查询词典 pressure accumulator

The research results show that the steam inlet pressure and water inlet temperature are the main factors which affect the lifting-pressure performance; the steam injector have the characteristics of self-adaptive outlet pressure and constant outlet flow rate; the theoretical maximum lifting-pressure coefficient calculated could be high as 14 and the experimental value is 3.0, which could be high as 1.5 even if the water inlet temperature is high as 95℃. The noise of steam injector could be induced from 80db to 50db.

研究出该升压技术具有定流量特性、出口压力具有自适应特性，计算得出的理论极限升压能力的升压系数可达14，实验得出的最大升压能力为进口蒸汽压力的3倍，进口水温达到95℃时其升压能力还可达到1.5倍，噪音从目前的80db减少为50db。

Selection of safety valve Decided by the operating pressure safety valve nominal pressure, the decision by the operating temperature range of temperature safety valve from the computed value of the decision constant pressure safety valve spring or a lever set pressure range, then the safety valve according to the decision to use media materials and structure type, and then calculated according to the safety valve Discharge valve throat diameter.

安全阀的选用由操作压力决定安全阀的公称压力，由操作温度决定安全阀的使用温度范围，由计算出的安全阀的定压值决定弹簧或杠杆的定压范围，再根据使用介质决定安全阀的材质和结构型式，再根据安全阀泄放量计算出安全阀的喉径。

The main product categories: PEM standard parts: pressure riveting nut; pressure riveting nut column (SO, SOO, BSO-type); insert nut; pressure rivets; pressure riveting screw ; floating nut; Squeeze Nut; grounding nut column; spring screws; positioning shoring holders; positioning pin and so on.

主要产品种类： PEM标准件：压铆螺母；压铆螺母柱（SO、SOO、BSO类）；镶螺母；压铆钉；压铆螺钉；浮动螺母；挤压螺母；接地螺母柱；弹簧螺丝；定位持撑柱；定位销等。

Main products: Pressure riveting screw, nut riveting pressure, pressure riveting nut -, Inserts into the nut, rose riveting nut, floating nut, ground-nuts, nut-squeezing, Spring screws, self-locking nut, positioning support columns, targeted marketing, sales support cards, in spring, the combination of screws, rivets hollow, as well as various Pressure riveting type of plastic fasteners, etc.!

主要产品有：压铆螺钉，压铆螺母，压铆螺母柱，镶入螺母，涨铆螺母，浮动螺母，接地螺母柱，挤压螺母柱，弹簧螺钉，自锁螺母，定位支撑柱，定位销，支撑卡柱弹簧销，组合螺钉，空心铆钉，以及各种塑料压铆类紧固件等！

When the external control pressure increases to the shutoff pressure setting point of the valve, the external control pressure acting on the underside of the diaphragm, which breaks the balance of the compression of the pressure spring and the latch lever, triggers the latch and disengages valve disc arm from the latch.

当外接控制感应压力﹝即减压下游压力﹞升到此阀关断压设定点时，控制压作用于皮膜下层破坏压力弹簧压缩与闩杆间的平衡，然后扳开闩扣并从闩扣释放阀门封盘。

Then the influence of flow, pipe length, setting pressure of relief valve and stiffness coefficient of main valve spring on the water hammer peak pressure at the instant of fuel pistol closing was studied according to the detected pressure signals. Finally, the relatively accurate gas-liquid separation value and critical cavitation pressure value of the system was obtained by frequency analysis and wavelet analysis.

根据测得的压力信号，对燃料枪关闭瞬间流量、管长、溢流阀调定压力以及主阀弹簧刚度对水击效应引起的峰值压力的影响进行研究，并通过频率分析方法和小波分析方法较精确地获得系统的气液分离值和临界汽蚀压力点。

Turn it back on and set the box cover at the right, and then set the pumb output tubes and machine into the tubing connected, and then on the machine: the pumb work grow up immediately, and mold hold its output tube is also apparent from inside the pent up spilling in output occurred at both the reliability and vibration grow up; then view the instructions in the oil pressure table has been rising "" 0 to "" 5, at the same time, pressure relay (and by keeping the switchboard AC closing in — from its contact outgoing voltage) order lubrication solenoid valve work of fuel, oil pressure decreased and quickly rose to require lubrication with pressure-a solenoid valve, so self-repeating.

重陈不兵其拧不松并不兵盒盖上好，再不兵油泵输入惯与机械的不退油惯接开，然后试机：油泵处事的声音当即变不小了，且用手捏握其输入惯也暗显感触边面流油的鼓胀度和震不不静度均变不小了；再不雅油压外洋的辅导已由&0&逐步上降到了&5&，与此同时，不张力继电器不不静息（并开功使配电柜内互换隔绝器呼分——由其触不面传不入电压）令润滑电磁阀处事——放油，油压回降后又迅不缓上降至规矩不张力后再令润滑电磁阀放油，如此轮回来往。

Fluidization and Sounding Pressure Characters Experimental Research on Pulsating Fluidized Bed After verifying experimentally the Rijke type self-exciting pulsating fluidized bed combustion, under different operating conditions (different empty cross-section wind speed and inaction bed height), experimental research the oscillation characters of sounding pressure in the pulsating fluidized bed. The results indicate that the sound characters in the Rijke type self-exciting pulsating fluidized bed combustor are the same with it in the Rijke type combustor, the pressure in the combustor oscillate up and down in the sinusoidal manner and the pressure is the superposition of the multiple harmonic waves.

脉动流化床流化与声学压力特性实验研究在实验验证了Rijke型自激脉动流化燃烧概念后，在不同运行条件(空截面风速、静止床层高度)下，实验研究了Rijke型自激式脉动流化床的声压振动特性，研究结果表明：脉动流化床内建立起的声波特性和Rijke型脉动燃烧器内的一样，各点压力呈正弦规律上下振动，且压力是基波幅值最大的多次谐波的叠加。

At initial time the core is saturated by oil or water,and put the core into a sample holder with two pressure transducers at ends;Then make the core in a high pressure condition and shut-in the ends of holder;After the pressure of core is steady,open one end of holder to one certain pressure,in the same time, measure the pressurd of sealed end,until attain to another balance state.

设计实验方法为：初始时刻，将岩心在高压下饱和原油，在一端封闭，并装入测压计，待系统压力平衡且稳定后，将岩心另一端放空至某一压力值，连续测量封闭端压力变化，直至系统达到稳定状态。

Turbines are equipped with safety devices for pressure,live steam pressure,extraction steam pressure vacuum,axial displacement of rotor,and the monitoring devices for speed,vibration,temperation,pressure etc.

本设计对凝汽式汽轮机调节系统的选用﹑原理进行了研究，选择了电液调节系统，介绍了其工作原理，完成各部件设计，配汽采用喷嘴调节法。调节气阀的启闭由油动机通过横梁﹑两阀杆和杠杆系统进行控制。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"