查询词典 pressure bar

The instruments used ATmega16L onboard A / D converter channels to achieve the cold wind pressure, the hot blast pressure, the furnace top pressure and cold wind current capacity four way analog acquisition;used PWM waveform produced by ATmega16L internal timing / Counter to achieve the entire differential pressure ,the cold wind flow and the permeability index three-way analog output for recording instruments; realized the cold wind pressure, the hot blast pressure, the furnace top pressure, the cold wind current capacity and the entire differential pressure five group parameter tour demonstration and the fixed-point demonstration by key-elect key's coordination during demonstration blast furnace permeable index; produced acousto-optics alarm when the permeable index across the upper and lower limits;used RS-485 realizing the communication with the superior computer.

仪表利用ATmega16L自带的A/D转换通道实现对冷风压力、热风压力、炉顶压力及冷风流量四路模拟信号的采集；通过ATmega16L内部的定时/计数器产生的PWM波形来实现对全压差、冷风流量及透气性指数三路模拟量输出供记录仪表使用；通过键选键的配合在显示高炉透气性指数的同时实现冷风压力、热风压力、炉顶压力、冷风流量及全压差五路参数的巡回显示与定点显示；当高炉透气性指数越上、下限时，仪表产生声光报警信号；仪表采用RS-485与上位机实现通信。

The purpose of our work is that get the target and technique of pressure adjustment through the analysis of formation porous pressure that affects the quality of cementing, regulation of pressure change for infilling wells, technique of pressure dropping for whole block, technique of pressure discharge for high pressure, maintaining pressure in high pressure and lower penetrability formation.

突出的工作在于通过对影响固井质量的地层孔隙压力的分析得出压力剖面调整的目标，通过注水井降压规律、区块整体降压技术、高压层泄压技术、高渗低压层压力保持方法等几个方面研究提出一套压力剖面调整技术。

The basic of laboratory is for measuring and testing pressure. The main equipments of the lab. are I,II grade piston type pressure vacuometer(Difinity:±0.02%,Test range:0.25Mpa-60Mpa),Digital pressure meter,Test system and microwave tube of dynamic pressure sensor, Intelligent digital pressure verifier.The test for micropressure, low pressure, middle pressure and high pressure can be worked out.

本实验室主要进行压力的计量和测试工作，主要设备有一，二等活塞式压力真空计（准确度：± 0.02%，测量范围： 0.25Mpa— 60Mpa）；数字式压力计；动态压力传感器的标定激波管和测试系统；以及智能数字压力校验仪等仪器；可进行微压，低压，中压以及高压测试实验。

"Hydraulic safety valve" is widely used in hydraulic power systems and hydraulic equipment of safety devices, pressure devices can be limited, is a special valve, which is different from the conventional valve, the traditional use of mechanical valves metal spring as a driving force, can only be limited to low pressure, encountered more BALANCING VALVES than 10Mpa pressure limit pressure can do to increase the volume of pressurized design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置，也可以作限压装置，是一种特殊的阀门，它不同于传统的阀门，传统阀门用机械金属弹簧为动力，只能限中低压力，遇到超过10Mpa以上的压力限压，闸阀只能做加大体积的增压设计，因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重，结构复杂，制造难度大，产品成本高；在使用过程中金属弹簧的疲劳变化大使限压参数波动大，要经常调整才能保证正常使用。

"Hydraulic safety valve" is now widely used in hydraulic power systems and hydraulic equipment in the safety device could also serve as limited pressure device, is a special valve, unlike conventional valves, conventional valves with mechanical metal spring as a driving force, can only be limited to low pressure, the pressure encountered over more than 10Mpa limit pressure can do to increase the volume of the Safety Overflow Valve booster design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置，也可以作限压装置，是一种特殊的阀门，它不同于传统的阀门，传统阀门用机械金属弹簧为动力，只能限中低压力，遇到超过10Mpa以上的压力限压，只能做加大体积的增压设计，因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重，结构复杂，制造难度大，产品成本高；在使用过程中金属弹簧的疲劳变化大使限压参数波动大，要经常调整才能保证正常使用。

Measurirg indxes included:(1) Electrocardiograh;(2) Hemodynamics: cardiac output, pump output, aortic pressire, pulmo nary artery pressure, left atrium pressure, right atrium pressure, left ventricular end systolic pressure, left ventricular end diastolic pressure, LV-dp/dt, right ventricul ar end systolic pressure, RV-dp/dt, systolic pressure time index, diastolic pressure time index, endocardial viability ratio;(3) Myocardial metabolism: coronory sinus blood flow, myocardial oxygen consumption, myocardial lactate extractiorn;(4) Ischemic myocardial area;(5) Ultrastructure of myocardium.

测量指标包括：①心电图；②血流动力学：心输出量、泵输出量、主动脉压、肺动脉压、左房压、右房压、左室收缩末压、左室舒张末压、左室压的一阶导数、右室收缩末压、右室压的一阶导数、收缩压力时间指标、舒张压力时间指标、心内膜下心肌供血比率；③心肌代谢；冠状窦血流量、心肌氧耗量、心肌乳酸摄取量；④心肌缺血面积检查及缺血心肌的超微结构观察。

Versions are available for measuring absolute pressure (1.0 to 25 bar), relative pressure (0.5 to 5.0 bar) and differential pressure (0.5 to 5.0 bar).

现可供应用于测量绝对压力（1.0～25巴）、相对压力（0.5～5.0巴）和差压（0.5～5.0巴）的变送器版本。

The steam chest ,vapor separators,preheater and surface condenser are designed and constructed for an internal pressure of 1 bar gauge and full vacuum at 121 ℃ except as follows .the shellside of the first effect chest is designed for an internal pressure of 2 bar gauge and full vacuum at 135℃.the bubeside of the prehearter and surface condenser are designed for an internal pressure of 7 bar gauge and full vacuum at 121℃.the equipment is designed and constructed in accordance with asme.certificates are provided.

蒸发分离室，蒸汽室，预热和冷凝器要设计结构内部能够承压1 bar 和在121 ℃充满真空。一效蒸汽室壳侧要设计成能够承压2 bar 和在135 ℃。预热器的管侧和表面冷凝器设计成7 bar 和在121 ℃。设备的设计和制造要符合ASME。要提供证明。

The hot line that profiled bar factory is Lai steel Inc. produces one of units, have small-sized, medium-sized and large 3 section product line, basically produce product of profiled bar of etc of light-duty series, medium-sized series and profiled bar of large series H, main body equipment is advanced, year productivity 2.4 million tons of above. 2004, h profiled bar passed product certification of Chinese ship's classification society, the mark is worn the pass that profiled bar of Lai steel H had hull to use steel and marine oil platform to use steel. 2006, passed day bid and Europe mark attestation respectively, hold one's head high push forward Japan and Europe.

梗概： 型钢厂是莱钢股份有限公司的热线生产单位之一，拥有小型、中型和大型三条型钢生产线，主要生产轻型系列、中型系列和大型系列H型钢及其他型钢产品，主体设备先进，年生产能力240万吨以上。2004年，H型钢通过了中国船级社产品认证，标志着莱钢H型钢拥有了船体用钢和海洋石油平台用钢的通行证。2006年，分别通过了日标和欧标认证，昂首挺进日本和欧洲。

Now, pyronaridine bar food like the people of Tangshan has become the unique taste, CU Liu pyronaridine root, root pyronaridine braise, deep-fried bar pyronaridine, Jiao pyronaridine slide bar, glass bar pyronaridine, speculation pyronaridine root, root sign pyronaridine son, sweet and sour pyronaridine bar, etc.

现在，咯扎菜肴已经成为唐山人民喜爱的独特美味，醋溜咯扎、烩咯扎、炸咯扎、焦溜咯扎，玻璃咯扎，炒咯扎，咯扎签子、糖醋咯扎等等，据说能做一百多道菜，很有特色，摆在餐桌上，质高形异，色美味香。

Given the language of section 102(2), the Supreme Court's rejection of substantive review under NEPA seems unjustifiable in principle

按照第102条的规定，最高法院否决《国家环境政策法》所规定的实质性复审在原则上似乎是不正当的。

ObjectiveTo explore the effect of variable hip abduction orthosis on children spastic cerebral palsy.

目的探讨髋关节矫形器在儿童痉挛型脑性瘫痪康复中的作用。