查询词典 pitch ratio

Based on the results, there is an increase in total emergy input from 1.126×10^22 to 1.661×10^22 seja(-1), with an ob-served increase in total emergy output from 5.002×10^20 to 1.383×10^22 seja^(-1) for 1952~2005. Ecological function potential drops from 54.08% to 37.02% and the basic population capacity increases from 199 400 to 315 100. Emergy self-support ratio drops from 74.58% to 54.13%, while emergy investment ratio increases from 34.0% to 85.0%. Emergy density increases from 1.34×10^11 to 1.97 ×10^11 sejm^(-2) and emergy/money ratio decreases from 4.93×10^14 to 1.81×10^13 sej$^(-1). There is an increase in environment load ratio and net energy yield ratio from 0.85 to 1.70 and from 0.18 to 1.82 respectively.

结果表明，1952~2005年期间，阿坝州农业生态系统总能值投入从1.126×10^22 seja^(-1)增加到1.661×10^22 seja^(-1)，总能值产出从5.002×10^20 seja^(-1)增加到1.383×10^22 seja^(-1)，生态功能潜力从54.08%下降到37.02%，人口基本承载力从19.94万人增加到31.51万人，能值自给率从74.58%下降到54.13%，能值投资率从34.0%上升到85.0%，能值密度从1.34×10^11 sejm^(-2)上升到1.97×10^11 sejm^(-2)，能值货币比率从4.93×10^14 sej$(-1)降低到1.81×10^13 sej$(-1)，环境负荷率从0.85上升到1.70，净能值产出率从0.18上升到1.82，可持续发展指数从0.20增加到1.07。

Considering the pitch deviation, pitch accumulative deviation, flank angle deviation and their combined influence on the pitch diameter, the authors present a complete differential optimal approximate model in this paper and use the ideal thread to approximate the actual thread radially and axially.

本文建立的螺纹中径当量全微分优化逼近模型，考虑了螺距偏差、螺距累积偏差和半角偏差本身及其相互间对中径的综合影响，并用理想螺纹在径向和轴向二维逼近实际螺纹。

The rules of the cold-test characteristics changing with helix pitch are also studied and it turns out that, with increasing helix pitch, the phase velocity increases linearly, the interaction impedance changes nonlinearly and the attenuation constant decreases nonlinearly. At the same time, with the limitation of the synchronism between the electron beam and the electromagnetic wave, the change of pitch is small and therefore an approximate linear relation can be introduced.

研究表明：相速几乎随螺距增大而线性变大，互作用阻抗与螺距是非线性的关系，衰减常数随螺距增大而非线性地减小；由于在维持电子注与电磁波速度同步的限制下，螺距变化的幅度不可能很大，因此可近似按线性关系来处理互作用阻抗及衰减常数与螺距之间的关系。

1 When thickness of the short pitch or long neck flange straight side of Type B doesn't equal to the cylinder thickness connected with it: If cylinder thickness is not larger than 10mm, and thickness difference with short pitch or long neck straight side is larger than 3mm; If cylinder thickness is larger than 10mm, and thickness difference with short pitch or long neck straight side is larger than 30% of the cylinder thickness or 5mm, Type B flange should take the slope value 1: 3, and the long neck flange should be thinned according to Chart 1, or have pile welding on the end of butt welding seam to achieve transition.

6.5.1 乙型法兰的短节厚度或长颈法兰的直边厚度与其相联接的圆筒厚度不等时：若圆筒厚度不大于10mm，且与短节或长颈直边厚度差超过3mm；若圆筒厚度大于10mm，且与短节或长颈直边厚度差大于圆筒厚度的30%或超过5mm时，乙型平焊法兰应按斜率1：3，长颈对焊法兰按图1虚线削薄，或者在对接焊缝的筒体端部按图2堆焊过渡。

A design method of non-perpendicular pitch cone of the honing wheel is presented in this article. By adjusting the distance from the contact point of pitch cones to the axis of honing wheel, the relative velocity between pitch cones is ensured to be in the direction of the tooth trace of the gear.

提出了用于珩磨螺旋锥齿轮的非正交珩磨轮节锥面的设计方法，通过调整节锥面切点到珩磨轮轴线的距离，保证了节锥面之间的相对速度恰好沿着齿长方向。

The definiens and working principle of controllable pitch propeller are introduced, the characters of CPP mechanism are summarized, and three types of shipping are concluded, which is applicable to equip with controllable pitch propeller by compared with pitch propeller. The control system of CPP usually adopts PID control, but the parameter of PID controller is adjusted inconveniently so as not to receive favorable result, therefore, the CPP control system based on fuzzy and neural network control is proposed so that improving the control effect. The result shows that the system design is feasible and effective.

介绍了可调螺距螺旋桨的定义及工作原理，并归纳了可调螺距螺旋桨推进装置的工作特性及特点，通过与定距桨进行的对比分析，总结出适用于可调螺距螺旋桨的三类船舶；目前调距桨控制系统一般采用传统的PID 控制方法，但由于PID控制器的参数不便于调节，不能取得良好的控制效果，从而提出了基于模糊神经网络控制的调距桨控制系统的设计，以提高调距桨在各种工况下的控制效果，仿真试验结果表明了调距桨控制系统设计的合理性。

The numerator in this fractional designation is known as the diametral pitch and controls the pitch diameter; the denominator, which is always double the numerator, is known as the stub pitch and controls the tooth depth.

在这一系列的分数中的分子是径节，径节的大小决定了节圆的直径；而分数中的分母通常是分子的两倍，分母是残余径节，它的作用是控制齿槽的深度。

Stub Pitch is a number used to denote the radial distance from the pitch circle to the major circle of the external spline and from the pitch circle to the minor circleof the internal spline.

残余径节：残余径节是一个数，它用于表示节圆与外花键的大圆或内花键的小圆之间的半径差。

Geodesic curvature of the pitch curve on spherical surface was introduced as a medium,through which the pitch curve on spherical surface can be changed into equivalent planar pitch curve by numerical computation method.

以曲面上曲线的短程曲率为媒介，导出了球面节曲线伸展成平面当量节曲线的算法。

Perfect pitch is very helpful, but it is not essential; good relative pitch is sometimes even better, especially when you are dealing with transposing instruments or when the general pitch of an instrument you are working with is half a note off.

完美的定调是很有益的，但不是非常重要的，有时相对良好的定调更好，特别是在更换乐器或乐器比一般定调低半个音符时。

Through comparing with the results by simulation to study the effects of theprojectile"s final velocity, the angle of rotation and the ballistic trajectory"s migration withdifferent projectile"s rotating speeds, different target"s moving speeds and differentpenetration angles.

通过比较数值模拟的结果来研究不同弹头转速、目标速度、侵彻角对侵彻过程中弹头最终速度、翻转角度和弹道偏移的影响。

I love stationery and all the accoutrement of writing.

我爱文具以及所有的书写的工具装备。