查询词典 poly

Using this technique, fluorine atoms can be introduced into poly-Si films to passivate trap states, and hence the performance of SPC poly-Si TFTs can be significantly improved.

利用此技术，氟原子可以有效地被导入复晶矽薄膜中以消除薄膜中的载子补获态，进而有效地提升元件特性。

The same calculations are also carried out for several other typical linear conjugated molecules poly(phenylene vinylene, poly, polythiophene, and polyphenylene molecules and similar results as those of the PA are obtained.

对一系列其它类型的线型π-共轭分子聚对苯撑乙炔(PPV、聚苯乙炔、聚噻吩和聚苯进行了类似的计算研究，也得到了相同的结果。

Spinodals of polystyrene/poly/poly(2,6 dimethyl 1,4 phenylene oxide) were simulated over a wide temperature range and the calculated resul...

将上述方法用于已知状态方程参数的三元均聚物共混物聚苯乙烯／聚甲基乙烯基醚／聚2，6－二甲基1，4－苯撑氧中，得到一系列不同温度下的spinodal相图，预测结果与文献报导吻合。在此基础上进一步研究了聚合物的分子量对体系相行为的影响。

Multi block copolymer poly p phenylene vinylene co poly(ethylene oxide(PPVEO200 and PPVEO600) was synthesized by Wittig reaction.

通过经典的Wittig反应，成功合成了聚对苯亚乙烯和2种分子量聚氧化乙烯的多嵌段共聚物(PPVEO200和PPVEO600)。

The recent development in the toughening and plasticization of poly or poly(hydroxybutyrate-co-hydroxybutyvalerate) was reviewed.

总结了近年来国内外关于聚羟基丁酸酯和聚羟基丁酸酯-co-羟基戊酸酯共聚物在增韧和增塑改性方面的研究进展。

One of them is that your low poly model needs to conform well to your high poly mesh.

烘焙一个好的法线贴图需要几个要求：一个是你的低模需要很好的匹配你的高模。

Low temperature poly-Si is attractive for display developing toward high circuit integration, low power consumption, and organic electro-luminescence, but poly-Si has high surface roughness which causes poor uniformity, bad reliability, and high scale-down difficulty of TFTs.

显示器朝高度电路整合，低耗电及有机发光发展，低温多晶硅是最受瞩目的技术。然而，多晶硅的高表面粗糙度会造成组件均匀度、可靠度不佳，及组件缩小化的困难。

Results: MR demonstrated capsule wall and papillary solid lesions in one case with cystic and solid lesions of hepatobiliary cystadenoma. Poly cystic form tan if different sine in sew case, capsule wall and septation was thick, part of capsule wall was obviously thickened and nodes form, intrahepatic bile duct was dilated, large poly-antrum cystic keen form structure in one case, capsule wall and septation were smooth, part of capsule wall was uniformly thicken, capsule wall, septation, mural nodus form and solid lesions in three cases wee all slightly hyperintense on T2WI and slightly hypointense on T1WI. Part of cyst fluid was hypointense on T2WI the diameter if tumor ranged from 3.4cm to 13.5cm. Part of capsule wall, septation, solid lesions and mural nodus west obviously enhanced in arterial phase in three cases, the extent of enhancement showed a little degrade in port vein phase, balance phase and delay phase, but dense to liver parenchyma at synchronization.

结果：3例肝内胆管囊腺瘤中1例呈囊实性结构，可见囊壁及乳头状实性肿块；1例为多个大小不等的多房囊状结构，囊壁及分隔光滑，囊壁局部明显增厚，有壁结节，周围见轻度的肝内胆管扩张；1例为巨大的多房囊状结构，囊壁及分隔光滑，局部均匀增厚；3例中的囊壁、分隔、壁结节及实性部分均呈T2WI稍高信号、T1WI稍低信号，囊内液性部分均呈T2WI高信号、T1WI低信号；肿瘤瘤体大小径线范围3.4~13.5cm.3例肝内胆管囊腺瘤中囊壁、分隔、实性肿块和壁结节动脉期均明显强化，门脉期、平衡期及延迟期强化程度略减低，强化程度均高于同期肝实质。

A very mild and extremely efficient hydrolysis method for transformation of polystyrene-b-poly (tert-butyl acrylate) to polystyrene-b-poly was designed and carried out using more convenient and inexpensive chlorotrimethylsilane/sodium iodide as reagents.

在温和的条件下使用廉价方便的三甲基硅氯烷/碘化钠作试剂，在乙腈溶剂中，50℃下使聚苯乙烯-嵌-聚丙烯酸特丁酯高效的水解。用透射电镜和动态光散射对嵌段共聚物聚苯乙烯-b-聚丙烯酸在水介质中的胶束化进行了研究。

Through lots of tests, the new technology of preparing the polymeric ferric aluminum silicate sulfate by using the waste-acid of Ti02-industriy and the coal fly ash has been designed. The highest Al-acid stripping rate can be achieved by the waste sulfate acid under boiling degree for 1. 5h when the mass ratio between NaCl and Coal Fly ash is 0. 05:1, as well as that between Coal Fly ash and Waste Acid ratio is 1:10. By means of the oxidation-polymerized reaction under 40-50*C and normal pressure, using NaNCkas catalyst and air as oxidation, the polymeric ferric aluminum sulfate can be obtained. The poly-silicic acid is polymerized with soluble glass in the optimum conditions of pH=5-6 and the concentration of Si02 is about 3%. The inorganic high molecule coagulant of PFASS is synthesized with the poly-silicic acid into the solution of polymeric ferric aluminum sulfate.

本论文通过大量的试验，研究开发出了用粉煤灰及钛白废酸制取聚合硫酸硅酸铁铝的新工艺，其最佳工艺条件为：于沸点温度，以NaCl为助溶剂(NaCl与粉煤灰质量比为0.05：1)，以钛白废酸浸取粉煤灰(固液比为1：10)中的铝1.5小时，最大浸取率可达40％；经过滤洗涤后，调节滤液pH至2.0左右，以NANO_2为催化剂(NaNO_2用量为滤液中FeSO_4·7H_2O量的3％)，空气为氧化剂，于40-50℃进行常压催化氧化反应，制取聚合硫酸铁铝，催化氧化时间为2小时；将工业水玻璃稀释至3％左右，调节其pH于5-6，室温下制备活性聚硅酸；将活性聚硅酸与聚合硫酸铁铝按照一定比例复合，经熟化，即制得新型无机高分子混凝剂PFASS。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。