查询词典 porosity

The results show that the porosity of the membrane prepared by ScCO_2 induced phase separation is higher than that prepared by conventional method;the membrane structures are significantly influenced by the process parameters;compared with the conventional immersion precipitation phase inversion,ScCO_2 induced phase separation process can effectively avoid the formation of macrovoids at suitable operating conditions;during depressurization process,the great differences in the effect of depressurization time on membranes structure for various polymer materials result from that the speed of CO_2 gaseous nuclei escaping from membrane substrate can not keep the pace with the outer depressurization rate.(2) The tendency that the interaction parameters affect the binodal curve position is illustrated by changing the interaction parameters in reasonable ranges.

研究结果表明：与传统方法相比，采用ScCO_2诱导相转化法可获得更高的膜孔隙率；通过改变操作参数可对膜的结构进行调控，且操作参数对膜结构的影响与铸膜体系的自身性质也紧密相关；在适宜的操作条件下，ScCO_2诱导相转化法能有效避免采用传统的浸入沉淀相转化法制膜时易出现的大空腔结构；泄压过程中CO_2气核从聚合物膜基体中逃逸的速度能否与膜基体外部的泄压速度保持同步，是泄压时间对不同材质膜结构影响截然不同的根源所在。

The main results are as follows: 1 Taking advantage of the porosity and being carrier of anodic alumina, we reported the luminescence of Eu , dye Ru L〓X〓 Ru (Ⅱ(4, 4'-dicarboxyl-2, 2'-bipyridyl)〓〓, and silica gel film anchored porous anodic alumina prepared by self-assembling and deposition.

主要内容如下： 1 利用多孔氧化铝非常高的孔隙率以及它作为载体的优点，采用自组装及沉积的方法将稀土Eu离子、凝胶和有机染料镶嵌于其中，研究了多孔氧化铝复合材料的光致发光。

The bigger average pore of the porosity system,the smaller size of the micro-residual oil droplet and the more dispersed micro-residual oil droplet after waterflooding, that is to say, when the average pore width is big enough,the micro-residual oil is mainly composed of isolated single-pore and dual-pores droplets whereas the blocklike remaining oil is hardly exist.

微观驱替效率随平均孔宽的增加而增加，孔隙大小决定微观剩余油液滴的大小，孔隙系统的平均孔隙半径越大，水驱之后微观剩余油的尺寸越小，分布越分散，也即当孔隙的平均孔宽较大时，微观剩余油主要是由孤立的单孔隙和双孔隙液滴组成，连片的块状剩余油几乎不存在。

The research result showed that(1) The reclaimed water used didn't influence the sensory quality of a given turf grass tested;under irrigation of reclaimed water,Festuca arundinacea are the best,followed by Buchloe dactyloides and Zoysia japonica;(2) The influence of different types of irrigation water on growth characters of turfgrass is species-dependence;(3) Irrigation by reclaimed water and fresh+reclaimed water increases Na~+,CEC,and total porosity of the turf soil in comparison to fresh water,and improves soil quality.

结果表明：本研究使用的再生水对所供测试绿化草种的颜色、覆盖度、质地和均匀性无不良影响，再生水灌溉条件下，高羊茅表现出了最强的综合耐污能力，其次是结缕草和野牛草。灌溉水类型对于草坪草的生长指标的影响具有种的特异性。再生水灌溉和&清水+再生水&交替灌溉提高了土壤的阳离子交换量和总孔隙度，有利于土壤物理性状的改善。

The heat transfer performance of open celled aluminum foam heat sinks under axial fan impinging cooling flow is experimentally studied. Three open-celled aluminum foam samples with different pore sizes and identical porosity (ε=0.92) were tested.

针对电子元器件的冷却问题，实验研究了孔隙率为0.92、孔密度不同的3种通孔泡沫铝热沉在轴流风扇冲击射流下的换热特性。

The relationships among the composition, microstructure and performance of these cementitious materials with high porosity and low alkalinity were studied.

项目组系统研究了高孔隙率低碱度生态材料的组成、结构与性能之间的关系。

In general no porosity is observed in the seam when the length of claviform intermetallic compound is less than 10 μm. Moreover, the microstructure in the seam plays a key role in the diameter of the pore.

界面棒状的金属间化合物长度低于10 μm时一般不产生气孔，而气孔的直径与焊缝内部的微观组织有关。

It was found that increasing pressure for blank can improve the compactedness of blanks so as to make foam aluminium materials with homogeneous pores. Foaming temperature, as one of the main influencing factors on foaming process, should be controlled higher than the melting point of Al or Alalloy to a certain extant in order to keep a reasonable viscosity. Thus, the foam aluminum with homogeneous pores and high porosity is available. As shown by experiments, such materials should be made on conditions that they shall be protected with molten salt under 300?MPa pressure at 675～680?℃.

研究了粉末冶金法制备泡沫铝材料的方法讨论了发泡过程中的保护方式、制坯压力、发泡温度等参数对泡沫铝体积质量、孔隙率、孔结构的影响，并对发泡机理进行了探讨增大制坯压力使得金属坯致密，可以得到孔结构均匀的泡沫铝材料；发泡温度是影响发泡的主要因素之一，发泡温度控制在高于铝或铝合金熔点，同时保持熔体具有一定粘度的范围内，能够得到孔结构均匀、高孔隙率的泡沫铝材料实验结果表明：采用熔盐保护方式，在300MPa的压力下，温度在675～680℃时，可得到孔径均匀、孔隙率高的泡沫铝材料。

This conglomeratic sand body has the characteristics of medium-high permeability, medium-high porosity, fairly serious heterogeneity and sensitivity. The lateral strong heterogeneity is in the northern part and the vertical one is in the upper part.

该砂砾岩体虽具有中高孔、中高渗储集层特点，但存在较严重的非均质性和敏感性问题，平面以北部非均质性最强，纵向以上部非均质性更严重。

On the basis of the conversional log characteristic analysis, evaluation parameters from the logging data are given for identification of the reservoir types, fractures, shale intervals of the formation and tight reservoirs in the carbonate reservoir with dual porosity.

在对岩心分析和岩性、电性、物性和含油性特征研究的基础上，充分分析了该油田储层测井响应，针对该区碳酸盐岩储层双重孔隙介质的特点，建立了识别储层类型、裂缝性质等测井评价参数。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。