查询词典 precursor

It was found that because of the difference in component distribution and structure, the tendency that pores furcate and bend was smaller in amorphous precursor than in crystalline precursor, and for the amorphous precursor, the velocity of Al leaching-out and the expanding of specific surface area of catalyst were more sensitive to activation process parameters.

结果发现，由于两者在组元的分布及结构上的差异，非晶态前置体合金在活化过程中形成的微孔发生弯折、分叉的倾向要小于晶态前置体合金，同时前者在活化过程中的抽Al速率、以及所得到的催化剂的比表面积等对活化工艺更为敏感。

A pair of primers that contained flanking hydropathic amino acid codons were synthesized, to amply the sequence coding for 10~34 aa in the precursor sequence. The amplified fragment was inserted into pRSET-A to generate the first double repeat of the precursor gene. By utilizing a pair of isocaudamer BamH I and Bgl II sites, and another downstream Hind III site of plasmid pRSET-A, following a series of simple double digestions and ligation of the resulted products, a series of repeat (3, 4 and 6) precursor peptide fragment genes were derived.

本实验设计一对两侧含编码疏水性氨基酸密码子的引物，经过扩增前导序列10~34aa基因序列，并重新克隆入质粒pRSET-A构建串联二聚体后，再利用质粒pRSET-A的BamH I / Bgl II同尾酶克隆位点，经一系列简单的酶切和连接，快速构建这一前导肽中不含组氨酸标签序列的串联多聚体基因，并成功表达其六聚体重组蛋白。

The comparative investigation of the characteristics of deformation and AE were conducted and the results are presented as followed: 1. The characteristics of rock AE are correlated to the strength, joints, cracks, and the size and hardness of crystalline grain. 2. The sequence of AE can be divided into four phases: beginning phase, tempestuousness phase, drop phase and dreariness phase. The loss and the duration of the phases are correlated to the rock character and flaws in the rock. 3. The AE rate characteristics are not almost concordant with the AE energy rate. 4. Besides the homogeneity, the strength of rock contributes the activity of AE. The higher the strength is, the lower the activity is. 5. There is a dreariness phase before the failure of most kinds of rock. 6. Whether the precursor is obvious is correlated to rock the character, and the precursor of AE rate is more apparent than the precursor of AE energy rate comparatively.

通过对比研究这六种不同岩石的变形和声发射特征发现，岩石声发射受到岩石强度、节理裂隙和晶粒软硬大小等的影响；岩石声发射过程存在初始区、剧烈区、下降区和沉寂区，各个阶段是否存在及持续时间与岩石强度、内部缺陷等有关；岩石的声发射事件率特征与能量率特征并不完全一致；岩石的声发射活性除了受其均匀性影响外，还受到岩石的强度影响，强度越小，声发射活性越强；大多数岩石破坏前存在一声发射沉寂区；岩石的破坏前兆是否明显跟岩性有关，相比较而言，岩石破坏时的声发射率前兆比声发射能量率前兆更为明显一些。

The results indicate that polyborazine precursor prepared at 150℃ for 10 h and propylamine/isopropylamine molar ratio 2:1, could possess nearly linear molecule skeleton and he prone to melt spinnability. When melt at 90℃, the precursor fibers are prepared with average diameter 10-20μm and BC1.27 N1.52 H structure. After curing process and sintered in NH3 at 1200℃, the near-stoichiometric BN fibers was obtained, which proved this precursor is apt for preparation of BN fibers.

结果表明，当正丙胺／异丙胺摩尔比为2：1，聚合温度为150℃，反应时间为10h时，合成产物具有近似线性分子结构，熔点为90℃，具有良好的成丝性，可获得平均直径10~20μm，组成为BC1.27N1.52H的先驱体纤维，先驱体纤维再经不熔化处理及1200℃氨气高温锻烧等工艺可获得近化学计量比的氮化硼纤维。

The method is as follows: n-butyl titanate, absolute ethyl alcohol, surfactant and concentrated hydrochloric acid are fully mixed and stirred for 4 to 6 hours under room temperature to obtain precursor solution, then the precursor solution is spinningly coated on a clean conductive glass substrate of an indium oxide tin coating, and then the conductive glass spinningly coated with the precursor solution is preserved for 25 to 72 hours at the temperature of between 20 and 30 DEG C and the relative humidity of between 50 and 75 percent below, and finally undergoes a high-temperature calcination at the temperature of between 350 and 700 DEG C.

将钛酸正丁酯，无水乙醇，表面活性剂和浓盐酸充分混合，在室温下搅拌4小时-6小时得到前驱剂，然后将前驱剂旋涂在清洁的氧化铟锡镀层的导电玻璃基底上，接着在20℃-30℃，相对湿度在50％-75％下，将旋涂有前驱剂的导电玻璃保存24小时-72小时，最后经过350℃-700℃高温煅烧。

At first, the difference of the iron chloride and iron nitrate precursor was studied. By the photoelectrochemical results, the film prepared by iron chloride precursor showed better photoelectrochemical response than the film prepared by iron nitrate precursor, and the reasons were discussed.

研究中首先比较使用氯化铁前驱液与硝酸铁前驱液所制备出的氧化铁薄膜的差异，由实验结果知道，使用氯化铁前驱液的薄膜，其光电化学表现比使用硝酸铁前驱液的薄膜来得好，而研究中也探讨了其可能的原因。

Precursor LiMgxMn2-xO4 is prepared by the method of phase transfer, and then the precursor is sintered in the air astrosphere at a certain temperature for a certain time to get cathode material for lithium ion battery.

利用相转移法合成了LiMgxMn2-xO4前驱体，在电炉中于一定温度下烧结一定时间，得到锂离子电池正极材料粉体，并利用XRD、SEM、IR等对材料粉体进行结构形态表征。

So, the smaller precursor and product were obtained. When decomposed into ceria particles, the precursor burst apart from～510nm to～300nm because of the gas come into being and expand.

在煅烧分解过程中，前驱物分解为二氧化铈粉末，由于气体的产生、膨胀使前驱物崩裂，发生崩裂及抽空行为，颗粒度由前驱物的～510nm变为产物的～300nm。

SMM is the main precursor substance of DMS, and Cystine is one of the precursor substances of DMS in vegetables.

硫甲基蛋氨酸是蔬菜中甲硫醚主要的前体物质，胱氨酸是蔬菜中甲硫醚的前体物质之一。

First, the precursor polymer with azobenzene groups on main-chain was obtained by condensation polymerization between 4,4'-dihydroxyazobenzene and N,N-(2-bromoethyl)aniline through Williamson reaction. Then the azo polymer containing azobenzene groups both on main-chain and side-chain was prepared through an azo-coupling reaction between the precursor polymer and the diazonium salt of 4-nitroaniline.

设计并合成了一种新型的主侧链均含偶氮生色团的聚合物，首先通过4，4'-二羟基偶氮苯与N，N-二溴乙基苯胺之间的Williamson反应缩聚得到主链含偶氮苯基团的先驱聚合物，再通过重氮偶合反应得到目标产物，并利用核磁共振、红外光谱、紫外可见光谱、热分析等手段确认了所制备聚合物的结构。

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是，这是不可能的，只要是搞市场经济，是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。