查询词典 powders

The invention makes clay brick powders as main materials, and is compounded from such chemical industry materials as acrylic acid emulsion, sodium hexametaphosphate, sodium benzoate, glycol, trimethylene glycol, polydimethyl siloxanes, methylcellulose and titanium oxide powder as per certain proportion.

本发明以粘土砖粉为主要原料，和丙烯酸乳液、六偏磷酸钠、苯甲酸钠、乙二醇、丙二醇、聚二甲基硅氧烷、甲基纤维素、钛白粉等化工原料按一定配比组合而成。

Whimpering and truckling fold with powders for invalids—conformity goes to the fourth-remov'd; I wear my hat as I please, indoors or out.

whimpering和truckling褶皱与粉末致残符合要求去到第四remov'd ；配戴我的帽子，因为我请，或在室内。

Whimpering and truckling fold with powders for invalids, conformity

认为岁月是空虚的，地上只是泥潭和污浊。

Energy deposition at the interface of the particles caused by micro-explosive welding in explosive consolidation of metal powders is analyzed by symmetrical impaction model of uncompressible liquid. Two-dimensional equation of energy in the flow field of explosive welding is deduced and solved by finite difference method. Then the distribution of the temperature in the flow field is calculated on the basis of considering the adiabatic compression.

摘 要：以不可压缩理想流体对称碰撞模型对金属粉末爆炸烧结中由微爆炸焊接引起的颗粒界面附近沉积的能量进行了分析，在考虑热传导效应的基础上推导出了焊接流场中二维形式的能量方程并用有限差分法对其进行了求解，在考虑冲击绝热压缩贡献的基础上计算出了焊接流场中的温度分布。

After annealing in nitrogen at 500 ℃ with the holding time of 30 min, the hardness of the less pure powders decrease by about 30%, while that of high purity powder under the same condition is unconspicuous.

较低纯度铁粉的压坯在500℃氮气中退火30 min，硬度迅速降低30%；而相同条件下高纯铁粉的压坯表面硬度基本不变。

Subsequently, undoped and doped MgO nano-powders were synthesized by modified precipitation or sol-gel method.

首先简要概述了MgO在环境净化和抗菌方面的研究进展以及纳米MgO的制备方法和掺杂改性的研究。

MAS precursor powders were uniaxially pressed at 100 MPa employing a lubricated steel cylindrical mold. After sintering at 1450℃ for 2 hours, Single-phase cordierite ceramic is prepared, and its relative density is 95.1%.

以硫酸铝、硝酸镁和硅溶胶为原料，采用溶胶-凝胶法，制得MAS先驱体粉末，XRD表明，该粉末经1300℃的热处理后，完全转变为堇青石。

The uniphase C with W/≤0.3 can be synthesized without being preheated. When W/ is higher than 0.3, the sample expansion increases with the increase of W content, the reaction between W and C is incomplete, the combustion products consist of W〓C, WC, TiC, C, and unreacted W. Preheating mixtures can accelerate the completion of the reaction among Ti, W, and C. The uniphase C with W/=0.4 can be synthesized by SHS at preheat temperature of 600℃. There are two kinds of powders with size of 2-4μm and size less than 1μm in the combustion products.

通过燃烧前沿激冷淬熄试验及产物形貌特征（燃烧块断面组织和产物多晶聚合体颗粒）分析，创新性地提出了两种体系的自蔓延高温反应机制。1熔化—溶解—析出机制：当燃烧温度较高时，燃烧前沿Ti粉熔化，W和C溶解于熔融Ti里，而后C从熔融里析出。2扩散—固溶机制：当燃烧温度不足以使燃烧前沿Ti粉熔化时，通过C的扩散先形成TiC层，其后C沿着热应力导致的TiC层裂纹继续扩散，与固态Ti核反应生成TiC；同时，C扩散至W颗粒，形成W〓C，而后通过C的继续扩散W〓C转变成WC；与此同时，WC固溶至TiC里，形成C固溶体。

Estimated value of the strain is 4.87×10^(-3). The energy stored in shocked powders was released during sintering process. The temperature of maximum shrink rate of shocked sample was about 70℃ lower than that of unshocked one. The strength and density of HA ceramics from the shocked sample can be enhanced obviously.

通过衍射峰展宽现象分析，得到粉体内的平均晶格畸变量约为4.87×10^(-3)，由此而存在晶格中的额外缺陷能在烧结过程中释放，可促进HA陶瓷的烧结，使冲击试样比未冲击试样达到最大线收缩率时的温度降低70℃，HA陶瓷的强度和密度明显提高。

When the vials are full of Ar without vacuumize, the paramagnetic Fe-Cr+N+O structure almost represent 100% of the final product after powders milled for 85h.

Fe组元随球磨时间增加单调减少，富Fe的Fe相随球磨时间延长先增加后减少，顺磁相随球磨时间的增加而单调增加。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。