查询词典 plastic deformation

In chapter 2, a finite element model for the composite sandwich plates is developed, based on the Zig-Zag deformation assumption and the first order shear deformation theory, and the finite element buckling analysis governing equations for the plates under mechanical, thermal and/or thermal-mechanical mixed loads are deduced respectively. By Von-Karman nonlinear deformation relations and Total Lagrange formulation, an incremental governing equation for postbuckling analysis is established and a corresponding effective computational scheme is presented..

第二章首先建立了基于Zig-Zag截面变形假定和Mindlin一阶剪切理论的夹层板有限元分析模型，分别推导了夹层板机械力、热载和热—机械力耦合屈曲分析的有限元列式和相应的屈曲前以及屈曲临界状态的平衡方程，基于Von-Karman大挠度理论，采用增量形式的全局lagrangian法推导了复合材料夹层板增量形式的几何非线性有限元离散平衡方程，给出了一种有效的非线性平衡方程的迭代求解格式。

There are intense deformation in the foreside and weak deformation in the middle part as well as stabled deformation on the top of the landslide.

其前缘为滑坡强变形区，中部为弱变形区，上部为老滑坡区。

Research on improved AR model and its application to simulation and prediction of vertical deformation ;2. The vertical deformation of the Three Gorges area was calculated according to the Farrell s globosity deformation theory.

根据三峡地区的数字高程模型，模拟三峡二期工程蓄水位达到 135m后的水体负载，利用Far rell提出的质量负荷产生的地球形变理论，推算三峡水库水位达到 135m后整个库区的垂直形变，与三峡库区GPS形变监测网获得的蓄水前后的垂直形变图像进行对比分析，结果显示：在三斗坪巴东库段，两者中都出现了 3个相同的、明显的垂直形变集中区。

The results indicate that the flow stress of the alloy increases with increasing strain rate and decreasing deformation temperature. The flow stress increases with increasing strain until the stress reaches the peak value, then the flow stress remains constant, which indicates that dynamic recrystallization happens during deformation. The flow behaviors are described by the hyperbolic sine constitutive equation, and the activation energy calculated is 337.75 kJ/mol. The as-forged microstructure consists of refined α2/γ and γ grains, and the grains are much homogeneous than before. The B2 phase distributes uniformly at the grain boundary of α2/γ and γ grains. The B2 phase decreases with increasing deformation temperature.

结果表明：流变应力随着应变速率提高和变形温度降低而增大；在变形过程中，流变应力随着变形量增大而增大，当流变应力达到峰值后趋于平稳，表明合金在变形过程中发生了动态再结晶；热变形过程的流变应力可采用双曲正弦本构关系来描述，平均激活能为337.75 kJ/mol；从合金的组织演化过程中可以看出，合金中不均匀的原始组织得到明显均匀化，变形后的组织是由α2/γ层片晶团和γ晶粒组成的双态组织，在α2/γ层片晶团和γ晶粒的晶界交界处发现分布均匀的B2相，并且随着变形温度升高B2相数量逐渐减少。

On the basis of Chen's equation of finite deformation mechanics with a dragging coordinator system,the paper studied the meaning of elastic parameters and constitutive equation in the medium equivalent to classic infinitesimal deformation mechanics that cracked,large deformation formation corresponds to and relevant features of seismic velocity.

基于陈至达的拖带坐标系的变形力学方程，研究了大变形破裂地层对应的经典无限小变形力学的等效介质弹性参数的含义、物性方程和相应的地震反射波的速度特性。

Based on investigating the short and intermittent structural plane, surrounding rockmass of the huge underground powerhouse in Three Gorge has been divided into five statistical similar areas according to its characteristic of rockmass structure by applying structure plane network simulation. Distributed characteristic of structural plane has been studied and based on it mechanics macrocharacteristic has been studied:(1) It is the first time that based on the result of structural plane network simulation rockmass quality of every structure area has been studied with applying blurred information optimum seeking technique and be compared with and RQD method. The result indicated that it has better effect to evaluate rock quality with blurred information optimum seeking technique.(2) It is the first time that the interrelated relationship of the result of in-suit rockmass deformation test and fractal characteristic of structure on test point has been applied to determine rockmass deformation parameter. The question of evaluating deformation parameters of engineering rockmass has been solved.(3) Anisotropy strength parameters have been determined by applying shear zones simulating method. The result indicated that there are different strength parameters in every structural area, after comparing the result of Fast Lagranian Analysis in continua number simulation method with that of method of weighted mean according to continuity. The result indicated that when a suitable reduction coefficient is been considered rockmass strength parameters can be simply and fast determined with method of weighted mean according to continuity where there is not enough test result.(4) Damage characteristic has been studied based on analysis fractal characteristic of structural plane network by applying fractal-damage coupling method. It is the first time that the concept of damage degree has been set up to evaluate rockmass quality according to the biggest principal damage.

通过对短小、断续性结构面统计特征的研究，将地下厂房区划分为五个岩体结构统计均质区，应用结构面网络模拟技术研究了各个岩体结构均质区结构面的发育分布特征，并以此为基础对岩体宏观力学特性进行了深入研究：(1)首次通过在结构面网络模拟计算结果的基础上，应用模糊信息优化技术研究了厂房区各个岩体结构分区的岩体质量并与岩体基本质量指标研究法、岩体质量指标RQD值研究法作了对比，结果表明以结构面网络模拟结果为基础，应用模糊信息优化技术进行岩体质量评价能够取得很好的效果，解决了工程岩体质量的定量评价问题；(2)首次通过对已有的现场大型岩体变形试验结果的分析及相应试验点岩体结构分形特征的研究，建立了结构面分布的分形维数和岩体变形指标间的相关关系，并首次应用这种相关关系根据结构面网络模拟及分形维数计算结果确定了缺少试验结果的地下厂房各工程部位的岩体变形指标而且应用于围岩稳定性计算，解决了工程岩体宏观变形参数的评价问题；(3)应用在结构面模拟网络图上模拟岩体剪切破坏带的方法，得出了岩体在不同方向上的强度参数，结果表明岩体的强度特性与结构面的发育方向和程度有着明显的关系，各个岩体结构均质区具有不同的强度参数；同时还通过应用拉格朗日差分法对岩体强度指标的数值分析并与按连通率加权平均计算法对比表明，按连通率加权平均计算法在考虑合理的折减系数情况下，可以简单快速地对缺少现场大型试验结果的具体工程部位实现岩体强度指标的估计，通过以上研究解决了工程岩体抗剪强度参数的评价问题；(4)通过结构面网络分形维数的研究，应用分形损伤耦合分析方法，研究了厂房区岩体的损伤特征，并首次引入"损伤度"的概念，建立了应用最大主损伤评价岩体质量的指标体系。

Lightweight steel frame structure; structural ultimate bearing capacity; second order nonelastic analysis; shearing deformation; lateral-torsional deformation; warping deformation; joint semi- rigidity connection; neural network BP; Genetic Algorithm arithmetic

轻型钢框架结构；结构极限承载力；二阶非弹性分析；剪切变形；侧扭变形；翘曲变形；节点半刚性；神经网络BP算法；遗传算法

It is believed that wear is causedby protuberant deformation at middle of the segments and that thermal deformation is the main factorto cause deformation of the segments.

推力瓦的热变形主要是由三个分量组成：瓦体与瓦面线胀系数不同引起的热变形，瓦厚度方向温差引起的热变形和瓦面热变形。

The graben geomorphic characteristics of Northern Xiqiangtang and Changjiang Riverhead depressions are obvious, whereas the Huanghe Riverhead and Ruoergai depressions are of relatively low development degree. However, they are products of the east-west geomorphic extensive deformation, and the dynamic background of the deformation is the same as that of the continental tectonic deformation of Qinghai-Tibet plateau.

其中西羌塘北部坳陷和长江源坳陷的地堑式裂陷地貌特徵明显，而黄河源坳陷和若尔盖坳陷发育程度较低，但它们均是在青藏高原大陆构造变形的统一动力学背景下，地貌发生东西向伸展变形的产物。

Supracrustal sequences free of early strong deformation The early deformation of Jingangku formation complex of Hengshan Wutai group complex has formed a bedding parallel S〓 gneissic and schistosity, occasionally bedding parallel recumbent folds in layers. The early deformation of the near-horizontal ductile shearing isn't very strong in Wutai group complex. The orientation of shear movement is NNW—SSE.

经受早期强烈变形的表壳岩系岩系恒山五台岩群金岗库岩组和五台山五台岩群最早期的变形是平行地层层理的S1片麻理和片理，偶见层内的顺层掩卧褶皱，这些早期近水平韧性剪切变形在五台岩群大都不甚强烈，对地层层序的扰动也很弱，剪切运动方向是北西西——南南东向的。

Summary In copyright infringement cases,if the alleged infringer uses or even plagiarizes the copyrighted works or parts thereof,which causes no substantially adverse effect on the normal exploitation of the work,nor does it inflict any substantial damages to the right owner,the de minis doctrine should be applied to exempt the liabilities of the defendant and seek the balance of interests between the right owner and the general public embodied by the copyright law.

在侵犯著作权案件中，如果被控侵权行为人虽未经著作权人的同意，使用甚至抄袭了受著作权保护的作品或作品的片段，但若情节轻微，未对该作品的正常使用产生任何实质不利的影响，亦未对权利人的权利造成实质性的损害，则应适用&不计琐细原则&，免除行为人的责任，以寻求在权利人利益与著作权法所体现的社会公共利益之间的平衡。

This new product will become our best seller.

这个新产品会成为我们最畅销的产品。