查询词典 preheating pot

We should use the tempilstick to check the temperature for the preheating of the interlamination away from the soldering seam less than 75mm.

预热和层间温度都应用测温笔在离开焊缝不小于75mm 的地方进行检查。

The relation between the irradiator and the distribution of temperature field, heating efficiency in the preheating process was obtained.

在此基础上建立了预热过程中粉床温度场的三维解析数学模型，并利用该模型采用MATLAB软件对管式和板式预热装置下的粉床受热情况进行了数值模拟。

The forming mechanism and influence factors of elephant skin were discussed based on journal box body, and some critical influence factors such as the preheating temperature of mold, forming pressure etc.

以轴箱体零件为例，探讨了皱纹缺陷的形成机理，分析了其影响因素。理论分析表明：模具预热温度、成形比压是影响铸件质量的关键因素。

Preheating roasts the plate 3 minutes with the high fire, puts in an earth department, puts a piece of midheaven earth department again, hits the egg in the vacancy, after covering ham, covers again by the earth department, roasts for 40 seconds by Gao Huo, turns hostile roasts again for 40 seconds, takes out, turns hostile again the earth department, lifts the above earth department, joins the tomato piece, the fresh vegetable leaf, Hu Jiaoyan and the ketchup, to cuts chargging then.

用高火预热烤盘3分钟，放入一片土司，再放上一片中空土司，打蛋于中空处，盖上一片火腿后，再以土司覆盖，以高火烤40秒，翻面再烤40秒，取出，将土司再翻面，掀开最上面的土司，加入番茄片、生菜叶、胡椒盐和番茄酱，对切装盘即可。

The article studied on processing technology of tomato beverage using tomato as material, they did experiment aim to increase juice yield , stability of the beverge and to keep colour. The results indicated juice yield is able to reach 81.5% after preheating, adding pectase , pressure filtering, the processing technology improved the utilization of tomato.

以番茄为原料进行饮料的加工，针对提高番茄出汁率、饮料稳定性、饮料色泽的保持工艺研究实验，结果发现，对番茄预热后，再加果胶酶处理、加压过滤工艺可使番茄的出汁率达到81.5%，提高了番茄的利用率；番茄饮料中添加2‰，质量比5：2：3的羧甲基纤维素钠、黄原胶、琼脂复配增稠剂可使饮料在常温保存三个月仍具有良好的稳定性。

In order to improve the penetrability of sintering feed, the steam was used for preheating sintering feed.

为改善料层透气性，利用蒸汽对烧结混合料进行预热。

Study results show that the thermal transmission characteristic of the radiation recuperator is variable during the heat treating process,and the average preheating temperature of air is not capable of achieving the rated design value of the recuperator.

结果表明，燃气辐射换热器的传热特性在整个热处理过程中是不断变化的，空气平均预热温度并不能达到换热器的额定设计值，故在周期式热处理炉上使用辐射换热器并不完全合适。

This paper introduces the major equipment of the polysilicon reducing furnace electrical system ,and emphasizes the working prin-ciples of preheating voltage regulator and reducing voltage regulator.

介绍了多晶硅还原炉电气系统的主要设备，着重分析了预热调压器和还原调压器的工作原理，并且提出了一种新型的还原调压器设计思想，减少了谐波含量，提高了功率因数。

Full sirocco preheating system, 3-segment:3-segment heating distributed evenly, soldering paste dregs will discharge out with hot air;Do not damage PCB and original parts, good effect to all kinds products.

全热风预热系统、三段式：三段预热分部均匀，助焊剂雾化残流会热风排出机外：不伤害PCB及原器件，针对各种产品有较好的效果。

The experimental results show that shortening of updraft drying time and prolonging of Preheating time will increase the output and compression strength of pellets.

试验结果表明，缩短鼓风干燥时间，延长预热时间和提高气流流速有利于较快提高料层温度，从而提高球团抗压强度和产量。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48