驱油效率；建立并求解渗流数学模型，编制黑油模拟程序，对长岩心驱替实验进行拟合，通过拟合结果研究驱替过程中油水饱和度和压力的变化情况等研究工作。

IAISI HVLP Low Pressure Environmental Friendly Spray Gun atomizes the paint at the lowest point of air pressure during its conversion to decrease the paint bounce and make the effective utilization rate reach as high as 95%,saving 10 to 30% paint compared to those conventional spray guns.

IAISIHVLP环保低压喷漆枪是通过气压转换后所喷射出来的最低压力，来雾化涂料，使涂料减少反弹，涂料的有效利用率会高达95%，比使用常规喷枪节省10-30%，减少对环境的污染，起到有效的环保作用。

At this point easy to increase the temperature regulating valve, brake system pressure gauge shows the pressure enough, regulators Department can hear the sound leakage.

此时调压阀温度易升高，制动系统气压表则显示气压不足，调压阀处可听见漏气声音。

The second step:.add nitrogen gas into the system,check whether pressure gauge changed after 24 hours, if the pressure drops, that means sealed system is not good, need to find out the leakage point and repair welding.

第二步，将封好的系统，冲入氮气封好，饱压24小时，看压力表掉压了没有，如果压力下降，证明制冷系统没有封好，需要找出漏点，进行补焊。

In well completing test for gas wells of Feixianguan Group with high sulphur content, the well test interpretation can't be conducted until the pressure data are calculated with gas column calculating formula because the distance between the pressure testing point and the central part of the formation is too big.

川东北飞仙关组高含硫气藏气井在完井测试过程中，压力测点位置与产层中部的距离较大，需将压力数据用气柱压力计算公式折算后再进行试井分析解释。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。