英语人>网络例句>powder process 相关的网络例句
powder process相关的网络例句

查询词典 powder process

与 powder process 相关的网络例句 [注:此内容来源于网络,仅供参考]

The effects of the spray-drying process of the ammonium paratungstate and the carburization temperature on the formation of the precusor and WC powder were investigated.

采用喷雾干燥-固定床法制备碳化钨粉末,研究了喷雾干燥和碳化反应温度对制备偏钨酸铵前驱体以及碳化钨的影响,前驱体粉末呈现均匀的球状形态,平均粒径为10~20μm,喷雾温度对影响粒径大小和分布影响小;400℃的进口温度下进行喷雾干燥,喷雾粉末仍然保持偏钨酸铵原来的基本组成不发生分解。

The shredding of agro-residues, such as corn stalk, straw, wood sawdust and other herbaceous biomass, were investigated in this dissertation. According to the machinery mechanics of shredding, the components, shearing strength and pressive strength of the biomass were analysed in theory, which played a critical role during the shredding process. And the powder was examined by Scanning Electron Microscopy. It was founded that shearing,splitting and grinding force were appropriate for shredding biomass. The results also showed that primary shredding was the bulk shredding model, which was mainly affected by shearing and splitting force, therefore the curly knife and the straight knife were useful; while the fine shredding was the surface shredding model, affected by splitting and grinding force, and the straight knife useful.

本文以农林废弃生物质为研究对象,结合机械力破碎基础理论,从影响其破碎的化学组分和剪切强度、抗压强度等力学角度进行了理论研究,并运用扫描显微镜对破碎产物的微观结构进行了实际分析,结合二者得出如下结论:最适合生物质的施力方式为剪切力、劈碎力和磨削力;生物质粗破碎为体积破碎,主要受剪切力和劈碎力作用,刀片宜设计成弯口刀和单面直刃刀;细破碎为表面破碎,主要受剪切力和磨削力作用,刀片宜设计成双面直刃刀。

Pyrochlore phases were not observed in the material. The purity and homogeneity of the PMNT powder was improved by controlling process carefully.

通过对初始原料和工艺过程的控制提高了PMNT粉体的纯度和均匀性。

A clean production technology of sodium sulfoxylate formaldehyde by one-step process with sodium pyrosulfite ,zinc powder and formaldehyde as raw materials was studied in detail.

详细研究了以焦亚硫酸钠、锌粉和甲醛为原料,一步法合成甲醛合次硫酸氢钠的清洁生产工艺,其最佳操作条件为:焦亚硫酸钠与锌粉物质的量比约1∶2.5,焦亚硫酸钠与甲醛物质的量比约1∶2.1,亚硫酸氢钠溶液的pH 3.3~3.6,活化温度≤45℃,最高温度97~102℃,高温反应时间

To take Tagetes erecta frozen dried powder, ensilaged fresh flower as raw materials, the suitable water yield 6.8, 2.8~3.8 mL/g respectively that the extraction process needed in the water-organic solvent coexistence system was determined, which has guaranteed a good enzyme activity, it can degrade the plant cell wall to make hydrolysis carry on smoothly.

分别以万寿菊花冻干粉、青贮鲜花为原料,在水-有机溶剂共存体系确定提取过程所需要的最适水量分别为6.8、2.8~3.8 mL/g,保证了该体系中较好的酶活性,能够降解植物细胞壁使水解顺利进行。

This study proposes to coat these CIGS thin film bases under the non-vacuum. In this process, synthesis nano-sized alloy powder is turned into trihydric compound paste of CIS by using Sol-Gel in the first step. An array of CIGS thin film absorbing layer was produced on Soda Lime glass through screen-printing.

中文摘要本文提出以非真空制程的涂布方法制备CIGS薄膜吸收层,将具备奈米等级的多元合金粉末利用溶胶-凝胶制备三元化合物的CIS前驱层浆料,以网版印刷式於钠玻璃基板上制作CIGS薄膜吸收层。

BFL's distinctive competence is Natural Yeast in powder: the outcome of an unrushed natural leavening process which confers high quality and distinctive taste to a wide variety of bakery products.

公司最具有特色的产品为粉状的天然酵母。由于其出自天然的发酵工艺,可以用于范围广泛的烘焙产品,保证高质量和独特的风味。

Atomisation 雾化 The distribution of powder particles with air to form a fine pattern during the spraying application process.

在喷涂应用过程中,粉末粒子以空气为介质的喷射出的雾团。

The working process of set is as follows; the liquid of raw material is pumped in through diaphragm pump. The liquid of raw material atomizes into tiny droplets. Then it gathers with hot air and fall off. Most parts of powder material will be collected through the outlet of discharge at the bottom. The wasted air and fine power will be separated through cyclone.

本机组工作过程为料液通过隔膜高压输入,喷出雾状液滴,然后同热空气并流下降,大部分粉粒由塔底排料口收集,废气及其微小粉末经旋风分离器分离,废气由抽风机排出,粉末由设在旋风分离器下端的收粉筒收集,风机出口处还可以装备二级除尘装置,回收率在96-98%以上。

Paper production business card printing and membership card making out powder, szlama and peeling of the main reasons: blanket on ink and paper-surface contact with Nano-imprint lithography process, on the surface of the paper uponsize and the avulsing force viscosity, and the force with the business card printing and membership card making faster.

纸张产生制卡和会员卡制作掉粉、拉毛和剥皮的主要原因表现为:橡皮布上油墨与纸面接触压印过程中,对纸张的表面产生粘拉力和剥离力,并且这种力随制卡和会员卡制作速度的加快而增加。

第18/25页 首页 < ... 14 15 16 17 18 19 20 21 22 ... > 尾页
推荐网络例句

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石!

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻,也许正是在通往天国的路上,我体验着这白色的晕旋。

When you click Save, you save the file to the host′s hard disk or server, not to your own machine.

单击"保存"会将文件保存到主持人的硬盘或服务器上,而不是您自己的计算机上。