查询词典 prepared

With the cross and not fire-resistant fire retardant particleboard prepared study time: increase can be swelling of the particleboard prepared than not prepared Expandable Graphite particleboard longer fire resistance.

同过与不加阻燃剂制备的刨花板耐火时间的研究得出：加可膨胀制备的刨花板比不加可膨胀石墨制备的刨花板的耐火时间要长。

It is that:(1) the related compounds in Metronidazole Buccal Tablets prepared by Chongqing Medical College can be tested by determining (321nm) the total peak area of the impurities;(2) The related compounds in Metronidazole Disodium Phosphate for Injection prepared by Chongqing Medical College can be test by determining (254nm) the total peak area of the impurities and the peak area of the largest impurity;(3) Ceftriaxone polymer in Ceftriaxone Sodium for Injection prepared by Chongqing Keru Pharmacy Co.

结果如下：①用HPLC一UV法，在321nm处检测，用归一化法计算，控制各杂质峰面积的和，可检查重庆医科大学的注射用甲硝吟磷酸二钠中的有关物质：②用HPLC一UV法，在254nm处检测，控制杂质峰面积的和及控制最大杂质峰面积，可对重庆科瑞制药股份有限公司的注射用头饱曲松钠中的有关物质实施控制；③用HPLC一Uv法，在254nm处检测，按外标法计算，可检查注射用头抱曲松钠中的聚合物；④用紫外分光光度法，在277nm波长处测定吸收度，按C6H9N303的吸收系数为377计算每片标示百分含量，可测定重庆医科大学的甲硝哇口颊片的含量均匀度；⑤用紫外分光光度法，在277run波长处分别测定释放溶液20min、50min和90min的吸收度，按甲硝哇(C6H剥303)的吸收系数为377计算释放度，可检查重庆医科大学的甲硝哇口颊片的释放度。

The research indicates that:(1) detecting λmax (277nm) can identify Metronidazole Buccal Tablets prepared by Chongqing Medical College;(2) detecting λmax (321nm) and λmin (265nm) can identify Metronidazole Disodium Phosphate for Injection prepared by Chongqing Medical College;(3) detecting tr (6.7min) in HPLC-UV spectrum can identify Ceftriaxone Sodium for Injection prepared by Chongqing Keru Pharmacy Co.;(4) detecting tR (10.2min) 6.7min in HPLC-UV spectrum can identify Clarithromycin Tablets prepared by Harebin Yida Pharmacy Co.;(5) detecting λmax (254nm) can identify Potassium Sodium Dehydroandroan Drographolide Succinate prepared by Hong Kong Yaohen Co..

结果表明：①测定紫外最大吸收波长λ_(max277nm可鉴别重庆医科大学医药研究所制备的甲硝唑口颊片；②测定紫外最大吸收波长λ_(max321nm和最小吸收波长λ_(min265nm可鉴别重庆医科大学医药研究所制备的注射用甲硝唑磷酸二钠；③测定HPLC-UV中的保留时间(t_R6.7min)可鉴别重庆科瑞制药股份有限公司制备的注射用头孢曲松钠；④测定高效液相色谱的保留时间(t_R10.2min)可鉴别哈尔滨伊达制药厂提供的克拉霉素片；⑤测定紫外最大吸收波长(又max254nm)可鉴别香港耀恒公司提供的炎琉宁。

The annual report must be prepared and published within four months after the end of each accounting year; the half-yearly report must be prepared and published within two months after the end of the first half of each accounting year; and the quarterly report shall be prepared and published within one month after the end of each accounting year's third and ninth months.

年度报告应当在每个会计年度结束之日起4 个月内，中期报告应当在每个会计年度的上半年结束之日起2 个月内，季度报告应当在每个会计年度第3 个月、第9 个月结束后的1 个月内编制完成并披露。

In the prepared process, 1,8- dihydric anthraquinone and 2,3,5,4-tetrahydroxystilbene-2- O-3 -D-glucoside were chosen as detected targets, the quality of 4 prepared method, high pressure steamed method, prepared method with beans, prepared method with ginger, prepared method with yellow wine, was compared.

以1，8-二羟基蒽醌和二苯乙烯甙作为检测指标，对黑豆炮制法、姜制法、酒制法和高压清蒸法四种方法进行比较，发现高压清蒸法得到的产品中游离态蒽醌和二苯乙烯甙含量最高，分别是其它三种炮制品的1.78～1.84倍和1.06～1.61倍。

To precompile or "prepare" a view, set the Prepared property on the view to true.

要预先编辑或资料集，可将资料集中 Prepared 属性设为&真&。

Gelatinized corn starch was prepared by a co-rotating twin-screw extruder,and through drying and comminuting process. Thermoplastic starch was prepared with the gelatinized corn starch powder as raw material and glycerol and Polyvinyl Alcohol as plasticizing agents. Thermoplastic starch sheet was prepared with extruding process. Degree of gelatinization was tested by a polarizing microscope. Mechanical properties of prepared thermal plastic starch sheets were studied in relating to type and amount of the plasticizing agents.

利用双螺杆挤出机对玉米淀粉进行糊化处理，经干燥、粉碎后制得预糊化淀粉，以其为原料，添加甘油，PVA为增塑剂制备热塑性淀粉，经模压制备片材后，通过偏光显微镜分析了淀粉的糊化情况，研究了甘油含量和PVA含量变化对材料性能的影响。

On the basis of literature search on erosion of axial flow fan's blade, depending on the failure mechanisms, several kinds of coatings were prepared. NiWC35, Ni60, SNi46 and SNi67 spraying and fuzing coatings were prepared by spraying and fuzing. Cermet composite coating of LX88A was prepared by arc spraying. Cermet composite coatings of conventional WC/12Co and nanostructured WC/12Co were prepared by HVOF.

本文在综合国内外关于轴流式引风机叶片冲蚀领域的研究文献的基础上，以冲蚀机理为依据，采用火焰喷熔工艺制备了NiWC35、Ni60、SNi46和SNi67喷熔层，采用电弧喷涂工艺制备了LX88A金属陶瓷复合涂层，采用HVOF工艺制备出微米WC/12Co和纳米WC/12Co金属陶瓷复合涂层。

Prepared by Tom Sheeran Drill string Drill bit The hoisting equipment consists of: a crown block, a traveling block, drilling line, and a drawworks to pull the drilling line up or down.

Prepared by Tom Sheeran 钻柱钻头起重设备由以下部分组成：天车，游动滑车，游动钢丝绳，和一个用来起降游动钢丝绳的绞车。

The following main results are obtained: The TiO_2 photocatalyst with small crystallite size, high surface area, narrow and uniform pore size distribution, and microporous frameworks could be prepared out by applying MW radiation in the preparation process. The microwave-induced fluorescence technique verified for the first time that microwave enhanced the formation rate of hydroxyl radical, leading to the increase in the photocatalytic efficiency. Compared with the conventional catalyst, TiO_2 prepared by MW dielectric heating owns a higher UV absorption ability, and its optical absorption edge and photovoltaic response are shifted toward the short wavelength region, resulting in increase of photooxidation efficiency. The photocatalytic conversion and the mineralization ratio of acetaldehyde are increased respectively by 30% and 40% over the TiO2 prepared by MW radiation when compared to the TiO2 prepared by the conventional heating. For the MW-assisted photocatalytic reaction over the MW-prepared TiO2, production of hydroxyl radicals is enhanced by 22.5%, and the photocatalytic conversion is accordingly increased by 20%. Similarlly, applying MW also increased the photocatalytic conversion and the mineralization ratio of acetaldehyde over TiO2/Al2O3 sample.

论文得到如下主要结果和结论：(1)微波介电加热TiO_2 溶胶可得到晶粒度小、光催化活性高、比表面积大和孔径分布窄而均一，且微孔发达的TiO_2光催化剂；在溶胶干燥处理过程中微波可使催化剂表面缺陷增加，进而导致光催化反应过程有更多的活性羟基自由基产生；(2)微波制备能显著增强TiO_2 样品的紫外光吸收率，并使其光吸收和光伏响应阈值发生蓝移，从而提高TiO_2的氧化还原能力；(3)与常规加热法所制TiO_2比较，微波法制备的TiO_2对乙醛的光催化降解转化率提高30%，CO_2生成率提高40%以上；(4)与未加微波辐射时相比，发现在光催化反应过程中施加微波，TiO_2 的羟基自由基生成速率提高了22.5%，相应CH_3CHO 光催化降解转化率提高了20%；对Al_2O_3/TiO_2催化剂，CH_3CHO 光催化降解转化率甚至提高了33%，同时CO_2 的生成率也都大幅度提高；(5)微波辐射可改变光催化降解乙醛的产物分布，推断施加微波时乙醛光催化降解按照羟基自由基引发的链式反应机理进行，微波&非热效应&起主要作用。

By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.

到它被攻陷的时候，里面多数的犯人是写了反对政府贪污文章的作家。

The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.

在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色，卵在发育96h后卵基本全部孵化。