查询词典 polymerized

During the Polyvinyl Alcohol producion, the product cannot be polymerized by the monomer directly. Generally, it can be obtained by alcoholysis of poly vinyl acetate in the solution of methanol.

在聚乙烯醇生产过程中，因产品不能由其单体直接聚合得到，通常采用聚醋酸乙烯在甲醇中醇解得到，该过程副产大量的醋酸甲酯。

Three alicyclic dianhydrides, 1,2,3,4-cyclobutanetetracarboxylic dianhydride, 1,2,4,5-cyclopentanetetracarboxylic dianhydride, and 1,2, 4, 5-cydohexane tetracarboxylic dianhydride were polymerized with two aromatic diamines, 1,4-bis (4-amino-2-trifluoromethylphenoxy) benzene (6FAPB, a) and 4, 4'-bis(4-amino-2-trifluoromethyl phenoxy) biphenyl (6FBAB, b) respectively, via a two-step polycondensation procedure to afford two series of fluorinated semi-alicyclic polyimides.

分别将脂环族二酐单体1，2，3，4-环丁烷四酸二酐、1，2，4，5-环戊烷四酸二酐和1，2，4，5-环己烷四酸二酐与芳香族含氟二胺1，4-双（4-胺基-2-三氟甲基苯氧基）苯(6FAPB， a)和4，4'-双（4-胺基-2-三氟甲基苯氧基）联苯(6FBAB， b)反应制备两个系列的含氟半脂环族聚酰亚胺，研究了PI薄膜的热性能和光学性能。

Objective To investigate the antigenicity of polymerized bovine hemoglobin.

摘 要：目的研究乙醇醛聚合的牛血红蛋白的抗原性。

We also study characteristic index and its determination of complex flocculant, put forward the new concept of total basification degree and present the determined method of B〓.In this paper, the author studied and improved on the Ferron Timed Complex Colorimetry, put forward the determination principle and determined method of the improved Ferron Timed Complex Colorimetry, and determined successfully the iron and aluminum hydrolysis-polymerized species of FMA complex flocculation at the same time.

研究了复合絮凝剂的特性指标及其分析测定方法、复合絮凝剂的絮凝特性评价方法，提出了总碱化度作为复合絮凝剂特性指标的新概念，并给出了分析测定方法；研究改进了Ferron逐时配合比色法，提出了复合体系中铁铝水解聚合形态同时测定的测定原理及方法，成功地将其用于FMA中铁铝水解聚合形态的同时测定。

This paper discusses the influnce of different compounds in tar washing oil on the efficiency of adsorbing crude benzol and polymerized degree.

本文详细讨论了洗油中各组成对吸苯能力和聚合程度的影响。

As technique advences, especially the use of polymerized cubic boron nitride, hard turning has become possible.

随着工艺水平的提高，尤其是超硬刀具材料聚晶立方氮化硼的使用，硬车削已经成为可能。

The effects of different conditions (such as the ratio of enzyme amount to protein, pH, reaction temperature and reaction time) on the polymerization by MTGase were also investigated. The optimal conditions for sodium caseinate polymerized by MTGase were obtained: 10～20U/g protein, pH6. 0～8. 0, near 50℃.

还研究了酶量、pH、反应温度以及反应时间等因素对MTGase聚合酪蛋白酸钠的影响，得出较佳的催化工艺条件：酶量为10～20U/g蛋白；pH6.0～8.0；最适温度约为50℃。

This thesis demonstrates the pre-polymers in a polymer-dispersed cholesteric liquid crystals can be polymerized into a polymer film, which can eliminate the aligning capability of the homogeneous alignment layer. Thereafter, the textures of the cholesteric liquid crystals in UV-cured region can be changed from reflective planar texture to the scattered focal conic one. Additionally, the clearing temperature of the liquid crystals can be reduced by doping with chiral dopant or monomers. The cause is the increase of the impurity concentration in LCs. In other words, if the monomers are polymerized, the clearing temperature of LCs in that region should increase due to the decrease of the impurity concentration. Therefore, impurities associated with doping with monomeric and chiral dopants cause the clearing temperature of LCs in cured region to differ from that in uncured region.

本文中，我们提出在高分子聚合物薄膜之胆固醇液晶(polymer-dispersed cholesteric liquid crystals，简称PDCLCs)中，利用紫外光使PDCLC中的单体聚合成薄膜，此即为光引致聚合反应，而该薄膜将原本在表面所作的配向膜覆盖且破坏其配向能力，使胆固醇液晶由原本反射的planar结构转换成散射的focal conic结构；另外，有关液晶材料的相变温度会由於掺杂手性分子或单体而降低，此因液晶材料内『杂质』浓度增加，而造成的液晶材料之不纯度增加，最终导致相变温度降低，若搭配上述光引致聚合反应，则由於光照区之单体聚合，使该区域单体占总材料之比例下降，即不纯度降低，进而使液晶材料之相变温度上升，该区域之相变温度与未照光区有所不同。

Through lots of tests, the new technology of preparing the polymeric ferric aluminum silicate sulfate by using the waste-acid of Ti02-industriy and the coal fly ash has been designed. The highest Al-acid stripping rate can be achieved by the waste sulfate acid under boiling degree for 1. 5h when the mass ratio between NaCl and Coal Fly ash is 0. 05:1, as well as that between Coal Fly ash and Waste Acid ratio is 1:10. By means of the oxidation-polymerized reaction under 40-50*C and normal pressure, using NaNCkas catalyst and air as oxidation, the polymeric ferric aluminum sulfate can be obtained. The poly-silicic acid is polymerized with soluble glass in the optimum conditions of pH=5-6 and the concentration of Si02 is about 3%. The inorganic high molecule coagulant of PFASS is synthesized with the poly-silicic acid into the solution of polymeric ferric aluminum sulfate.

本论文通过大量的试验，研究开发出了用粉煤灰及钛白废酸制取聚合硫酸硅酸铁铝的新工艺，其最佳工艺条件为：于沸点温度，以NaCl为助溶剂(NaCl与粉煤灰质量比为0.05：1)，以钛白废酸浸取粉煤灰(固液比为1：10)中的铝1.5小时，最大浸取率可达40％；经过滤洗涤后，调节滤液pH至2.0左右，以NANO_2为催化剂(NaNO_2用量为滤液中FeSO_4·7H_2O量的3％)，空气为氧化剂，于40-50℃进行常压催化氧化反应，制取聚合硫酸铁铝，催化氧化时间为2小时；将工业水玻璃稀释至3％左右，调节其pH于5-6，室温下制备活性聚硅酸；将活性聚硅酸与聚合硫酸铁铝按照一定比例复合，经熟化，即制得新型无机高分子混凝剂PFASS。

It was demonstrated that the actin could be polymerized into discrete filaments of tree-like branch structure, random coil filaments cluster and long filaments with different diameters in F-buffer besides random aggregates. These polymerized filaments clearly exhibited the structural polymorphism and showed obvious difference from those assembled under the regulation by actin binding proteins or phalloidin.

研究发现，actin在体外通过自装配过程除了形成无序的蛋白堆积物之外，还能够聚合形成复杂的离散结构，包括树状分支的纤维丛、无规卷曲的纤维簇以及具有不同直径的长纤维等；这些大尺度纤维复合物明显不同于在ABPs或过量F-actin稳定剂参与下形成的由单根微丝和微丝束构成的聚合结构。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。