查询词典 preheated

The results show that the decalescence of catalyst bed affects the process of hydrogen peroxide catalytic decomposition greatly. If the catalyst bed is preheated or made up of materials with low thermal conductivity, that influence can be depressed. At the same time, the response characteristic of catalyst bed and the efficiency of catalytic decomposition can be improved. The low frequency pressure instability of catalyst bed occurs because of the coupling of catalytic decomposition and supplying. The decomposition plane pushes all the way through the catalyst bed during pressure oscillations, causing unreacted liquid hydrogen peroxide to be exhausted from the bed and leading to the appearance of liquid hydrogen peroxide channeling. Consequently, how to prevent or at least limit this channeling is the key to eliminate the pressure instability of catalyst bed. It was found that adding clapboard to the catalyst bed can depress the pressure instability efficiently.

结果表明催化剂床及催化剂的吸热对过氧化氢分解过程影响很大，对催化剂床进行预热或采用热导率低的材料制造催化剂床等措施，可以降低催化剂床壁面吸热对催化分解过程的影响，提高催化剂床的响应特性和催化分解效率；催化剂床的低频不稳定是催化分解过程与供应系统耦合产生的，催化剂床气体界面的波动过程中，液体过氧化氢穿透催化剂床形成过氧化氢液体通道，过氧化氢液体通道的产生和扩大是催化剂床不稳定的主要原因，也是消除催化剂床不稳定的关键，试验中在催化剂床内加入分流板成功地抑制了催化剂床的低频不稳定。

When using filo, be sure you have all the ingredients handy and the oven preheated.

使用filo前，确保你已经做好所有材料，烤箱也已准备好。

Make sure that your griddle or frying pan is preheated to the highest temperature before you cook your steaks.

一定要保证你用的那个锅在做牛排前已经预热到最高温度了。

Preheat your pan Make sure that your griddle or frying pan is preheated to the highest temperature before you cook your steaks.

预热你的锅一定要保证你用的那个锅在做牛排前已经预热到最高温度了。

ADD ALL HARDENER TO THE PREHEATED CHOCKING COMPOUND AND POWER MIX AT APPROX. 300-500 RPM FOR 2-3 MIN.

5.6-7 将所有的硬化剂加入到树脂中并用转速为300-500转/分钟的搅拌电钻进行混合2-3分钟。

The results of thermal balance calculation show that if the combustion air can be preheated to 600℃ by the self-preheating process and the gas can be preheated to 150℃ approximately by recovering waste heat of hot stoves flue gas, then the hot blast temperature of 1200℃ could be obtained. 4. The development of mathematical models on the heat transfer of chamber in hot blast stoves is briefly reviewed and the Hausen's mathematical model and its solution methods are mainly discussed.

对自身预热热风炉在一个工作周期内燃烧和传热过程的设计计算程序和应用公式进行了计算方法的研究，首次提出了一套新的热工计算方法，并以采用自身预热的大型高炉热风炉为例，进行了分析、比较和验证。

A preparation method of nickel oxide-base cathode of fused carbonate fuel cell is to select alkali earth metal oxide, transition metal oxide and rare-earth metal oxide, mix with carbonyl nickel powder in the proportion of 0.01-15.00 mol%, add assistant and mix even into a slurry; after the slurry is formed into a biscuit by doctor-blade casting, sinter it into a multi-porous nickel plate; dissolve lithium nitrate and cobaltous nitrate with mole ratio of Li:Co-1:1 and citric acid or PVA in the distilled water to make a solution with Li of 0.00-0.5 mol/L; immerse the multi-porous nickel plate or nickel oxide plate in the solution, keep for 10-60 minutes under vacuum below 200 millibar, then dry in an oven at 75 degrees centigrade further transfer to a crucible electric furnace preheated 650 degrees centigrade for keeping the temp.

要約 熔融碳酸盐燃料电池氧化镍基阴极的制备方法属于燃料电池领域。选取碱土金属氧化物、过渡金属氧化物和稀土金属氧化物，按0.01－15.00mol％的比例与羰基镍粉混合，加入助剂，混合均匀成浆料；混合浆料流延成型为素坯后烧结为多孔金属镍板；将摩尔比为Li∶Co＝1∶1的硝酸锂和硝酸钴以及柠檬酸或聚乙烯醇溶于蒸馏水中，制成为0.005－0.5mol/L的溶液；将多孔金属镍板或氧化镍板浸入溶液中，在真空度低于200毫巴下保持10－60分钟；置于75℃的烘箱中烘干，转移至预热到650℃坩埚电炉中保温1－10小时；将此过程重复一次或多次即可。

After a glass plate is preheated, the glass plate is heated to the transition temperature of the glass.

玻璃板预热后，将该玻璃板加热至玻璃的转变温度。

LiBOB was synthesized by an improved solid-state method. H2C2O42H2O was dehydrated to get anhydrous H2C2O4, and H2C2O42H2O was mortared with LiOHH2O. The mixture of H2C2O4 and LiOHH2O was preheated at 60 ℃ for 2 h before adding H3BO3 in several times to be mortared. In vacuum dryer, the mixture of the three starting materials was preheated in two steps: at 70 ℃ for 6 h and then at 100 ℃ for 3 h.

用改进的固相法合成一种新型电解质锂盐－双乙二酸硼酸锂：首先将脱去结晶水的H2C2O4与LiOHH2O研磨混匀，在60 ℃预热2 h后分批加入H3BO3，然后，于真空条件下在70 ℃和100 ℃分别保温6 h和3 h，得到LiBOB粗产品。

LiBOB was synthesized by an improved solid-state method. H2C2O4·2H2O was dehydrated to get anhydrous H2C2O4, and H2C2O4·2H2O was mortared with LiOH·H2O. The mixture of H2C2O4 and LiOH·H2O was preheated at 60 ℃ for 2 h before adding H3BO3 in several times to be mortared. In vacuum dryer, the mixture of the three starting materials was preheated in two steps: at 70 ℃ for 6 h and then at 100 ℃ for 3 h.

摘 要：用改进的固相法合成一种新型电解质锂盐——双乙二酸硼酸锂：首先将脱去结晶水的H2C2O4与LiOH·H2O研磨混匀，在60 ℃预热2 h后分批加入H3BO3，然后，于真空条件下在70 ℃和100 ℃分别保温6 h和3 h，得到LiBOB粗产品。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新