查询词典 pillar plate

Valve seat plate and the sealing surface for the oblique cone structure, in the oblique conical surface of valve plate welding temperature, corrosion resistant alloy material; fixed loop in the regulation of the spring between the plate and the plate with the adjustment bolt assembly structure.

阀板与阀座的密封面为斜圆锥结构，在阀板斜圆锥表面堆焊耐温、耐蚀合金材料；固定在调节环压板之间的弹簧与压板上调节螺栓装配一起的结构。

Furthermore the performances of heat transfers including corrugate plate, tube and fin-tube were compared under the same conditions. The results show that when the air frontal velocity is between 2.45 and 4.1m/s, the overall heat-transfer coefficient of plate heat exchanger ranges from 100 to 160 W/m^2/ equal to one sixth of that of fin- tube cooler based on tube outside area, which is about 70% higher than that of tube cooler. The volumetric heat transfer capacity of plate cooler is 1.5 times as that of fin-tube cooler and 15 times as that of tube cooler. The heat transfer capacity of per unit power of plate cooler is 5.5 times as that of tube cooler and similar results for fin-tube cooler.

在相同工况下，比较了波纹板式、光管式和翅片管式空冷器的性能指标，结果表明：迎面风速在2.45~4.1m/s之间，波纹板式空冷器传热系数达到100~160W/平方公尺/℃；约比光管式提高70%，但只有以管束外表面为基准的翅片管式传热系数的六分之一；板式空冷器单位体积换热量约是翅片管式空冷器的1.5倍，是光管式的15倍；板式空冷器单位功耗换热量约是光管式空冷器的5.5倍，而翅片管式空冷器与光管式空冷器则相差不大。

The coal feeder consists of mainly a coal bin with coal feeding cylinder inside it, a gate plate over the cylinder, an upper sieve plate below one side of the cylinder, and at least a lower sieve plate with opposite dip to the upper one below the other side of the cylinder and below the upper sieve plate.

该方案主要是由煤斗及煤斗内的给煤滚筒，在给煤滚筒上的闸板和给煤滚筒侧下方的上筛分板，在给煤滚筒的另一侧下方，上筛分板的下方，有至少一个与上筛分板倾斜角度相反的下筛分板。

To discuss the effect of pin carding plate on fiber length distribution in the card slivers,length tests to the card slivers under different carding plate gauge,taker-in speed and doffer speed using pin carding plate and saw-tooth carding plate under the card taker-in by USTER AFIS single fiber tester were done.

为探讨梳针分梳板对生条中纤维长度的影响，用AFIS单纤维测试仪，对在梳棉机刺辊下分别加装梳针分梳板和锯齿分梳板时在不同分梳板隔距、刺辊转速、道夫转速条件下所加工的生条进行长度检测。

Curtain plate stainless steel plate, spray nozzle for the spray nozzle to capture, exhaust fan with explosion-proof fan.3, chamber body assembly plate connection between the use of bolts, installation, removal, fast and convenient.4, configuration, special explosion-proof spray room lighting, interior lighting sufficient light.5 mist treatment with water curtain, shower folding capture plus maze can efficiently remove the paint mist.6, circulation pump with an area of small, simple installation and pipeline pumps.7, Room δ1.5mm steel and steel body is made of.8, dust chamber body is made of EPS board, has entered out.9, water curtain spray booth technical parametersNo Item ParametersA flow rate (m3 / h) 90002 Power 43 pump power 34 open wind speed 0.6-0.75 Compressed air consumption (m3/min) 0.36 lamp illumination 400Z-7 nozzle8 Painting Room: Dimensions 2500 × 2400 × 26009 Dust Room: Dimensions 2500 × 1800 × 3400Note: Manual spray system uses 你好gh-quality brand-name products in Taiwan.6, leveling RoomLeveling effect of room to spray paint surface after the paint on the share level, and to a number of solvent evaporation in order to prevent baking too quickly appeared in the film pinhole.1, Room body is made of welded steel and steel plate.2, chamber body wall windows with transparent glass observation and maintenance of the door.3, chamber body with the top emission device, keeping indoor air fresh.4, room spray processing site in vivo, uniform color, elegant appearance.3, the consolidated statementa, baking oven is designed to bridge Road.

没有碰到水帘的漆雾由水帘下部进入喷漆室的后部，由喷嘴喷出的水雾冲洗、迷宫折板过滤及折板上的喷淋系统三次过滤后，废气经风机排至大气中，布局特点如次：一、设置双工位水帘喷漆室。二、槽体采用型钢及Q235钢板制作，板厚4mm。水帘板为不锈钢板，喷淋捕捉喷嘴为雾化喷嘴，抽风机采用防爆型风机。3、室体拼装板之间采用螺栓连接、安装、拆卸、迅速，便捷。四、配置喷漆室专用防爆照明，内部采光充足、明亮。5、漆雾处理采用水帘、喷淋捕捉加迷宫折板，可高效去除漆雾。6、轮回泵采用占地少、安装简略的管道泵。7、室体采用δ1.5mm钢板与型钢制作而成。八、防尘室体采用EPS板制成，设有出进门。9、水帘喷漆室技术参数序号项目参数1 处理风量（m3/h） 90002 功率 43 水泵功率 34 开口风速 0.6-0.75 压缩空气耗量（m3/min） 0.36 照明灯照度 4007 喷嘴 Z型8 喷漆室：外形尺寸 2500×2400×26009 防尘室：外形尺寸 2500×1800×3400注：手动喷漆系统采用台湾优质名牌产品。六、流平室流平室的作用是使喷漆后喷在工件表面上的漆铺平，并使溶剂挥发一些，以防止烘烤过快而在漆膜上浮现针孔。一、室体采用型钢与钢板焊制而成。

Valve plate and valve seat sealing surface for the oblique cone structure, oblique cone surface in the valve plate welding temperature, corrosion resistant alloy materials; fixed in the regulation of the spring between the ring plate and the plate with the adjusting screw assembly structure.

阀板与阀座的密封面为斜圆锥结构，在阀板斜圆锥表面堆焊耐温、耐蚀合金材料；固定在调节环压板之间的弹簧与压板上调节螺栓装配一起的结构。

Valve plate and valve seat sealing surface for the oblique cone structure, oblique cone surface in the valve plate welding temperature, corrosion resistant alloy materials; fixed in the regulation of the spring between the ring plate and the Butterfly Valves plate with the adjusting screw assembly structure.

水力控制阀阀板与阀座的密封面为斜圆锥结构，在阀板斜圆锥表面堆焊耐温、耐蚀合金材料；固定在调节环压板之间的弹簧与压板上调节螺栓装配一起的结构。

Valve plate and valve seat sealing surface for the oblique cone structure, oblique cone surface in the valve plate welding temperature, corrosion resistant Water Control valves alloy materials; fixed in the regulation of the spring between the ring plate and the plate with the adjusting screw assembly structure.

阀板与阀座的密封面为斜圆锥结构，在阀板斜圆锥表面堆焊耐温、耐蚀合金材料；固定在调节环压板之间的弹簧与低温阀门压板上调节螺栓装配一起的结构。

The electrostatically actuated membrane is used in this kind of tunable capacitor. Both of two parallel-plate of the new tunable capacitor can deflect when subject to parallel-plate electrostatic actuation, this is different with the novel parallel-plate tunable capacitor which is only one of the two parallel-plate can deflect.

这种可调电容器采用静电驱动金属膜的原理工作，与一般的只有单极板可动的可调电容器相比，这种结构的不同之处在于采用一些复杂的制作工艺，制作出电容两块极板均可动的可调电容器。

An original polarizing plate having a plurality of layers is fixed on a first principal surface of an ultrahigh molecular weight polyethylene porous sheet by drawing from the opposite side. The original polarizing plate is cut by a blade moving across the thickness of the original polarizing plate by using the porous sheet as a cutting mat to obtain a polarizing plate having a plurality of layers.

将由多层构成的偏光原板从超高分子量聚乙烯树脂多孔质薄板(1)的一主面吸引、固定在该主面的相反侧的主面上，以多孔质薄板(1)作为切割垫，将偏光原板(2)用在其厚度方向移动的刀刃(4)切断，得到由多层构成的偏光板(3)。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48