查询词典 pressure nozzle

To accelerate the widespread of Synchronous Chip Seal and improve the operation quality of Synchronous Chipsealer, key techniques which influence the operation quality is studied detailedly, including the control of distributing quality, the dynamics characteristics of hydraulic system and the spray characteristics of asphalt nozzle of Synchronous Chipsealer.1 The factors which influence Synchronous Chip Seal quality are studied. Fiducial probability of simultaneous distribution density is advised to be used in evaluating the distribution bias and standard deviation of asphalt and aggregates simultaneously, which is more advanced than the single index evaluation method used before.2 The volume efficiency formula of asphalt pump is revised after analyzing the data of volume efficiency with mathematical statistics, which is helpful to match the asphalt spray system and control the flow out of asphalt pump accurately. With equation deduction and experiment, dynamic of hydraulic system used in Synchronous Chipsealer is studied, which lay the theory foundation on improving the stability and efficiency from design and controlling.4 Simulation on hydraulic system used in Synchronous Chipsealer is done with AMESim; the results indicate that multi-circle parallel connected hydraulic system with constant pressure power is better than that with load-sensing pressure power at present, because the latter will oscillate when the multi circles work at the same time. This conclusion has been proved during the debug of Synchronous Chipsealer.5 Asphalt nozzle characteristics, such as flat jet shape, flow distribution, are studied with experiment, the results indicate that cross quality of asphalt distributing is not increased linearly follow the increase of fan overlap level, the best point usually exists between two whole overlap level, asphalt distributing quality is better than±4% at the 2.5 overlap level, meets the superior specified in standard; The distribution quality of Synchronous Chipsealer can be increased by spray asphalt of different flow rang with nozzle of different diameter

为了加快同步碎石封层技术的推广，提高同步碎石封层设备的作业质量，本文对同步碎石封层设备作业质量的影响因素与控制方法、液压系统的动力学特性和沥青喷嘴的喷洒特性等关键技术进行了深入细致的研究：1研究了影响同步碎石封层作业质量的因素，提出了采用联合密度分布置信概率对同步碎石封层中沥青洒布量和碎石撒布量的系统偏差和标准差指标进行综合评价的方法，克服了传统评价方法只能对单一指标进行评价的缺陷；2采用数理统计的方法，研究了沥青泵的容积效率特性，修正了沥青泵容积效率公式，为沥青喷洒系统的匹配和沥青泵出口流量的精确控制提供了依据；采用数理方程推导与试验相结合的方法，研究了同步碎石封层设备液压系统的动力学特性，为从设计和控制的角度提高同步碎石封层设备液压系统的稳定性和效率奠定了理论基础；3运用AMESim软件对采用负载敏感控制和恒压控制的两种同步碎石封层设备液压系统进行仿真，结果表明：负载敏感控制的并联液压系统在多回路同时工作时，由于液压泵排量控制参考压力不稳定，容易引发液压系统振荡，恒压控制的并联液压系统是目前技术条件下比较理想的同步碎石封层设备工作装置驱动方案；该结论亦通过同步碎石封层设备装机试验得到了验证。4采用试验的方法对沥青喷嘴的喷洒特性进行了研究，结果表明：沥青洒布的横向精度并不是随着喷洒扇面重叠度的增加线性增加，其最高点通常出现在二个重叠度之间的"半重叠位置"，"2.5重叠"洒布时，沥青的横向洒布精度≤±4%，可以达到国家相关标准中的优级标准；同步碎石封层设备还可以根据不同洒布量情况下的流量需求，采用不同通径的喷嘴进行喷洒，提高沥青洒布精度。

The main production and the fire extinguishers matching accessories: dry powder dusting of assembly, dioxane high-pressure nozzle assembly, dioxane elbow assembly, was clean asbestos, insurance sales, iron leather, Qian Feng, a peg, and Kind of screw joints, all kinds of rubber seals, etc..

主要生产与灭火器配套的消防配件：干粉喷粉管总成，二氧高压喷管总成，二氧弯管总成，无尘石棉被，保险销，铁皮套，铅封，挂具，及各种螺丝接头，各种橡胶密封圈等。

Our company specializes in the production and sale of savings Orifice, nozzle length, the standard nozzle, three curves of the wings, wind measuring devices Venturi, V-cone flowmeter, vortex flowmeter, metal tube rotameter, electromagnetic flowmeter , 1151.3351 differential pressure transmitter, pressure transmitter, multi-channel pressure measurement device, purge devices, anti-samplers, Rosemount transmitter, EJA transmitter and other products the company spirit of "good faith User envisaged "business philosophy, we are bound to quality products, low prices, first-class services to meet your requirements Let us work together hand in hand and a better future. www.wxhtyb.com contact: Shen Yong-gang Mobile: 13921233600 Tel :0510-86023630QQ:

我公司专业生产和销售节流孔板，长径喷嘴，标准喷嘴，三曲线机翼，测风装置文丘里管，V型锥流量计，涡街流量计，金属管转子流量计，电磁流量计，1151.3351差压变送器，压力变送器，多路风压测量装置，吹扫装置，防堵取样器，罗斯蒙特变送器，EJA变送器等产品公司本着"真诚地为用户设想"的经营理念，我们必将优良产品，低廉的价格，一流的服务来满足您的要求让我们一起携手并进，共创美好未来。www.wxhtyb.com联系人：沈勇刚手机：13921233600电话：0510-86023630QQ：

The invention also relates to a nozzle body (31) comprising a nozzle outlet which is disposed on the combustion chamber side end thereof, a nozzle needle (33) which is arranged in an axially displaceable manner and/or which can is actuated in a longitudinal recess (32) of the nozzle body (31); a throttle disk (25) which is arranged between the nozzle body (31) and the control valve (20) and which is closed on the rear end (oriented away from the nozzle outlet) of the longitudinal recess (32). Said throttle disk forms an opening stop for the nozzle needle (33) which co-operates with the rear front surface (orientated away from the nozzle outlet) of the nozzle needle (33) and defines the opening stroke of the nozzle needle (33), and a control chamber (45) formed between the rear nozzle needle front surface and the throttle disk (25), said control chamber being hydraulically connected to a pressure connection (29) which is used to supply fuel.

还设置了：一个喷嘴体(31)，在该喷嘴体的燃烧室侧的端部上构成一个喷嘴出口；一个喷嘴针(33)，该喷嘴针在轴向上可运动或可操作地安置在该喷嘴体(31)的一个纵向开口(32)中；一个封闭该纵向开口(32)的后面的端部的、安置在喷嘴体(31)与控制阀(20)之间的节流盘(25)，该节流盘构成用于该喷嘴针(33)的一个打开止挡，在此与该喷嘴针(33)的后面的端面协同作用并由此限定该喷嘴针(33)的打开行程的边界；和一个在该后面的喷嘴针端面与该节流盘(25)之间构成的控制室(45)，该控制室与一个用于燃料输入的压力接口(29)处于液压连接中。

The nozzle of the gasifier is simplified. The cold-flow field in the gasifier chamber is studied. The research shows that the chamber has recirculation along the whole length. The particles in the chamber perform a very good flowing characteristics even for the large particles of dp=150μm, and no abrupt change is observed. This is due to the operational pressure is high and the density of the gas is large there. The maximal reflux velocity of both phases, the reflux intensity, the concentrational distribution of particles, and the static pressure loss in the chamber are all related to following factors: the load of gasifier, the concentration of coal-water slurry, the diameter of the coal particle, the distribution ratio of oxygen in the two channels of the nozzle, and the angle of jet in nozzle.

本文对水煤浆气化炉喷嘴进行了简化处理，在此基础上，对气化室内的冷态流动过程进行了研究，发现：整个气化室都处于流动的回流区长度范围以内；水煤浆气化炉中，由于操作压力很高，气相密度很大，所以即使对于dp=150μm的较大煤颗粒，其对流体的跟随特性也很好，没有发生流动特性突跃的现象；两相的最大回流速度、回流强度，颗粒相的浓度分布，以及气化室内的静压力损失等，均与气化炉的负荷、水煤浆浓度、煤粒直径、O2在喷嘴两个流道中的分配比例、以及喷嘴的射流角等参数有关。

The research provides an experimental basis for the industrial design of swirl pressure nozzle.

实验结果为旋流压力式雾化器的工业化设计提供了重要的实验依据。

Experimental equipment had been established to research atomization characteristics of a type of pressure nozzle.

建立了雾化实验装置，以甘油-水混合液为介质，研究了一种压力式喷嘴的雾化特性。

GB/T2624--936 and production in line with ISO5167 - 1 standard expenditure devices, including pressure Kok access standard orifice, the standard nozzle, the flange pressure from the standard orifice, the trail from pressure from the standard orifice, the length of the nozzle And Venturi tube and cultural Venturi nozzle, double orifice, eccentric orifice, missing a round orifice, cone-shaped entrance orifice, the first-orifice, Pitot Venturi tubes, nozzles, such as the speed of sound. OVAL Co., Ltd.

生产符合GB/T2624--936和ISO5167--1的标准节流装置；包括角接取压标准孔板、标准喷嘴、法兰取压标准孔板、径距取压标准孔板、长径喷嘴以及文丘里管和文丘里喷嘴、双重孔板、偏心孔板、圆缺孔板、锥形入口孔板、端头孔板、皮托文丘里管、音速喷嘴等。

Arguably, the nozzle to limit position paper, as soon as possible, and it's jitter destroyed the suction nozzle swing movement and the co-ordination of the aliquation valve, causing the pendulum back through the nozzle, the paper could not be immediately spoiledour suction nozzle feed to end just swing pressure wheel has come down upon the relationship between the paper over, resulting in a swayig press paper round has not yet been pressed paper, paper suction nozzle the cardboard in place, and with live paerboard to move back a little bit, causing a pause.

按理说，吸嘴摆到极限场所答当即不收纸，而这种抖不静爱护了吸嘴摆不静不静息与呼气阀的打扰，使得吸嘴往回摆时，未能当即不收纸，爱护了吸嘴送纸到尽脚时摆不静压纸轮恰好压住纸的移交干系，导致摆不静压纸轮还来压住纸，递纸吸嘴不离已把纸板送到位，并带住纸板此后定一下，引起迟滞。

The calculation and experiment results show that the maximum lifting pressure performance decreases with the increase in throat diameter of channel of variable section, water flux of low pressure and pressure ratio of steam nozzle, and has its minimum value with water nozzle annular space. The coefficient of maximum lifting pressure performance may be as high as 26. In the design of steam injector, the larger pressure ratio of steam nozzle and the smaller water nozzle annular space are selected, the higher lifting pressure performance could be obtained.

计算及研究表明：极限升压能力随变截面混合腔喉部直径、被升压的低压水流量和蒸汽喷嘴压比增加而降低，随环形水喷嘴间隙的变化出现了最小值；计算得出变截面超音速汽液两相流装置的极限升压能力可达26；在设计升压装置时应尽可能选取较大的蒸汽喷嘴压比和较小的环形水喷嘴间隙。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。