查询词典 power steering

There are several manual steering gears in current use like the rack and pinion type ,the worm and tapered pin steering gear ,and the worm and roller steering gear.

目前使用的手动转向齿轮机构就是有好几种，如齿条齿轮式转向机构、蜗杆斜销式转向机构以及蜗轮滚柱式转向机构。

In this dissertation, according to the theory of Mechanical Dynamics and Multi-body Dynamics, a simulation model of NJ2046 light off-road vehicle including suspension system, steering system and tires is built with the software CarSim and so the vehicle steering characteristics are analyzed with the step angle input of steering wheel.

摘要本文根据机械系统动力学、多体动力学理论，运用动力学仿真软件CarSim建立了包括悬架系统、转向系统和轮胎等模型的NJ2046越野汽车整车仿真模型，在此基础上分析了NJ2046越野汽车在方向盘转角阶跃输入时的转向特性，通过对不同车速、不同载荷条件下的仿真计算，得出了在这些条件下该车具有的不同表现特征，揭示了转向特性与车速、载荷和轮胎的内在关系。

Mark a point on the steering wheel cover that is longitudinally and transversely, as measured along the surface of the steering wheel cover, within ±6 mm (±0.2 in) of the point that is defined by the intersection of the steering wheel cover and a line between the volumetric center of the smallest volume that can encompass the folded undeployed air bag and the volumetric center of the static fully inflated air bag.

S26.2.2 在方向盘面上划一点作记号，这个点是在沿方向盘的表面测量而确定的。这个点的位置由方向盘表面和能装下未充气折叠气囊最小空间的中心与静止状态下充分冲气气囊的空间中心之间的一条线所交叉的那个点来确定。前面的那个记号点在这个交叉点的纵横±6 mm (±0.2 in)处。

Because steering axis load of light truck is not very big, so I choose manual steering system for the design, This arragement of steering tapy is also simple and the cost is cheap.

本次中型货车转向系设计由于前轴负荷不太大，故而选择结构简单、制造成本低的机械转向，并使其满足转向系设计的本要求。

Extra sag on the front end will decrease the effective steering head angle, quickening steering, while too little front sag will slow steering.

车前端额外的下沉会减少转向头的角度，加快转向，小的前端下沉会减慢转向。

Two types of steering mechanism for full trailers are axle steering and wheel steering.

全挂车转向装置分为轴转向和轮转向两种形式。

There are six major parameters impacting vehicle handling and stability performance: the cg location, the rigidity of tyre side list, the rigidity of steering system, the steering system transmission ratio, the rear axle roll steering coefficient and the entire vehicle circling the vertical axis the rotating inertia.

对操稳性影响较大的主要有6个参数：重心位置、车轮侧偏刚度、转向系刚度、转向系传动比、后轴侧倾转向系数及整车绕垂直轴的转动惯量。

The multi-body steering system model of a dual-front-axle heavy trucks using ADAMS software was established, which contains body, steering wheel, recirculating ball steering gear, double-front axle, dual-rocking arms, suspension, king pin and the front wheels etc.

应用机械系统动力学自动分析软件ADAMS(Automatic Dynamic Analysis of Mechanical Systems)，针对某型号重型汽车双前桥系统为研究对象，建立包括车身、转向盘、循环球式转向器、双前桥、双摇臂、悬架、主销、转向轮等在内的双前桥系统多体模型。

If there is no excessive wear or the time gap, they should check: First, the steering gear worm gear wear, or the required space, such as the gap is too large to be adjusted; Second, the shift device connected part of the wear and tear, or whether or not to adjust too loose; Third, the steering is loose parts installed; Fourth, there are loose steering arm down.

如无过大磨损或间隙时，则应检查：第一，转向器蜗轮蜗杆磨损情况，或间隙是否符合规定，如间隙过大应调整；第二，转向装置连接部分的磨损情况，或是否调整得过松；第三，转向器安装部位是否松动；第四，转向垂臂有松动。

The ADAMS software and kinematics theory are applied to design the hydraulic steering mechanism of the SGA3550 track, with bottom angle of steering trapezoid and the trapezoid arm length as design parameters, minimum error between theoretical steering angle and practical one as objective function.

利用动力学分析软件ADAMS，从汽车转向运动学出发，对SGA3550自卸式汽车全液压转向机构进行设计。以汽车转向时实际转角与理论转角的误差最小为目标函数，以转向梯形底角和梯形臂长为设计参数，对转向机构进行了优化设计。

"Bird Man's Diary, Butting on the Love Island", Changsha, China

2008年"鸟人日记，顶在爱情岛"，中国长沙

As long as they were in the service of a family of wizards, their magic would remain dormant.

只要他们一天为家庭服务，他们的法力就潜藏不动。