查询词典 point particle

Basing on the view point of the α particle structure of the 12 c nucleus,the form factor and the transition form factor of the α particle in 12 c nucleus are as inputs,the inelastic scattering of pion-12c for 2+(4.43 mev) and 3-(9.64 mev) at tπ=150,180 mev are studied within glauber scattering theory.the calculated differential cross sections show better agreement with the experimental data.

从12c原子核的α粒子结构观点出发，应用12c原子核内α粒子的形状因子和跃迁形状因子，在glauber散射理论框架下，计算了共振区内能量为tπ=150，180 mev，π-12c的2+(4.43 mev)和3-(9.64 mev)非弹性散射微分截面。理论结果与实验较好8 t tt 8.c o m 地符合。

From the physiological point of view the critical parameters of magnetizable complex systems and magnetic field are particle size, surface characteristics of the particle, concentration and volume of the fluid, reversibility and strength of the drug-ferrofluid binding, access the organism, duration and rate injection, geometry and strength of the external magnetic field.

从生理学观点看，影响磁性复合物系统和磁场的关键因素包括：颗粒大小、颗粒的表面特性、流体的浓度和体积、药物-铁磁流体吸附的强度和可逆性、有机体的可接近性、持续时间和注入的速率，以及外磁场的几何位置和强度等

The correlation among all these parameters of four different types of wear debris is conducted. In the analysis of surface texture, the maximum and minimum brightness point in texture normal line is examined firstly. Then, the differences among some typical wear particles are analyzed through analyzing the texture gray level co-occurrence Matrix, color principal component analysis of the wear particle and the direction of wear particle outline.

在磨粒表面纹理分析中，通过检测磨粒表面纹理法线上亮度极小、极大值的纹理分析方法分析了滑动磨粒与疲劳磨粒差别，通过灰度共生矩阵进行纹理分析四种不同类型的磨粒图像，通过主成分分析分析方法对磨粒颜色特征进行识别，以及根据磨粒轮廓方向判断磁性磨粒和非磁性磨粒。

In this algorithm, the probability of a certain particle element assuming a value of 0 or 1 is in positive proportion to value 0 or 1 of this element in the current position of the particle, the historic best position it experienced, and the best point found by any member of its topological neighborhood; but in negative proportion to value of the former position of it.

在该算法中，每个粒子各元素在新位置取二元值0或1的概率正比例于其当前位置、其历史最优位置和其邻域内的历史最优位置的取值，而负比例于其前一个位置的取值。

The recompression phenomena have been found in the particle velocity histories of alumina specimens while the impact pressure between 7GPa-8GPa. From the point of view of phenomena, the recompression signals in terms of free surface particle velocity occurring in alumina ceramics under shock-loaded were similar to those in glass where failure wave has been widely verified.(4)The modified form for the Hugoniot Elastic Limit was given associated with

得到了A95陶瓷采用Drucker-Prager准则修正公式计算的σHEL值，并与实验得到的σHEL值进行了比较；(5)采用ANSYS/LS-DYNA有限元分析软件对冲击压缩下氧化铝陶瓷动态力学性能进行了模拟分析，数值模拟结果与实验结果吻合较好，数值模拟结果表明JH-2材料模型能够较好地模拟陶瓷的物理力学性能。

In this thesis, three major achievements were made in theoretical study: conditions and rules for preparing nano-powders by chemical precipitation are analyzed from the point of view of thermodynamics and kinetics, the principle, standards and experimental method for the aqueous dispersion of nano-scaled metal oxide powders were proposed and verified, mathematical model of nano-filming addition of dopants by chemical coprecipitation was established. In experimental research, nm-ZnO, nm-Bi〓O〓, nm-Co〓O〓 and nm-MnO powder with spherical shape, narrow particle size distribution and small particle size were prepared successfully, highly stable and dispersive aqueous suspensoid of nm-ZnO, nm-TiO〓, nm-Co〓O〓 and nm-MnO powder were prepared successfully and surface modification on these nano-powders was also achieved, 0-3 nanocomposite ZnO varistors with nm-ZnO, nm-TiO〓and nm-MnO respectively were prepared successfully by conventional mechanical attrition, and exhibited much better electrical properties than those of conventional varistors.

综上所述，本文在理论研究方面取得了三项成果：（1）从热力学和动力学角度推导并分析了液相化学沉淀法制备纳米粉体的反应条件和规律，（2）提出了纳米氧化物的水分散体系的设计原理、规范和通用实验步骤，（3）提出了共沉淀的数学模型和计算方法；在实验方面所取得的成果有：（1）成功制备了粒度小、分布窄、形貌对称的纳米氧化锌、纳米氧化铋、纳米氧化钴和纳米氧化亚锰，（2）成功地制备了纳米氧化锌、纳米二氧化钛、纳米氧化钴和纳米氧化锰的高稳定分散悬浮液并实现了干粉体的表面改性，（3）成功地进行了纳米氧化锌、纳米二氧化钛和纳米氧化锰对压敏电阻的0—3复合掺杂实验，试样性能远优于常规压敏电阻，为实现压敏电阻的高能高压化提供了新的方法和思路。

The results were found as following:(1) The damage value increases more significantly with the increase in PVF before 30% PVF, beyond which the increasing trend becomes gradually gentle.(2)Keeping the interphase strength and PVF unchanged, the damage increase with increasing moisture concentration in a nearly linear relation.(3)The results generated from the FCC model with consideration of the interphase debonding are in good agreement with the experimental data, meanwhile, the FCC model is also capable of predicting the critical load for the damaged and the undamaged dental composite subject too the 3-point flexural test.4 A 3D-fmite element analysis has been successfully exploited to examine the mechanical behavior of the restoration-tooth structure under the polymerization shrinkage and water sorption. It was found:(1) The low stiffness of the composite has the effect to limit the displacement occurring in the remaining tooth tissue. For lower interphase, the cuspal flexures are litter higher. The high interphase modulus acts as a \'shielding effect\' for stress transfer.

得到如下结论：(1)相同的吸湿性，在30％PVF(颗粒体积分数：Particle volume fraction，PVF)前增加PVF，层间脱胶损伤值显著增加；此后损伤值的增加趋于平缓；(2)保持层间强度和PVF不变，层间脱胶损伤随吸湿率的增加而接近线性增加；(3)FCC(面心立方：Face-centred cubic，FCC)模型层间脱胶损伤的预测结果和实验数据基本吻合；同时此模型可以用于预测牙齿填充材料三点弯曲实验的临界载荷。4、建立理想牙齿修复结构，利用有限元方法研究了同时考虑聚合收缩和吸湿膨胀耦合作用下的填充修复材料和粘结界面层材料性能对牙齿修复结构的力学行为的影响，得到如下结论：(1)低弹性模量的牙齿填充修复材料能限制天然牙组织的位移，但天然牙组织的位移与粘结界面层的弹性模量无关。

From this point of view, we investigate the effect of the curvature energy and the compressibility energy on the emission of the prescission particle. The effect, acting together with the other one that the lower emission barrier facilitates the particle emission, leads to a different way to emit proton and α particle.

从这个角度，笔者研究了引入曲率能和压缩能影响断前粒子发射的效应，与发射位垒降低增强断前粒子发射的效应相作用，使断前质子和断前α粒子在基态到鞍点间出现了不同的发射规律。

Response time is defined as the same point in the panel above to change from black and white plus the time required for change from white to black response time LCD there is a matter of time because the LCD is based on the rotation angle of liquid crystal molecules to control the light light and dark gray rotation of liquid crystal molecules will take time. the general aim is to monitor the use of word processing and web browser is under normal circumstances will continue to monitor display screen with a long period of time, then switch to a different picture of such a In fact, the use of fast response time more than slow the user is not affected but if you want to use animation or video monitor view will continue to change because the screen did not stop this time the response time will affect the picture quality.

坏点所谓坏点，是指液晶显示器上无法控制的恒亮或恒暗的点，坏点的造成是液晶面板生产时因各种因素造成的瑕疵，可能是particle落在面板里面，可能是静电伤害破坏面板，可能是制程控制不良等等等，坏点分为两种：亮点与暗点，亮点就是在任何画面下恒亮的点，切换到黑色画面就可以发现，暗点就是在任何画面下恒暗的点，切换到白色画面就可以发现，一般来说，亮点会比暗点更令人无法接受，所以很多monitor厂商会保证无亮点，但好像比较少保证无暗点的，有些面板厂商会在出货前把亮点修成暗点。

To address routing planning of the delivery vehicle navigation in logistics, the article based on point-to-point model, improved the fundamental particle swarm optimization in the initial population, the method of population and evolutionary strategy for improvement, put forward the improved particle swarm optimization for vehicle routing point-to-point model problem of navigation in distribution, and verify the validity of the algorithm by simulation tests.

为解决物流配送车辆导航中的路径规划问题，文章以点对点模型为基础，对基本粒子群优化算法在初始种群的产生方法和种群的进化策略方面进行改进，提出适于配送车辆导航中路径规划点到点模型的改进型粒子群优化算法，并通过仿真试验验证算法的有效性。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。