查询词典 powder mill

3 Mill in fine raw materials should be put in after the first injected fuel injected powder, and should be put at the turn of the harsh fat, cocoa liquor should be pre-cut into small pieces, heating dissolved (temperature not exceeding 50 ℃) may invest .

4.3精磨机在投放原料时应先投放油料后投放粉料，并应分次交替投放苛刻脂，可可液块应预先切成小块，加热溶解（温度不超过50℃）后方可投放。

The whole grain wheat, oatmeal, wheat germ carried out under the water resistance of different experiments to prove that the water can run to create separation heart of the skin, but to increase the number of water and wheat run the length of the water and are very much related to the mechanical effect , the powder should be based on the length of the road, the development of appropriate moistening wheat water and time, and a flour mill, for example, details of the flour milling system, the amount of silt and water.

通过对全粒小麦、麦皮、麦胚进行不同水分下的抗力实验，证明润水可以创造皮心分离的条件，但是加水量多少和润麦时间的长短都与水分的力学效应有很大关系，应根据粉路的长短，制定合适的润麦水分和润麦时间。并以某面粉厂为例，详细介绍了制粉各系统出粉量粉质和水分的变化。

The effects of ball to powder ratio, radius of ball, reactant ratio, process control agent and mill style on the reaction incubation time of kinetics were studied.

球料比、球径大小、反应物料配比、过程控制剂和球磨机的类型等外界因素对反应动力学中的孕育期产生重要的影响。

If we ask iron ore powder content of the final product particle size less than 100% of negative 80μm, its large particle proportion of mineral particles is relatively small, high frequency sieve sieve wear and tear is not serious under the premise of high-frequency vibrations can be used sieve for grading,Screen carried out under the magnetic separation of ore; sieve of coarse ore, return to re-grinding mill.

如果要求铁精矿粉最终产品粒度负80μm含量低于100%时，其大颗粒的矿粒所占比例比较少，对高频筛的筛片磨损不严重的前提下，可采用高频震动筛进行分级，筛下的中矿进行磁选；筛上的粗矿，回到磨机重磨。

The equipment could pulverize many kinds of mine ore, the supersonic airflow could mill the ore into powder less than 10 micron, it could reduce the cost of mineral products processing and environmental pollution, increase the output.

设备能超细加工各类矿产品，其超音速气流能将各种矿产物料粉碎到10微米以下，对矿产品深加工起到降低成本、减少污染、增加产量。

The rotating turbo in the powder concentrator will make the coarse materials return to the mill and reground, while the fineness will mix with the air and go into the cyclone and be discharged the discharge valve which is in the bottom of it.

选粉机内旋转的涡轮使粗颗粒物料回落重磨，细粉则随气流进入旋风集粉器并由其下部的卸料阀排出即为成品，而带有少量细粉尘的气流则经过脉冲除尘器净化后通过风机和消声器排出。

The rotating turbo in the powder concentrator will make the coarse materials return to the mill and reground, while the fineness will mix with the air and go into the cyclone and be discharged the discharge valve which is in the bottom of it. The air which mixed with very little fineness will be purified by impulse duster and discharged by blower and muffler.

选粉机内旋转的涡轮使粗颗粒物料回落重磨，细粉则随气流进入旋风集粉器并由其下部的卸料阀排出即为成品，而带有少量细粉尘的气流则经过脉冲除尘器净化后通过风机和消声器排出。

After being ground, the material is to be routed to the sorter along the wind belt of the blower and the coarse powder will be put back to the mill for regrinding.

经过实地材料的分级改为以沿线风带的鼓风机和粗粉将回给磨磨。

In this thesis, GLS pin mill is studied based on present research situation of surper fine powder technology in d...

本文基于国内外超细粉体技术的研究现状，结合科研项目，对GLS销棒磨进行了理论及实验相结合的研究。

In this thesis, GLS pin mill is studied based on present research situation of surper fine powder technology in domestic and oversea Experimentally, by analysis on experiment results, the mechanism of impact action between the particle and the pin is revealed, and influence factors on grinding efficiency are discussed.

本文基于国内外超细粉体技术的研究现状，结合科研项目，对GLS销棒磨进行了理论及实验相结合的研究。在实验的基础上，揭示了颗粒与销棒间的作用机理，分析了影响销棒磨粉碎效率的主要因素。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。