查询词典 pressure nozzle

Silver Series pumps provide ample water pressure to power: A garden hose with spray nozzle fitted.

银系列水泵提供充足的水压力，以权力：一花园软管与喷头装上。

Moreover, the hot compressive deformation behavior of the RS/PM AZ91 magnesium alloy and AZ91 alloy matrix composite were also investigated, the conclusions are drawn as follows:1. The processing parameters of the atomization-twin rolls quenching technology were optimized as follows: the diameter of the nozzle 1mm, the wheel velocity 25m/s, the pressure of atomization gas 0.3MPa and Ar gas for melt injection 0.1MPa. The RS AZ91 alloy flakes exhibited fine and uniform microstructures. When the flakes were extruded at 673K, extruded velocity of 0.1mm/min and extrusion ratio of 25:1,the magnesium alloy rods with clean surface, uniform dimension and excellent mechanical properties were obtained.2. The RS AZ91 magnesium alloy powders prepared by atomization-twin rolls quenched technology exhibited fine equiaxed grains with the grain size of 1-3μm, the phase constituent included supersaturate solid solution phaseα-Mg and miner fineβ-Mg_(17)Al_(12) phase. The as-extruded materials also exhibited equiaxed grains with the size of 5-7μm and a large number of fineβ-Al_(12)Mg_(17) and fewer AlMg_2Zn phases were detected in the alloy.

本文还研究了快速凝固/粉末冶金AZ91镁合金热压缩变形流变应力行为，快速凝固/粉末冶金法原位生成Mg_2Si增强AZ91镁基复合材料，经过系统的研究，获得如下结论：1、雾化-双辊急冷法在下列工艺参数组合下：双辊线速度25m/s；喷嘴直径1mm；熔体压射压力0.1MPa；雾化气体压力0.3MPa。，可获得宏观尺寸细小、微观组织均匀细小、综合性能优良的的快速凝固AZ91镁合金细碎箔带，快速凝固箔带在挤压温度为673K、挤压速度为0.1mm/min，挤压比为25：1时，可获得的外表光洁、尺寸均匀、组织性能优异的镁合金棒材。2、雾化-双辊急冷法制备的AZ91镁合金粉末态为细小等轴晶组织，晶粒尺寸1-3μm，组织为α-Mg过饱和固溶体和微量的细小β-Mg_(17)Al_(12)相组成；粉末挤压棒材为等轴晶组织，晶粒尺寸5-7μm，组织中含有大量细小的β-Al_(12)Mg_(17)以及AlMg_2Zn析出相，室温力学性能，抗拉强度383MPa，屈服强度275MPa，断后伸长率7.5%。

Pivoting stainless steel spray lance (1050 mm), High-pressure hose 10 m, Dirt Blaster, Triple nozzle with touchless changeover, 0°/25°/40

带10米高压管的伺服引发枪，带发光二极管显示的电机保护系统，1050毫米轴向旋转不锈钢喷枪杆，6升清洁剂箱，润滑油显示窗，大水流量，压力控制开关，凯驰专利高压管防缠绕设计，三孔无接触旋转喷嘴0度/25度/40度，强力旋转喷嘴。

The important result is that a pressure exists on the nozzle base that partially offsets the truncation loss.

重要的结果是一种压力存在于喷嘴基地，部分抵消了截断损失。

If the spring tension on the unloader is set low, pump pressure will be low because water is bypassing the nozzle.

如果减荷器的弹簧张力设置的很低的话，泵压会很低，因为水会通过喷嘴。

The model of the pressure distribution on plug wall was established according to the altitude compensation capability of the plug nozzle.

结果表明，由于塞锥长度的截短所引起的截短损失和底部损失是影响塞式喷管性能的主要因素。

The nozzle water pressure, the bottle washing temperature and the contact time are subject to the standards recommended by the manufacturer of bottle washers.

喷嘴水压、洗瓶温度及接触时间应按照洗瓶机制造商所推荐为标准。

Production and size determination of large size atomic clusters A gas jet of clusters was produced when a high backing pressure rare gas adiabatically expanded into vacuum through a home-made double solenoid pulsed valve and a conic nozzle.

高背压惰性气体经由自行设计研制的双线圈高速脉冲气阀和锥型喷嘴向真空绝热超声膨胀，形成团簇喷流。

The experimental results show that the mean particle size of griseofulvin precipitated by RESS is smaller than 1, 0μm, narrow distribution and 95％ fine particles is smaller than 1. 0μm. Increase of the pre-expansion pressure, the extraction temperature, the expansion chamber temperature, the spraying distance, the concentration of cosolvent and decrease of the nozzle diameter resulted in decrease of the particle size under the operating condition studied. Enhancement of the pre-expansion temperature resulted in increase of the particles size. The SEM of GF shows that the shape of original is atactic and a wide size distribution, but the microparticles obtained by RESS is reverse. Similar melting points and XRD patterns were observed for the original material and the precipitates obtained by RESS.

实验结果表明，用含夹带剂的RESS法制备的灰黄霉素微粒的平均直径在1μm左右，且分布均匀，95％微粒在1μm以下，仅用CO〓作为超临界流体制备的微粒与上述方法制备的微粒的平均直径和分布相似，只是产量太低，而用机械法制备的微粒平均直径在3μm左右且分布较宽；不同的过程参数对沉析微粒尺寸有不同的影响，预膨胀压力、膨胀室温度、溶解温度以及夹带剂浓度的提高或增大，均可使沉析微粒的直径变小；预膨胀温度提高，所得微粒的直径变大；喷射距离的增加，沉析微粒的直径变小；喷嘴直径越小，由此制得的微粒的直径就越小；根据实验结果还可知道，通过理论计算的马赫盘处微粒的直径可以较好地估计出膨胀室中收集到的微粒的直径。

We selected the 2nd and the 3rd generation yeast with powerful vitality from the yeast mud fermented in tanks in working field as the ideal species source separated from yeast monoplast in beer and the ways to obtain them were as follows: 24 hours after deoxidisation of diacetyl to threshold value and decrease of its temperature to 5℃ was the best time for selection and sample－extraction location was at the nozzle of pressure－discharge pipes.

摘 要：从生产现场大罐发酵的酵母泥中选取第2～3代生命力强的酵母作为啤酒酵母单细胞分离的理想种源，选取的最好时间为双乙酰还原至阈值后降温至5℃，并让其停留24h时取样位置为排压酵母的管口，最后将所得菌种进行初选、复选或模拟生产恒温培养鉴定，选出优良菌株。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。