英语人>网络例句>polymerization 相关的网络例句
polymerization相关的网络例句

查询词典 polymerization

与 polymerization 相关的网络例句 [注:此内容来源于网络,仅供参考]

For VC suspended emulsion polymerization initiated by potassium persulphate, the initial polymerization rate is proportional to 133 and proportional to RpJ0 72, where

以 KPS为引发剂进行的 VC悬浮态乳液聚合,基本上是在隔离的小水滴内进行的,类似于乳液聚合机理,但齐聚物自由基的相转移可以引发少量的单体相聚人采用优化的聚合工艺条件,得到转化率大于70%、颗粒仍由基本不熔结的初级粒子组成、吸油率为 19。

With industrial monomer solution of dimethyldiallylammonium chloride as raw material, ammonium persulphate as initiator and Na_4EDTA as chelating agent,using the methods of adding initiator all at once,graduated increasing of temperature and stepwise initiation and polymerization,the polymerization process of preparing poly-dimethyldiallylammonium chloride was researched.

以一步法工业单体二甲基二烯丙基氯化铵为原料,以过硫酸铵为引发剂,采用一次性加入引发剂,梯度升温,分步引发水溶液聚合反应的方法,对制备聚二甲基二烯丙基氯化铵的聚合反应的工艺进行了优化研究。

In the polymerization, viscosity of PESA increased with the increase of the mass of Ca2 and the reaction temperatures; but it was not sensitive to pH value in the polymerization.

环氧琥珀酸的聚合反应中加入的引发剂Ca2的质量和反应温度对于聚环氧琥珀酸的粘度影响很大,随着Ca2的质量增加或是反应温度的提高,它的粘度始终保持着增长的趋势。

The ratio between the rate of polymerization of fibrin monomer and maximum ab sorbency (reflecting the polymerization of plasmic fibrinogen molecules).

纤维蛋白单体聚合速率与最大吸光度的比值(反映血浆纤维蛋白原分子的聚合功能)。

Preparation of polymeric nanocapsules by radiation induced miniemulsion polymerization (1) Polystyrene nanocapsules with liquid core were prepared by ~(60)Coγ-ray radiation induced miniemulsion polymerization, in which N-vinyl pyrrolidone was used as polar monomer.

本文首先通过辐射引发细乳液聚合制备了聚苯乙烯纳米微胶囊,并从热力学与动力学两方面研究了影响纳米微胶囊形貌的因素;之后使用反相乳液聚合制备了磁性复合微球和磁性复合空心微球,并研究了有关影响因素。

Much coagulation coul d be found to be adhered to the wall of reaction vessel and mixer when this cros slinker was used for conventional emulsion polymerization whereas coagulation co uld be greatly reduced and no obvious bulking of particle size of the product wo uld occur when this crosslinker was used for microemulsion polymerization and do sage and proportion of emulsifier wer.

将此交联剂用于乳液聚合中,若采用常规乳液聚合方法,反应器壁及搅拌上会粘附有大量凝胶;采用微乳聚合的方法并调整乳化剂用量及比例,可大大减少凝胶量,同时使产品粒径无明显粗大化现象。

A series of core-shell particles were synthesized by using multi-step soapless emulsion polymerization and conventional emulsion polymerization methods.

采用复合无皂乳液聚合方法和常规乳液聚合方法合成了一系列核壳结构胶粒。

Moreover, nano-scale SiO〓 particle is as seed, styrene-acrylate-acrylic acid emulsion polymerization and soapless acrylic emulsion are studied from varying the level of SiO〓 particle and reaction temperature, particle size of these emulsions are determined and SiO〓 content of participating polymerization is also determined. Kinetic study is carried out in the presence of nano-scale SiO〓 particle.

此外用原位聚合法制备了纳米SiO〓/苯乙烯-丙烯酸酯复合乳液和无皂丙烯酸乳液,研究了不同SiO〓含量、反应温度等对聚合反应稳定性的影响,测定了所得乳胶粒的粒径,分析了在乳液中SiO〓含量,并进行了在SiO〓存在下乳液聚合反应的动力学研究。

A novel macromonomer,polystyrene capped with thienyl group,which can undergos oxidation coupling polymerization,has been synthesized by anionic polymerization of styrene with butyl lithium as the initiator and 3-bromo-thiophene as the terminator.

以丁基锂为引发剂、四氢呋喃为溶剂,在氮气气氛和-78℃下进行苯乙烯阴离子聚合,并加入 3-溴噻吩作为终止剂,从而合成出末端含噻吩基的聚苯乙烯,它可以进行氧化偶联聚合,是一类新的大分子单体。

From solution polymerization, polymers are tokened using MALDI-TOF-MSand IR spectrum. The structure of polymers are confirmed and obtain 2-28 repeatunits of poly(p-aminobenzaldehyde). The tip of polymer molecule still have one-NH_2 and one -CHO. To a certainty condtion, this polymer can polymerization tocreat even more molecular weight.

对溶液聚合得到的聚合物进行了飞行时间质谱和红外光谱表征,确定了聚合物分子的结构,测得了聚对氨基苯甲醛的2-28个重复单元,且聚合物分子末端还保留有一个-NH_2和一个-CHO,在一定条件下可以进一步缩合生成更高分子量的聚合物。

第10/97页 首页 < ... 6 7 8 9 10 11 12 13 14 ... > 尾页
推荐网络例句

It seems likely that Kraft will return with a better offer.

看起来卡夫要重新考虑一个更好的出价了。

But he'd rather burn off my feelers and watch me squirm.

可他却放任那个家伙对我为所欲为!

He consistance of the population dissociation coefficient method andthe sample dissociation coefficient method for the calculation of structural reliabilityin solid rocket motors was reviewed.

依据结构强度-工作应力理论模型,应用数理统计方法和对某团体发动机大量试验数据的实例计算,证明了总体变异系数法和样本变异系数法在结构可靠性计算中的一致性。