查询词典 pin

Methods Knee joint was examined with arthroscopy and the remanant end of ACL was repaired. Then self made hook pin and sutural pin were used to suture the ACL by bidirectional 'U' shape suturation. The silk was fixed on the end point of tibia through anterior tunnel of tibial tuberosity.

关节镜探查膝关节、修整ACL残端，使用自制钩针和缝合针，双向&U&形缝合ACL断端，缝线经胫骨结节前骨隧道固定ACL于胫骨端止点。

If the device is operated halfCchannel with the FST pin clocking and FSR pin held low, the receive filter input will be conencted to the VAG voltage.

如果该设备是与福斯特针时钟和FSR经营halfCchannel引脚保持低电平，接收器输入将conencted到VAG的电压。

Insert a self-tapping screw into the drilled pin and carefully pull the pin from the camshaft.

插入自动攻丝螺丝到钻孔的销中，小心地在凸轮轴中拉动销。

PATIENTS AND METHODS: In this prospective randomized study, we followed up 610 pin sites in 39 cases using two different pin site care protocols.

患者和方法：在这项前瞻性随机研究中，我们随访应用两种方法护理的39名患者610处针孔。

The user presses one lobe (112) for an aspirating stroke to rotate the plunger shaft (48) in one direction and align the stop pin (52) with uppermost lower stop (104) for a relatively short aspirating stroke and the user presses the other lobe (114) for a dispensing stroke to rotate the plunger shaft (48) in the other direction and align the stop pin (52) with lowermost lower stop (106) for a relatively long dispensing stroke.

用户按压用于吸取冲程的一个凸耳(112)，以便使柱塞杆(48)沿一个方向旋转，并使止动器销(52)与用于相对较短的吸取冲程的最上面的下部止动器(104)对齐，而用户按压用于分配冲程的另一凸耳(114)，以便使柱塞杆(48)沿另一方向旋转，并使止动器销(52)与用于相对较长的分配冲程的最下面的下部止动器(106)对齐。

In the transmission mechanism of optional drive ratio worm crank pin,the circular pitch of annulus worm changes from the function of optional drive ratio.When the annulus worm tums equably,the roll-pin crank brings shift tuming through joggling,and it can applly to dumping and turning mechanism of ladle.

变传动比蜗杆曲柄销式传动机构，其环面蜗杆的齿距是依变传动比的函数关系变化的，当环面蜗杆匀速转动时，通过啮合使滚销式曲柄产生预期的变速转动，可应用于铸造生产的铁水浇包的倾转机构。

This paper,based on analyzing the characteristics of spring pin clutch, jaw clutch and plats friction clutch, presents a new typs clutch——spring column pin-jaw clutch, discussing the principle of its work, with the designs of its structural dimensions and calculations of its capacity.

本文在分析弹簧插销离合器、牙嵌离合器和摩擦离合器特点的基础上，提出了弹簧柱销牙嵌离合器，并对这种离合器的工作原理、结构尺寸设计及工作能力计算作了详细的阐述。

The connecting pin axle, firm screw, screw, open pin should use the special components of the production factory.

各部件之间的连接销轴、紧固螺栓、螺母、开口销必须使用厂家的随机专用紧固件，不得随意代用。

We should pay attention to the removal or installation to maintain the balance of CPU, in particular, attention should be paid prior to installation to check whether the pin-bending, do not always make a beat or out, or else it may break pin CPU.

平时使时，我们不应忽视对CPU风扇的保养，比如在气温较低的情况下，风扇的润滑油容易失败，导致运行噪音大，甚至风扇坏掉，这时我们就应该将风扇拆下清理并加油。

Facing flywheel rear end, and insert the assembly pin when the timing arrowhead on flywheel rear end is aligned to speed sensor assembly hole on flywheel case; fasten the flywheel bolt and take off the assembly pin finally.

面对飞轮后端，当飞轮后端面上的正时箭头对准飞轮壳上的转速传感器安装孔时，然后插上装配销，上紧飞轮螺栓，最后拔下装配销。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。